Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 32 for “"Load Line"”.
-
Optimal capacitor placement for line-loss reduction and importance of voltage reduction during reactive power compensation and its effects on load, line loss, and generation
… capacitor locations and sizes to minimize line loss on a radial distribution system was developed in this work. Both the power loss index (PLI)-based approach and the loss sensitivity coefficient-based approach were comparatively studied to determine the optimal capacitor location. The …
-
Fracture of cementitious composites
… most frequently is in the measurement of the load-line deflection. Until recently, the way this measurement has been made, using a dial gauge or LVDT (Linear Variable Differential Transformer) to measure the deformation between the center of the specimen and the frame, includes the crushing of …
-
Design, Analysis and Implementation of Multiphase Synchronous Buck DC-DC Converter for Transportable Processor
… sense methods are proposed, the tolerance of load line base on the component's tolerance in the converter is analyzed, the equation to estimate the output capacitance is derived, and the small signal analysis of multiphase synchronous buck converter with the droop current loop is derived. A …
-
The constant fracture angle model for cementitious materials
… been investigated for the past two decades using linear elastic and nonlinear fracture mechanics concepts. The models proposed so far remain questionable largely due to specimen dependency of the proposed fracture parameters. In this study, a new approach for modeling the fracture characteristics …
-
Residual Stress, Shakedown and Failure in Carburized Hoisting Load Chain
<p>Electric chain hoists lift their loads by passing carburized chain over a rotating load sprocket. A link passing over the load sprocket experiences relative motion with respect to adjacent links, giving rise to link/link interface frictional tractions that do not occur in those links not passing …
-
New Technologies to Improve the Transient Response of Buck Converters
… to increase, it has become time to replace the linearly-controlled conventional Buck converter. Digital circuits, such as microprocessors, are requiring higher dynamic currents, at lower voltages, than ever before. Traditionally, such Buck converters have been controlled by linear voltage-mode …
-
Electrical characteristics of breakdown phenomena
… experiments utilize a 50Q coaxial transmission line system with an axial discharge and a load line to simulate a matched terminating impedance. DC breakdown, and in part pulsed breakdown, are characterized for argon gas, subcooled liquid nitrogen, biodegradable oil and vacuum. The discharge …
-
Performance of diagonal conducting wall MHD generator in multiple mode operation
… Conducting Wall MHD Generator with multiple loading was investigated; both feedback and direct coupling were considered. Using experimental data a comparison of the power output and Hall voltage for these loading techniques was made.</p><p>From analysis it was found that feedback coupling …
-
High power microwave interference effects on analog and digital circuits in IC's
… and bit-flip errors were identified using a load-line characteristic analysis. We developed a parameter extraction method that can predict the dynamic operation of inverters under microwave interference from DC load-line characteristics. Using the method, the effects of microwave interference …
-
On modeling and control of MHD-steam system
… of a control strategy for responding to changing load demands.</p> <p>Assuming the system variables are perturbed a small amount from their steady-state values when such a load demand is received, a linear incremental model of the plant is constructed. The model makes use of a fuel dependent …
-
Experimental investigations of subnanosecond gas breakdown
… breakdown can be achieved in a transmission line or waveguide, most incoming power could be reflected, protecting any circuitry on the other side. This experiment consisted of a study of breakdown in gas using a needle tip to plane geometry with high voltage pulsers, ranging from 1 to 7.5 kV, …
-
Digital Control of Voltage Regulators for Fast Transient Response in Computer Applications
… computer applications. Voltage mode control with load line positioning and phase current balancing technique is first introduced to maximize the transient response of the VR and to balance the phase current for multiphase VR under high frequency dynamic load conditions. The VR and its control …
-
A comparison between the plastic work energy criterion and the J-Integral fracture criterion in fatigue crack propagation
… value of AJ was determined from areas within the load-displacement hysteresis loops using a double cantilever clip-on extensometer. The value of U was obtained from areas within hysteresis loops using small foil strain gages that were attached at various positions with respect to the advancing …
-
On the Application of Unstructured Data and Machine Learning to Power Systems Forecasting
… data such as behind-the-fence generation (BTF), load, line losses, and interzonal congestion are essential for maintaining grid reliability and optimizing operational and planning decisions. However, accurately forecasting these data can be challenging owing to their inherently non-linear and …
-
A reduced-order crawler crane model with active control to attenuate the transient vibrations
The nonlinear differential equations describing the motion of a crawler crane in a plane are formulated by applying Lagrange's equation to the system kinetic energy, potential energy and virtual work. The transient response of the crane system due to the vertical drop of the suspended load is …
-
The design of a 4-Megawatt induction heating power supply
… tank capacitor as a function of frequency and load Q. Third, in the course of the design, the operation of the oscillator was simulated by a digital computer program. This program solves the differential equations of the circuit and produces a time history of the interesting voltages and …
-
Enabling low cost test and tuning of difficult-to-measure device specifications: application to DC-DC converters and high speed devices
… under test (DUT) damage during conventional load/line regulation measurement on power converter, a "safe" alternate test structure is developed where the power converter (boost/buck converter) is placed in a different mode of operation during alternative test (light switching load) as opposed …
-
Modeling And Digital Control Of High Frequency Dc-dc Power Converters
… with other systems, voltage dynamic programming,load line specifications, phase current balance, protection, power status monitoring and system diagnosis are going into today's power supply systems. Digital controllers, compared withanalog controllers, are in a favorable position to provide basic …
-
The influence of high performance matrices on fracture behavior of concrete
… behavior of concrete is investigated. While the linear elastic fracture mechanics (LEFM) concept is not appropriate for concrete, a nonlinear fracture model based on the load vs. load-line deflection and the load vs. crack-mouthopening displacement (CMOD) responses of the three-point bend tests …
-
Fabrication of silicon-based nano-structures and their scaling effects on mechanical and electrical properties
… the mechanical properties of silicon nanolines (SiNLs) with feature size scaled into the tens of nanometer level. And the second is to study the electron transport in nickel silicide formed on the SiNLs. For the first study, a fabrication process was developed to form nanoscale Si lines …
Page 1 of 2