Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 8 of 8 for “"Markstein Number"”.
-
Measurement of Markstein numbers and laminar flame speeds in computationally simulated premixed cylindrically expanding laminar flames
… properties, such as laminar flame speed and Markstein number, play crucial roles in characterizing premixed flames. These parameters influence flame stability, speed, and response to perturbations. While these properties can be determined experimentally, such measurements are often costly and …
-
Acceleration of Non-Equidiffusive Flames in Channels: Computational Simulations and Analytical Studies
… devoted to equidiffusive flames, where the Lewis number, defined as the thermal to mass diffusivity ratio, is unity, Le = 1. However, in reality thermal and mass diffusion are typically not balanced, especially in rich and lean mixtures. Hence, the micro-scale, diffusional-thermal effects may …
-
Fundamental studies of premixed combustion
… of flame stretch, quantified by the associated Markstein lengths. Methane-air mixtures at initial temperatures between 300 and 400 K, and pressures between 0.1 and 1.0 MPa have been studied at equivalence ratios of 0.8, 1.0 and 1.2. Values of unstretched laminar burning velocity are correlated …
-
DEVELOPMENT OF A TURBULENT BURNING VELOCITY MODEL BASED ON FLAME STRETCH CONCEPT FOR SPARK IGNITION ENGINES
… mixtures (ϕ = 0.84). This was due to the lower Markstein number, the representation of flame sensitivity to flame stretch, for the rich fuel-air mixture compared to the stoichiometric or lean mixtures. The ratio of the thermal to mass diffusivity appeared to be the dominant factor in the …
-
Experimental and Numerical Investigation of Spherical Flame Propagation for Hydrogen-Methane-Air Mixtures
… velocities, ��, are derived and presented. The Markstein length, Lb, Markstein number, Mab, and strain rate Markstein number, Masr, have also been derived. The results show that the maximum ul occurs on the rich side of stoichiometric conditions. For example, for 30% and 50% H2, it occurs at ϕ = …
-
Turbulent flame development in a high-pressure combustion vessel
… free laminar burning velocity and also the Markstein number, a measure of the influence of stretch on the burning velocity. The peak laminar burning velocity was found to be in the range 1>ø>1.2 depending on the fuel. At 0.5 MPa a number of the flames were observed to become cellular, in …
-
DEVELOPMENT OF A TURBULENT FLAME SPEED MODEL BASED ON FLAME STRETCH CONCEPT FOR SPARK IGNITION ENGINES
This is an MSc report to develop a turbulent combustion model and couple it with engine simulation software to improve its predictive capability. For liquid or gaseous fuels one of the most important quantities is the velocity at which the flame front propagates normal to itself and relative to the …
-
Propagation and Morphology of Premixed Flames in Obstructed Channels under Atmospheric and Supercritical Conditions
… properties based on fuel mixture Lewis numbers (the ratio of the thermal to mass diffusivities) and operating conditions. In semi-open channels, the flame accelerates while propagating from the closed end to the open end. Much stronger flame acceleration occurs when a channel is packed …