Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 18 of 18 for “"Microelectromechanical systems--Design and construction"”.

  1. Testing for delay defects utilizing test data compression techniques

    … new types of defects are being discovered and new fault models are being created for those defects. Transition delay and path delay fault models are two such models that have been created, but they still fall short in that they are unable to obtain a high test coverage of smaller delay …

    texas Repository record for Testing for delay defects utilizing test data compression techniques (opens in a new tab)

  2. MEMS micro-bridge actuator for potential application in optical switching

    … consists of a bridge supported by 'legs' and springs at its four corners. The springs and the bridge are made of a tri-layer structure comprising of 2.5µm thick low-stress PECVD oxide, 1µm thick high-stress PECVD oxide and 2µm thick heavily phosphorus doped silicon. The legs, on the other …

    unsw Repository record for MEMS micro-bridge actuator for potential application in optical switching (opens in a new tab)

  3. Piezoelectrically-Transduced Silicon Micromechanical Resonators

    This thesis reports on the design and fabrication of micro-electro-mechanical (MEM) resonators on silicon that are piezoelectrically-transduced for operation in the very high frequency (VHF) range. These devices have a block-type or beam-type design, and are designed to resonate in their in-plane …

    gatech Repository record for Piezoelectrically-Transduced Silicon Micromechanical Resonators (opens in a new tab)

  4. Advanced sensing technologies : from vanadium dioxide MEMS resonators to polypropylene ferroelectret nanogenerators

    "This thesis presents fundamental and applied research studies designed to enable smart material-based advanced sensing technologies including the use of vanadium dioxide (VO2) thin films in resonant frequency tuning methods, and the self-powering/energy harvesting capabilities of polypropylene …

    msu Repository record for Advanced sensing technologies : from vanadium dioxide MEMS resonators to polypropylene ferroelectret nanogenerators (opens in a new tab)

  5. Characterization of the mechanical properties of freestanding platinum thin films

    … are used as Ohmic contacts. But the elastic and plastic properties of these thin films (thickness < 1μm) are significantly different from those of the bulk material. At these scales the volume fraction of material defects such as: grain boundaries, dislocations and interstitials become quite …

    unm Repository record for Characterization of the mechanical properties of freestanding platinum thin films (opens in a new tab)

  6. Monitoring and Control of Semiconductor Manufacturing Using Acoustic Techniques

    … processes require numerous steps, cost and yield are critical concerns. In-situ monitoring is therefore vital for process control. However, this goal is currently restricted by the shortage of available sensors capable of performing in this manner. The goal of this research therefore, …

    gatech Repository record for Monitoring and Control of Semiconductor Manufacturing Using Acoustic Techniques (opens in a new tab)

  7. Micromachined Components for RF Systems

    … all have in common the use of epoxy patterning and subsequent metallization. Techniques and structures such as embedded conductors, epoxy-core conductors, a reverse-side exposure technique, a multi-exposure scheme, and inclined patterning are presented. The epoxy-core conductor technique makes …

    gatech Repository record for Micromachined Components for RF Systems (opens in a new tab)

  8. Development of Monolithic SiGe and Packaged RF MEMS High-Linearity Five-bit High-Low Pass Phase Shifters for SoC X-band T/R Modules

    … has been performed, increasing the understanding of error sources arising from bit layout issues and fabrication tolerances. This included a detailed analysis of error sources in monolithic microwave phase shifters due to device size limitations, inductor parasitics, loading effects, and …

    gatech Repository record for Development of Monolithic SiGe and Packaged RF MEMS High-Linearity Five-bit High-Low Pass Phase Shifters for SoC X-band T/R Modules (opens in a new tab)

  9. Design and Optimization of Temperature-Stable MEMS Resonators for Timing Applications Based on Thin-Film Lithium Tantalate

    … While quartz-based oscillators meet accuracy demands, they cannot be easily miniaturized for higher frequencies. Silicon-based MEMS resonators offer a promising alternative due to their small size, and low power consumption, though they suffer from significant temperature drift. This research …

    ucf Repository record for Design and Optimization of Temperature-Stable MEMS Resonators for Timing Applications Based on Thin-Film Lithium Tantalate (opens in a new tab)

  10. Fabrication of High-Frequency Piezoelectric Resonant Micro-Accelerometers based on Capacitive Loading Effect

    … is presented. This novel sensor was designed to operate in 10's of MHz frequency range utilizing an out-of-plane capacitive mechanism for acceleration sensing. The sensor is comprised of a 2-port RF MEMS piezoelectric resonator, operating at 27MHz, and a Capacitive Mass-spring …

    ucf Repository record for Fabrication of High-Frequency Piezoelectric Resonant Micro-Accelerometers based on Capacitive Loading Effect (opens in a new tab)

  11. Monolithic Thin-film Lithium Niobate Scanning Micromirror: Design and Simulation

    … is utilized as both as the structural material and the actuating piezoelectric medium. In this novel monolithic design, the conventional composite torsional hinges are avoided. The finite element simulations performed and reported in here indicate that the proposed design offers a superior …

    ucf Repository record for Monolithic Thin-film Lithium Niobate Scanning Micromirror: Design and Simulation (opens in a new tab)

  12. An Electromagnetic Actuated Microvalve Fabricated on a Single Wafer

    … components of the miniaturization of the fluidic systems to control of fluid flow in a variety of applications as diverse as chemical analysis systems, micro-fuel cells, and integrated fluidic channel arrangements for electronic cooling. Using microvalves, these systems offer important advantages: …

    gatech Repository record for An Electromagnetic Actuated Microvalve Fabricated on a Single Wafer (opens in a new tab)

  13. A Mixed-Signal Low-Noise Sigma-Delta Interface IC for Integrated Sub-Micro-Gravity Capacitive SOI Accelerometers

    This dissertation presents the design and development of a mixed-signal low noise second-order integrated circuit (IC) for the open-loop and closed-loop operation of integrated capacitive micro- and nano-gravity accelerometers. The micromechanical accelerometers are fabricated in thick (less than …

    gatech Repository record for A Mixed-Signal Low-Noise Sigma-Delta Interface IC for Integrated Sub-Micro-Gravity Capacitive SOI Accelerometers (opens in a new tab)

  14. Design Considerations and Thermodynamic Feasibility Study of a Meso-scale Refrigerator

    … in miniaturization of chemical, environmental and energy systems. This foreseeable trend towards miniaturization in chemical, environmental and mechanical systems is expected to revolutionize the ways the human life is being perceived today. The high volume and mass reproducibility is seen as …

    ucf Repository record for Design Considerations and Thermodynamic Feasibility Study of a Meso-scale Refrigerator (opens in a new tab)

  15. Characterization of the MEMS directional sound sensor fabricated using the SOIMUMPs process

    … the directional sound sensing. The MEMS sensor design considered in this thesis is fabricated using a process by which the sensor has two resonant vibrational modes: rocking and bending. The sensor is simulated using finite element analysis and tested by actuating the sensor using a sound …

    nps Repository record for Characterization of the MEMS directional sound sensor fabricated using the SOIMUMPs process (opens in a new tab)

  16. Development of a compliant micro gripper : a thesis submitted in partial fulfillment for the degree of Masters of Engineering in the School of Engineering and Advanced Technology, Massey University

    Manipulating micro objects simply and effectively has been a widely discussed and challenging task in recent literature for many reasons. Limitations in complex micro fabrication techniques mean creating extremely small tools at the micro scale is very difficult. Adhesion forces also dominate at …

    massey Repository record for Development of a compliant micro gripper : a thesis submitted in partial fulfillment for the degree of Masters of Engineering in the School of Engineering and Advanced Technology, Massey University (opens in a new tab)