Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 9 of 9 for “"Molded Fiber"”.
-
Upcycling of industrial hemp byproducts into a sustainable molded fiber packaging system
… and characterization of fully bio-based molded fiber composites using industrial hemp (Cannabis sativa L.) hurds, starch, and cellulose nanofibrils (CNF) for sustainable single-use packaging applications. Hemp hurds, a low-value byproduct of the hemp industry, are usually discarded, which …
-
Transportation, Handling, and Microbial Comparison of Molded Fiber and Expanded Polystyrene Apply Trays
… apple trays are expanded polystyrene (EPS) and molded fiber. An industrial switch from Molded Fiber to EPS trays provoked an interest in the difference between the two materials. Testing was required to conclude which tray material, if any, provided better protection for the apples. In order to …
-
Comparing the environmental impacts of PET, PP, coated paperboard, and molded fiber frozen meal trays : a review
… with a switch from traditional plastics to fiber packaging materials. Life cycle assessment (LCA) provides a highly defensible method for comparing the full life cycle impact of alternatives, but consumer perception of packaging sustainability largely focuses on material attributes …
-
Extending the performance of net shape molded fiber reinforced polymer composite valves for use in internal combustion engines
Fiber Reinforced Composite (FRC) materials offer the possibility of reduced mass and increased structural performance over conventional metals. When used in reciprocating components of internal combustion engines, this may enable increased power and mechanical efficiency. Previously published work …
-
Development and evaluation of 3-D optical sectioning for the investigation of fiber orientation distributions in injection-molded fiber reinforced thermoplastics
Thesis (M.S.)--Michigan State University. Department of Mechanical Engineering, 1994
-
Profitability study for a paper recycling facility in Iceland
… their business where the paper is recycled into molded fibers. To answer this question a financial assessment was conducted followed by sensitivity analysis to assess the risk. Four operation cases were analyzed to study two recycling machines, and to compare the use of methane gas and geothermal …
-
Natural ventilation in buildings: the development of a component
… 1/3 scale ventilator cowls were produced in molded fiber reinforced plastic and altered in various ways in an attempt to optimize performance. Also tested were a variety of simple forms and three experimental types that had previously been tested at a larger scale. The models were tested in a …
-
Development of bio-based coatings incorporating lignin nanoparticles for packaging and textile applications
… renewable alternatives. Among these, cellulose fibers are one of the most abundant renewable materials, as they are both recyclable and biodegradable. However, to effectively compete with plastics, cellulose fibers must exhibit enhanced functionality. Therefore, developing renewable coatings …
-
Dimensional Stability and Properties of Thermoplastics Reinforced with Particulate and Fiber Fillers
… thermoplastics reinforced with particulate and fiber fillers. The first part of this study was concerned with ascertaining the main causes of warpage observed for injection-molded thermoplastics reinforced with high aspect ratio fibers. Typically, warpage in injection-molded fiber reinforced …