Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 36 for “"Multi-crystalline"”.
-
Defect characterisation in multi-crystalline silicon
… and impurity compositions at extended defects in multicrystalline silicon (mc-Si) samples. The results provide, for the first time, information regarding the chemical species present at defects whose electrical activity has previously been measured.</p> <p>A new APT specimen fabrication process …
-
High efficiency p-type laser-doped multi-crystalline silicon solar cells
… relatively low efficiency being 16.5% for mono-crystalline and 15.5% for multi-crystalline silicon solar cells [Mai06]. Much higher efficiency solar cells have been achieved in the laboratory. Unfortunately, the fabrication processes of the high efficiency laboratory solar cells are relatively …
-
Detection of Residual Stress in Multi-Crystalline Silicon Wafers Using Swept-Sine Frequency Response Data
This thesis presents audible vibratory mode data obtained by mechanically exciting acoustic modes in mc-Si wafers grown by EFG technique with various levels and distributions of residual stress. Stress maps obtained using scanning infrared polariscopy are presented, illustrating the variation of …
-
Development and characterization of a low thermal budget process for multi-crystalline silicon solar cells
… goal driving the development of solar cells. Multi-crystalline silicon has attracted considerable attention because of its high stability against light soaking. In case of solar grade multi-crystalline silicon the rigorous control of metal impurities is desirable for solar cell fabrication. It …
-
Effects of Dark and Illuminated Anneals on Multi-crystalline Silicon Wafers and on Mono-crystalline Silicon Wafers Passivate with Carrier-Selective Contacts
… induced degradation (LeTID) in p-type multi-crystalline silicon (mc-Si) has been a main research focus of the photovoltaic community. Nevertheless, the cause of this degradation is still unknown. Interestingly, LeTID can also be obtained by dark anneal (DA) and has also been identified …
-
Fundamental investigations of surface and subsurface damage, and wear in diamond wire sawing of silicon
… the high cost of solar cells, which use mono- or multi-crystalline silicon wafers as substrates. The wafers are cut from silicon ingots using the wire sawing process, which is an expensive step in the manufacturing process. To reduce the cost of solar cells, low-cost, thin silicon wafers of …
-
Investigation of Light Induced Degradation in Promising Photovoltaic Grade Si and Development of Porous Silicon Anti-Reflection Coatings for Silicon Solar Cells
Cast multi-crystalline silicon substrates are used in more than 50% of the photovoltaic modules produced today. The random grain orientations of multi-crystalline silicon wafers inhibit the formation of an effective surface texturing using conventional techniques. The other main substrate used is …
-
INDUSTRIAL DEPOSITION OF SILICON NITRIDE ON MC-SI FOR SOLAR CELL PRODUCTION EMPLOYING MICROWAVE PECVD
… Due to the cost and throughput concerns, multi-crystalline silicon solar cell are gaining its dominant position over crystalline solar cells represented by a share of more than 55% and this share is still increasing. However, the major issue existing for multi-crystalline solar cells is …
-
GaInN/GaN Schottky Barrier Solar Cells
… solar cells. Nonetheless, amorphous and multi-crystalline forms of GaInN have been theorized to exhibit a defect-free bandgap, enabling GaInN alloys at any indium composition to be realized. But the range of possible p-type doping has not yet been determined and no device quality material …
-
Study of stress measurement using polariscope
… of the in-plane residual stresses in thin multi crystalline silicon wafer, and try to meet the need of photovoltaic industry to in situ measure residual stress for large cast wafers.
-
Measurement and analysis of wire sawing induced residual stress in photovoltaic silicon wafers
… heating process to produce a Si ingot from polycrystalline Silicon, which is then cut into bricks and subsequently sawn into wafers using a wire saw. These processes create residual stresses both from the thermal gradient induced by solidification and from either the rolling-indenting or …
-
Investigations into b-o defect formation-dissociation in cz-silicon and their effect on solar cell performance
… of silicon solar cells is taken by single crystalline Czochralski (CZ) grown wafers. The efficiency of solar cells fabricated on boron-doped Czochralski silicon degrades due to the formation of metastable defects when excess electrons are created by illumination or minority carrier …
-
Potencialo poveikio vandeninio tirpalo sluoksnio prie polimerinio paviršiaus savybėms tyrimas kvarco rezonatoriaus admitanso metodu /
… obtained for quartz sensor covered with PVB and multi-crystalline wax Cosmoloid H80 shows that the nature of the coating does not considerably affect the dependence of ρη on the potential. Dependence of the product of density and viscosity on the potential in 0,1M NaF solution at PVB-coated Au …
-
Thermo-mechanical simulation of Si processing for photovoltaic applications
… via wire sawing of directional solidified multi-crystalline silicon (mc-Si) ingots. During these two processes, defects such as dislocations arise in the material which reduce the final electrical efficiency of the solar cells. Furthermore, processing conditions during these processes can …
-
Resonance Ultrasonic Vibrations (RUV) for Crack Detection in Silicon Wafers for Solar Cells
… been successful in detecting cracks in single crystalline and multi-crystalline silicon wafers. Further development of the RUV system would solidify its place in manufacturing plants for non-destructive crack detection in PV cells.The contributing work of the author toward the further …
-
Life Cycle Assessment of Silicon Photovoltaic Panels: Comparative Analysis of Technologies and Circular End-of-Life Strategies
… photovoltaic (PV) panel technologies: single-crystalline silicon, multi-crystalline silicon, monofacial passivated emitter rear contact (PERC), bifacial PERC, tunnel oxide passivated contact (TOPCon), and heterojunction (HJT). Using SimaPro software, the study applies the ReCiPe Midpoint (H) …
-
Life Cycle Assessment of Silicon Photovoltaic Panels: Comparative Analysis of Technologies and Circular End-of-Life Strategies
… photovoltaic (PV) panel technologies: single-crystalline silicon, multi-crystalline silicon, monofacial passivated emitter rear contact (PERC), bifacial PERC, tunnel oxide passivated contact (TOPCon), and heterojunction (HJT). Using SimaPro software, the study applies the ReCiPe Midpoint (H) …
-
Life Cycle Assessment of Silicon Photovoltaic Panels: Comparative Analysis of Technologies and Circular End-of-Life Strategies
… photovoltaic (PV) panel technologies: single-crystalline silicon, multi-crystalline silicon, monofacial passivated emitter rear contact (PERC), bifacial PERC, tunnel oxide passivated contact (TOPCon), and heterojunction (HJT). Using SimaPro software, the study applies the ReCiPe Midpoint (H) …
-
Life Cycle Assessment of Silicon Photovoltaic Panels: Comparative Analysis of Technologies and Circular End-of-Life Strategies
… photovoltaic (PV) panel technologies: single-crystalline silicon, multi-crystalline silicon, monofacial passivated emitter rear contact (PERC), bifacial PERC, tunnel oxide passivated contact (TOPCon), and heterojunction (HJT). Using SimaPro software, the study applies the ReCiPe Midpoint (H) …
Page 1 of 2