Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 15 of 15 for “"Nyquist stability"”.
-
Chatter stability of turning and milling with process damping
The prediction of chatter instability in machining steel and thermal-resistant alloys at low cutting speeds has been difficult due to unknown process damping contributed by the contact mechanism between tool flank and wavy surface finish. This thesis presents modeling and measurement of process …
-
Impedance-Based Stability Analysis and Controller Design of Three-Phase Inverter-Based Ac Systems
… ac systems may suffer from small-signal instability issues due to the dynamic interactions among inverters and passive components in the systems. It is crucial for system integrators to analyze the system stability and design the inverter controller parameters during system planning and …
-
Design and simulation of a torque sensing governor for an internal combustion engine
… for the real system using each governor and the Nyquist stability criteria applied. The Nyquist criteria showed the system to be stable when either governor was used. The Nyquist plots showed that the torque sensor reduced phase lag more than the derivative component of conventional control.
-
AC/DC power system small-signal impedance measurement for stability analysis
… a dc power system is small-signal stable if the Nyquist contour of product of the source impedance and load admittance satisfied the Nyquist stability criterion. Methods of extracting impedance in dc systems have been well established. However, for ac systems, the traditional current-injection …
-
Voltage Stability and Control in Autonomous Electric Power Systems with Variable Frequency
… various types of power electronic loads. The stability of these systems is a challenge due to the inherent nonlinearity of the circuits involved. Traditionally, the stability analysis in this type of power systems has been approached by means of small-signal methodology derived from the …
-
Stability Analysis of Three-Phase AC Power Systems Based on Measured D-Q Frame Impedances
Small-signal stability is of great concern for distributed power systems with a large number of regulated power converters. These converters are constant-power loads (CPLs) exhibit a negative incremental input resistance within the output voltage regulation bandwidth. In the case of dc systems, …
-
Analysis and control of nonlinear vibration in inertial actuators
… is strongly nonlinear and invalidates the linear Nyquist stability criterion, which significantly complicates the assessment of closed-loop stability. As an example, stroke saturation may occur when using proof-mass actuators in active car suspensions, due to large impulsive forces from the …
-
Stabilization and control of unstable time delay systems
… controller is not a trivial solution to achieve stability of the closed loop. PID and lead-lag controller are the two most popular type of the controllers used in industrial control (often in single loop configuration). In this thesis, Nyquist stability criterion combined with some algebraic …
-
An impedance frequency response approach for analyzing interactions in ac-dc systems
… frequency range are identified and stability determined. This approach applies the Generalized Nyquist stability Criterion (GNC) assuming that the frequency dependent impedance responses are available. The frequency responses of the subsystems are obtained using two different …
-
Control Methods for Improving Tracking Accuracy and Disturbance Rejection in Ball Screw Feed Drives
… action over the tracking error is included. The stability analysis and tuning procedure for this controller is presented together with experimental results that prove the effectiveness of this method in high-speed tracking and cutting applications. The second design uses the pole placement …
-
Modeling, Control and Analysis of Inverter-Based Generators in the Power Grids
… inertia IBGs brings new problems on the system stability. The main objectives of this dissertation are to: 1- carry out large-signal analysis to identify the stability issues and small-signal analysis to assess the stability of the power systems, and 2- provide a standard measuring procedure to …
-
Architecting aircraft power distribution systems via redundancy allocation
… is constructed to study the performance and stability of the candidate architectures. The combination of the optimization process and dynamic modeling facilitates the selection of a power system architecture that meets the system requirements and objectives.
-
Frequency scan based stability analysis of power electronic systems
… a PES at steady state. This thesis presents the stability analysis of the interactions between a PES and its ac grid using frequency scanning techniques. Frequency scanning techniques in different domains are used to extract the model of PESs and the ac grids independently. These results are then …
-
MEMS-based phase-locked-loop clock conditioner
… frequency could not be selected since the stability of the configuration deteriorates as the filter bandwidth is reduced. This fact suggests that a full-spectrum clock conditioning is not possible using traditional PLL architectures, and an alternative scheme is necessary to attenuate the …