Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 6 of 6 for “"PRYING FORCES"”.

  1. Improvement of the mechanical model for mode 1 T-stub plastic strength

    … thickness to bolts diameter and the position of prying forces. From this study, it was observed that membrane effects are, indeed, negligible at yielding. Neverthe less, it was shown that the position of the plastic hinges is poorly evaluated. The same applies to the stress distribution under the …

    liege Repository record for Improvement of the mechanical model for mode 1 T-stub plastic strength (opens in a new tab) Download PDF for Improvement of the mechanical model for mode 1 T-stub plastic strength (opens in a new tab)

  2. Behavior of Diagonal Knee Moment End-Plate Connections

    … to predict bolt rupture including and excluding prying forces. An experimental investigation was conducted to verify the design solutions. Five knee area specimens and one plate girder specimen were tested in this study. The analytical and experimental results are analyzed and compared. For the …

    vt Repository record for Behavior of Diagonal Knee Moment End-Plate Connections (opens in a new tab)

  3. Prototype Development and Experimental Verification of a Cast Modular Connector for Seismic-Resistant Steel Frames

    … a base end-region that virtually eliminates prying forces on bolts.The dissertation presents three journal papers. The first paper describes the portion of the analytical research focused on establishing the optimum geometry for the energy dissipating arm elements. Key parameters were …

    arizona-thes Repository record for Prototype Development and Experimental Verification of a Cast Modular Connector for Seismic-Resistant Steel Frames (opens in a new tab)

  4. Design of moment end-plate connections for seismic loading

    … were developed from yield-line theory with prying forces included in the bolt tension forces. Stiffened end-plates, four-bolt wide connections and shimmed end-plate connections were valiations of the four-bolt connection tested. A325 and A490 bolts with internal strain gauges were employed …

    vt Repository record for Design of moment end-plate connections for seismic loading (opens in a new tab)

  5. Development and Seismic Evaluation of Cast-in-Place Emulating ABC Pocket Connections and SMA Reinforced Two-Way Column Hinges

    … to reduce joints stresses and address prying forces. The secondary objective of the study was achieved by implementing two-way hinges reinforced with CAM bars at the base of both columns. CAM bars were attached to #4 (Ø13 mm) steel bars at both ends using headed bar couplers and were …

    unr Repository record for Development and Seismic Evaluation of Cast-in-Place Emulating ABC Pocket Connections and SMA Reinforced Two-Way Column Hinges (opens in a new tab)

  6. ΕΦΑΡΜΟΓΕΣ ΤΗΣ ΘΕΩΡΙΑΣ ΤΩΝ ΜΟΝΟΠΛΕΥΡΩΝ ΠΡΟΒΛΗΜΑΤΩΝ ΣΤΟΝ ΥΠΟΛΟΓΙΣΜΟ ΤΩΝ ΣΥΝΔΕΣΕΩΝΤΩΝ ΜΕΤΑΛΛΙΚΩΝ ΚΑΤΑΣΚΕΥΩΝ

    THIS PAPER DEALS WITH UNILATERAL PHENOMENA OCCURING IN PROBLEM OF ANALYSIS OF CONTACT ZONES IN PRISMATIC MEMBERS CONNECTING STEEL PLATES AND IN GENERAL ENCOMPOSSES SIMILAR SITUATIONS ENCOUNTERED IN OTHER FORMS OF BOLTED CONNECTIONS OF STEEL MEMBERS . THIS PROBLEM IS THOROUGHLY STUDIED FOR A VARIETY …

    greece Repository record for ΕΦΑΡΜΟΓΕΣ ΤΗΣ ΘΕΩΡΙΑΣ ΤΩΝ ΜΟΝΟΠΛΕΥΡΩΝ ΠΡΟΒΛΗΜΑΤΩΝ ΣΤΟΝ ΥΠΟΛΟΓΙΣΜΟ ΤΩΝ ΣΥΝΔΕΣΕΩΝΤΩΝ ΜΕΤΑΛΛΙΚΩΝ ΚΑΤΑΣΚΕΥΩΝ (opens in a new tab)