Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 20 for “"Particle sensor"”.
-
Limited assessment of a selected particulate matter sensor technology in emission measurement applications on diesel vehicles
The study assessed the ability of a novel particle sensor to provide adequate evaluation of real-time emissions from modem diesel engines and estimate the effectiveness of emission control devices. Emission data were obtained from vehicles in real-world field conditions under various test cycles. …
-
Application of Quartz Crystal Microbalance to Measure the Rheology of Complex Colloidal Suspensions
… QCM is immersed into a medium, a shift in the sensor oscillation frequency (ΔF) is observed, where the magnitude of the shift is proportional to the bulk properties of the medium and the nature of its contact to the resonator surface. In most cases an increased dampening due to a loss in …
-
Particle Sensing in Gas Turbine Inlets Using Optical Measurements and Machine Learning
… studies have investigated the effects of particle ingestion on the component level, an accurate in-situ measurement technique is needed for a systematic understanding of the effects and real-time engine health monitoring. Optical measurement techniques are attractive for this application …
-
Particle Matter Measurements for Inspection/Maintenance Programs
Particle emissions from Heavy Duty Diesel Vehicles (HDDVs) are currently measured by opacity or dynamometer gravimetric analysis. The Electronic Tailpipe Particle Sensor (ETaPS) is an inexpensive measurement device purported to give real time response to particle mass and was proposed as a possible …
-
Advanced sampling and detection methods for exhaust particle emissions measurements
… detection methods for the measurement of exhaust particles, and with these to investigate the technologies and operation conditions that affect exhaust particle emissions of modern vehicles. The sampling method evaluated is the "Catalytic Stripper", which is employed for the removal of volatile …
-
Advanced sampling and detecion methods for exhaust particle emissions measurements
… detection methods for the measurement of exhaust particles, and with these to investigate the technologies and operation conditions that affect exhaust particle emissions of modern vehicles. The sampling method evaluated is the "Catalytic Stripper", which is employed for the removal of volatile …
-
Using Sensors to Investigate the Effectiveness of Portable Air Filtration for Reducing Particle Exposures: Implications for Community Congregate Settings
… calibrating the performance of low-cost optical particle sensors, 2) Evaluate the real-world effectiveness of portable HEPA air cleaners (HEPA PACs) in reducing indoor particle levels in community congregate settings, while assessing usage patterns and factors influencing their efficacy, and 3) …
-
SPIN VALVE SENSOR ARRAYS FOR MAGNETIC BIO-LABEL DETECTION
A spin-valve based biosensor array designed for the detection of magnetic bio-labels has been developed. A Co/Cu/Co/NiFe spin-valve design with a bottom Co layer pinned by a Co/Ru/Co synthetic antiferromagnetic tri-layer was employed. The Ta/Ru/Co/Ru/Co/Cu/Co/Ni81Fe19/Ta multilayer stack was …
-
Exploitation of plasmonic nanoparticles for optical enhancements in composite materials
… the optical properties of plasmonic metal nanoparticles and their application in composite materials. Plasmonic metal nanoparticles can be used to concentrate and manipulate light. Due to the oscillations in the conduction electrons these particles exhibit extremely intense electric fields near …
-
Particle Image Velocimetry of Suspension Plasma Spray in the Vicinity of a Substrate
… the velocity and diameter of in-flight particles near the substrate, which depend on the plasma and injection conditions, have a strong influence on the coating columnar structure. In this work, the velocity of in-flight particles in the vicinity of the substrate and free jet was …
-
Fine Particle (PM2.5) Composition of Indoor and Outdoor Air Samples Collected in Xuanwei County, China
… a 24-hr outdoor measurement. Continuous fine particle sampling was also conducted indoors using a low-cost particle sensor. Samples were analyzed for total PM2.5 mass concentration and selected components (levoglucosan, 1-nitropyrene, and benzo[a] pyrene) indicative of source and potential …
-
Microcontroller Based Particulate Matter Monitors Utilising the Alphasense OPC-N3
Inexpensive particulate matter sensors provide a valuable means to inform citizens, poli- cymakers and researchers about the ambient air quality. Their low cost makes them suitable for use in emerging and lower-income countries. To realise these affordable sensors, some programming and development …
-
Analysis of particulate matter and volatile organic compound emissions from 3D printing activity
… PM emissions were measured using an optical particle sensor (OPS) and low-cost air quality monitors. Size ranges of interest were from 0.3 μm to 10 μm. VOC emissions were sampled using solid-phase microextraction (SPME) in a closed chamber experimental setup and analysed using gas …
-
High-throughput real-time sensing in optomechanical systems with opto-mechano-fluidics
Embargo set by: Seth Robbins for item 121157 Lift date: 2024-01-12T22:51:46Z Reason: Author requested closed access (OA after 2yrs) in Vireo ETD system
-
E-Cigarette Aerosol’s Effect on the Force Degradation of Elastomeric Chain: An in Vitro Study
… aerosol trap, exposure chamber, flow meter, and particle sensor was used to expose the elastomeric chains to the JUUL e-cigarette aerosol. For Ultra-Chain, there was a control group of ambient air and a test group of exposure to e-cigarette aerosol only. The Ultra-Chain was compared to the RMO …
-
The Effects of E-Cigarette Aerosol on the Force Degradation of Elastomeric Chain: An in Vitro Pilot Study
… aerosol trap, exposure chamber, flow meter, and particle sensor was used to expose the elastomeric chains. After the aerosol exposure, the elastomeric chain was placed back into the simulated oral environment. At every time interval, twenty samples were removed and placed on an Instron machine …
-
Novel measurement techniques for monitoring particulate matter: development, application and evaluation of a low-cost IoT sensor network
… Adapting an off-the-shelf low-cost optical particle sensor, an IoT enabled particulate matter sampler was developed, built, and tested in a range of environments. The sampler was designed with field deployment practicality in mind. Completely self-contained, AltasensePM was designed to use …
-
PM2.5 Particle Sensing and Fit Factor Test of a Respirator with SAW-Based Sensor
PM2.5 particle sensing has been done using surface acoustic wave based sensor for two different frequencies. Due to mass loading and elasticity loading on the sensor's surface, the center frequency of the sensor shifts. The particle concentration can be tracked based on that frequency shift. The …
-
Modelling and fabrication of magnetic field sensors based on nanostructured material
… interest towards the use of magnetic micro/nanoparticles in biomedicine for the labelling of biological species, in order to open new ways in drug delivery, biological analysis and cancer treatment via hyperthermia. These magnetic nanostructures are physically and chemically stable and permit …