Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 15 of 15 for “"Pier caps"”.

  1. External strengthening of reinforced concrete pier caps

    The shear capacity of reinforced concrete pier caps in existing bridge support systems can be a factor which limits the capacity of an existing bridge. In their usual configuration, pier caps behave as deep beams and have the ability to carry load through tied arch action after the formation of …

    gatech Repository record for External strengthening of reinforced concrete pier caps (opens in a new tab)

  2. Experimental testing, analysis, and strengthening of reinforced concrete pier caps by exterior post tensioning

    Condition assessment of existing concrete bridge pier caps using the general shear provisions of the AASHTO LRFD Bridge Design Specification has caused the Georgia Department of Transportation (GDOT) to post a large number of bridges in the State of Georgia. Posting of bridges disrupts the free …

    gatech Repository record for Experimental testing, analysis, and strengthening of reinforced concrete pier caps by exterior post tensioning (opens in a new tab)

  3. Experimental and analytical investigation of reinforced concrete bridge pier caps with an externally bonded stainless steel system

    … the behavior of reinforced concrete bridge pier caps strengthened with externally bonded reinforcement. In the experimental study, nine full-scale reinforced concrete bridge pier caps were built, externally strengthened with stainless steel reinforcement, and ten tested to failure. Load, …

    gatech Repository record for Experimental and analytical investigation of reinforced concrete bridge pier caps with an externally bonded stainless steel system (opens in a new tab)

  4. Time-dependent behavior of pretensioned stainless steel bars used for structural rehabilitation and retrofitting

    … for strengthening reinforced concrete bridge pier caps in shear. Stress relaxation experiments were conducted on UNS S32101 stainless steel bars subjected to various initial stresses and temperatures within the low homologous temperature (LHT) regime. Data from these experiments were used to …

    gatech Repository record for Time-dependent behavior of pretensioned stainless steel bars used for structural rehabilitation and retrofitting (opens in a new tab)

  5. Evaluation of strut-and-tie modeling for bridge pier applications

    … are not valid. In most instances, hammerhead piers can be defined as deep reinforced concrete members and therefore, should be designed using the strut-and-tie modeling approach. However, little has been done to develop a consistent approach to the design of hammerhead pier caps employing the …

    wvu Repository record for Evaluation of strut-and-tie modeling for bridge pier applications (opens in a new tab)

  6. Η δεύτερη χρήση κιονοκράνων στην Ελλάδα από την ύστερη αρχαιότητα έως τον πρώιμο μεσαίωνα

    … reused column capitals or column bases, imposts, pier caps and abaci functioning as capitals) in the territories of modern Greece from c. 300 to 1000. Within a critical catalogue, 100 selected monuments are discussed. The discussions focus on the building history of the monuments, the …

    greece Repository record for Η δεύτερη χρήση κιονοκράνων στην Ελλάδα από την ύστερη αρχαιότητα έως τον πρώιμο μεσαίωνα (opens in a new tab)

  7. Stress relaxation of stainless steel rods for bridge pier cap shear strengthening

    … rod system for strengthening reinforced concrete pier caps in shear. An overview of the stress relaxation phenomenon and its modeling is presented. Previous work on stress relaxation of stainless steel is reviewed and used to select an appropriate stress relaxation model to analyze the stress …

    gatech Repository record for Stress relaxation of stainless steel rods for bridge pier cap shear strengthening (opens in a new tab)

  8. Experimental and analytical study of integral-abutment bridges

    … displacements of the superstructure over the pier caps, strains in selected steel HP-shaped piles supporting the abutments, strains in several PC girders, bridge member temperatures, and end fixity of selected piles and girders in the abutments. The experimental temperature and displacement …

    iastate Repository record for Experimental and analytical study of integral-abutment bridges (opens in a new tab)

  9. Finite Element Analysis-Based Evaluation of Rebar Dowels as Restraints of Prestressed Concrete Beams

    … in Texas involves embedding dowel bars within pier caps or abutments. These dowels are extended through elastomeric bearings into longitudinal slots at the bottom of exterior girders. These dowels are likely intended to provide directional restraint and prevent transverse bearing displacement. …

    tamu Repository record for Finite Element Analysis-Based Evaluation of Rebar Dowels as Restraints of Prestressed Concrete Beams (opens in a new tab) Embargoed until 2028-05-01

  10. Finite Element Analysis-Based Evaluation of Rebar Dowels as Restraints of Prestressed Concrete Beams

    … in Texas involves embedding dowel bars within pier caps or abutments. These dowels are extended through elastomeric bearings into longitudinal slots at the bottom of exterior girders. These dowels are likely intended to provide directional restraint and prevent transverse bearing displacement. …

    tamu Repository record for Finite Element Analysis-Based Evaluation of Rebar Dowels as Restraints of Prestressed Concrete Beams (opens in a new tab) Embargoed until 2028-05-01

  11. Finite Element Analysis-Based Evaluation of Rebar Dowels as Restraints of Prestressed Concrete Beams

    … in Texas involves embedding dowel bars within pier caps or abutments. These dowels are extended through elastomeric bearings into longitudinal slots at the bottom of exterior girders. These dowels are likely intended to provide directional restraint and prevent transverse bearing displacement. …

    tamu Repository record for Finite Element Analysis-Based Evaluation of Rebar Dowels as Restraints of Prestressed Concrete Beams (opens in a new tab) Embargoed until 2028-05-01

  12. Preliminary Seismic Analysis and Design of Reinforced Concrete Bridge Columns for Curved Bridge Experiments

    … on two single-column bents with hammer-head pier caps, and have a subtended angle of 104°. The purpose of the shake table testing is to study the seismic system behavior of the bridge as well as additional bridge components including; conventional columns, isolation, ductile-cross frames, …

    unr Repository record for Preliminary Seismic Analysis and Design of Reinforced Concrete Bridge Columns for Curved Bridge Experiments (opens in a new tab)

  13. Seismic Performance of Bridge Column-Pile-Shaft Pin Connections for Application in Accelerated Bridge Construction

    … rigid joints between precast columns and precast pier caps. This research was comprised of experimental and analytical studies.The experimental portion of the study was conducted on a shake table at the Earthquake Engineering Laboratory at the University of Nevada, Reno including two 1/3.75 scale, …

    unr Repository record for Seismic Performance of Bridge Column-Pile-Shaft Pin Connections for Application in Accelerated Bridge Construction (opens in a new tab)

  14. Evaluation of Early In-Place Concrete Performance Based on Test Results of Cores and Cylinders

    … and were designed to replicate large beams or pier caps in bridge infrastructure. Cores were extracted vertically from the top and horizontally from the mid-height of the beams to evaluate the two alternatives of extracting cores in similar bridge elements. The girder webs were constructed to …

    waterloo Repository record for Evaluation of Early In-Place Concrete Performance Based on Test Results of Cores and Cylinders (opens in a new tab)