Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 2415 for “"Pipes"”.
-
Thermal stresses in pipes
… about thermal stresses in externally heated pipes that are subjected to different flow types: laminar flow, turbulent flow, and pulsating flow. The effect o f flow Reynolds number on thermal stresses in the pipe is studied. To investigate the influence o f fluid and solid properties on the …
-
Holographic nondestructive testing of pipes.
Pipes with internal and external radial and axial flaws were tested using double-exposure interferometric holography. A hydrostatic pressure was applied internally between exposures to stress each specimen. Photographs of the resulting holograms are presented. Surface displacements were measured …
-
The performance of jacked pipes
… into the performance of reinforced concrete pipes, assessment of pipe joints and the use of joint packing materials. The research has addressed specific problems which the tunnelling fraternity have raised. Model pipes have been constructed at scales of 1:6 and 1:10.5 using reinforced …
-
Uneven turns oscillating heat pipes
An experimental investigation on oscillating heat pipes with uneven turns was conducted in order to determine the effect of short turns on the heat transport capability. The shorter turns do not go through both the evaporating and condensing sections; the short turns were placed only in the …
-
Quasi-smooth flow in pipes
This thesis contains the results of a flow analysis for a circular pipe with a quasi-smooth roughness pattern. Seven ring-and-groove test patterns were investigated, all with h/j (h = depression depth, j = depression width) ratios equal to or greater than one. Resistance measurements for the flow …
-
Heat Pipes with Arbitrary Boundary Conditions
<p>Heat pipes passively transfer heat in numerous applications. Traditionally one side of the heat pipe is coupled to a heat source (evaporator) while the opposite side is coupled to a heat sink (condenser). This configuration has working fluid stagnation points at each end of the heat pipe. Other …
-
Butt fusion welding of polyethylene pipes
… used in the joining of polyethylene (PE) pipes by the water and gas industries. This welding process although deceptively simple, is rather poorly understood, with much of the initial developments being of a rather empirical nature. The Water Research centre (WRc) have funded the present …
-
Leak detection in plastic water pipes
… functions of leak signals in plastic pipes. The model explains some of the acoustic characteristics of the measured leak signal in plastic water pipes. Moreover, it is used to study the effects of the cut-off frequencies of high and low-pass digital filters used to remove noise, and …
-
Cementitious Liners in Reinforced Concrete Pipes
… the performance of damaged reinforced concrete pipes with a focus on developing design approaches to examine the required thickness of cementitious liners to restore strength to resist earth and vehicle loads. Design seeks to prevent the development of additional cracking within the damaged …
-
Experimental investigation of oscillating heat pipes
[ACCESS RESTRICTED TO THE UNIVERSITY OF MISSOURI-COLUMBIA AT AUTHOR'S REQUEST.] With ever increasing technological advances in electronics, modern computer components continue to produce higher power densities that present a challenge to thermal management. A radial flat-plate oscillating heat pipe …
-
Dynamics of fluid-conveying Timoshenko pipes
Structures conveying mass lose stability once the mass exceeds a certain critical velocity. The type of instability observed depends on the nature of the supports that the structure has. If the structure (beam or pipe) is cantilevered (thereby deeming it a nonconservative system), …
-
The structural performance of flexible pipes
<p>High density polyethylene pipes have been used for over a decade but little information is available on the in-service behavior of these pipes. An investigation to evaluate the field performance of HDPE pipes was undertaken using visual information obtained from a remote video camera. The …
-
Risk-based Rehabilitation of Wastewater Pipes
… of failure (POF) for individual wastewater pipes are Multi-Criteria Decision Analysis (MCDA) based on expert knowledge or statistical regression models, Bayesian Networks (BNs) and Artificial Neural Networks (ANNs). Further, the consequences of failure (COF) for individual pipes have been …
-
Lamb wave propagation in multilayered pipes
… linear theory of elasticity, for multilayered pipes; individual layers are made of isotropic elastic solids. A theoretical study of the Lamb wave propagation in multilayered pipes for both axisymmetric and nonaxisymmetric loading is presented. The stress and displacement variations inside the …
Page 1 of 121