Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 19 of 19 for “"Plume height"”.
-
Wildfires in earth system: Driver, transport and feedback
… study the transport of the wildfire emissions, a plume height dataset has been developed. The resulting dataset from 2002 to 2010 captured well the observed MISR plume height distribution. By adding the plume height dataset in the climate model, the plume-rise enhanced AOD downstream of the …
-
Investigation of Jet Dynamics in Cross-Flow: Quantifying Volcanic Plume Behavior
… aviation. Current models rely on inputs such as plume height, duration, eruption rate, and meteorological wind fields. Eruption rate is estimated from plume height using relations that depend on the rate of air entrainment into the plume, which is not well quantified. A wind tunnel experiment has …
-
Air assessment of open burning at Radford Army Ammunition Plant
… Army Ammunition Plant. The project considers the plume and burn characteristics, the removal of nitroglycerin from the waste, the emission of metals into the air, and the modeling of pollutant emissions from open burning. The plumes generated from open burning fall well below the mixing heights. …
-
Implementation and validation of a meteorological dispersion model applied on volcanic gas emission for studies of environmental impact
… the results of quantifiable parameters such as plume height and width is large. When comparing with the mobile measurements the model gives very good agreement in about two thirds of the cases. Finally, a simulation of ground dose over one month (December 2009) was also performed for Nyiragongo.
-
Historical Explosive Eruptions of Hekla and Askja Volcanoes, Iceland: Eruption Dynamics and Source Parameters
… provides eruption source parameters (volume, plume height, and mass eruption rate) for five of the largest historical Hekla eruptions, as well as new TGSD data for four of the Hekla eruptions and two phases of the 1875 Askja eruption. TGSDs were determined using a consistent methodology, …
-
Characterizing Explosive Volcanic Eruptions Using Tephra Fall Deposit Data
… distribution to estimate the erupted volume and plume height of explosive eruptions. These terms are known as eruption source parameters. These parameters are used to classify the intensity and magnitude of the eruption on a scale such as the Volcanic Explosivity Index (VEI). Accurate estimation …
-
Variability in Pyroconvection During the Bootleg Fire in 2021
… are used to characterize the wildfire's plume depth and the presence of pyroCu/Cb. These data are contextualized with High Resolution Rapid Refresh (HRRR) analysis fields to examine the thermodynamic structure of the atmosphere, and with GOES-17 Fire-Radiative Power (FRP) to characterize …
-
An Investigation of the Plume Theories of Briggs and Hanna
… the prediction of mechanical draft cooling tower plumes. However, due to a serious lack of data up to this date, little has been done to verify the predictive capability of these mathematical models. This thesis attempts to rectify this situation somewhat by undertaking a thorough investigation of …
-
The Statistical Design of Assessments of Ash Hazard Impacts from Explosive Volcanic Eruptions
… ash are ejected into the atmosphere from a plume that can intersect airspace at all flight levels. Ash is transported long distances by wind advection and dispersed by diffusion processes before settling, presenting significant hazards—including to aviation and critical infrastructure. …
-
The robustness of volcanic hazard forecasts under uncertainty : a thesis presented in partial fulfilment of the requirements for the degree of Doctor of Philosophy in Earth Science at Massey University (Manawatū campus), Aotearoa New Zealand
… such as median grain size, diffusion, and plume shape consistently have the largest influence on forecast variability, while others, such as plume height, demonstrate limited individual influence but become influential through higher-order interactions with other input parameters. …
-
Assessing roof vulnerability to collapse from tephra fall loading, with relevance to Ascension Island
… that three basaltic events, each with a 6–10 km plume height could produce proximal tephra loads sufficient to cause roof collapse if roofs were not cleared between eruptive phases. Finally, I combined my results to develop a GIS tool that assesses susceptibility to roof collapse at a building …
-
QUANTIFYING SO₂ EMISSIONS FROM EXPLOSIVE EVENTS OF THE 2021 LA SOUFRIÈRE ERUPTION USING DSCOVR/EPIC
… EPIC imagery captures short-lived SO₂ plumes, complementing spatially detailed but temporally limited observations from the TROPOspheric Monitoring Instrument (TROPOMI) on the polar-orbiting Sentinel-5P satellite. SO₂ plumes observed by EPIC are further analyzed using the Hybrid …
-
CMAQ Modeling and Analysis of Trace Gases and Biomass Burning
… after midnight. Finally, an offline physical plumerise module was applied to the Fire Inventory from NCAR (FINN) to simulate an intense fire episode in August 2012 in the western U.S. It was found that the base simulation with default FINN emissions underestimated the CO concentrations in the …
-
APPLICATIONS OF THE OZONE MONITORING INSTRUMENT IN OBSERVING VOLCANIC SULFUR DIOXIDE PLUMES AND SULFATE DEPOSITION
… sulfate, and the remote sensing of the SO2 layer height, important for aviation safety and chemical modeling. In the first study, I used column SO2 data from the Ozone Monitoring Instrument (OMI), and sulfate wet deposition data from the National Atmospheric Deposition Program to investigate the …
-
Retrieval of sub-pixel-based fire intensity and its application for characterizing smoke injection heights and fire weather in North America
… potential relationships to meteorology and smoke plume injection heights, are currently limited by the pixel resolution. This dissertation describes the development of a new, sub-pixel-based FRP calculation (FRPf) for fire pixels detected by the MODerate Resolution Imaging Spectroradiometer …
-
Developing Aerosol Representation in Atmospheric Modeling
… events by implementing satellite-constrained plume heights in the high-performance configuration of GEOS-Chem (GCHP). A Gaussian vertical profile is used for aerosol mass distribution, and the resulting satellite-derived surface-level PM2.5 concentrations are compared against ground-based …
-
Untangling the Nature and Timescales of Magmatic Processes Driving Eruptions at Quiescent Volcanoes: Examples from Momotombo, Nicaragua, and Cumbre Vieja, Canary Islands
… to time series of surface signals (tremor, plume height, gas emissions) to decipher the relationship between melt chemistry and eruption dynamics.
-
Investigating the enhancement of air pollutant predictions and understanding air quality disparities across racial, ethnic, and economic lines at US public schools
… information. Observations of smoke plume height (PH) may provide constraints on the vertical distribution of smoke and its impact on surface concentrations. Low-cost sensor networks have been rapidly expanding to provide higher density air pollution monitoring. Finally, both …
-
Re-establishing the beast : an investigation into the spatiotemporal evolution of the Y5 phase of the Taupō 232 ± 10 CE eruption, New Zealand : a thesis submitted in partial fulfilment of a Philosophiae Doctor degree in Earth Science, Volcanic Risk Solutions, School of Agriculture and Environment, Massey University, New Zealand
… explosive eruptions that generate buoyant plumes that reach >20 km into the atmosphere. They often produce devastating pyroclastic density currents (PDC) along with widespread tephra fall out, with significant hazards to communities around the volcanoes. Current computational modelling of …