Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 20 of 22 for “"Power Back-Off"”.

  1. Broadband Power Amplifier Design with High Power, High Efficiency and Large Back-off Range

    … different from any existing LMBAs and Doherty power amplifiers (DPAs) was presented, which is named as Pseudo-Doherty LMBA (PD-LMBA). Based on a special combination of control amplifier (carrier) and balanced amplifier (peaking) together with proper phase and amplitude controls, an optimal …

    ucf Repository record for Broadband Power Amplifier Design with High Power, High Efficiency and Large Back-off Range (opens in a new tab)

  2. CMOS RF power amplifiers for mobile wireless communications

    … However, the implementation of CMOS RF power amplifiers remains a formidable challenge. The objective of this research is to demonstrate the feasibility of CMOS RF power amplifiers by compensating for the RF performance disadvantages of CMOS technology. This dissertation proposes a …

    gatech Repository record for CMOS RF power amplifiers for mobile wireless communications (opens in a new tab)

  3. A Class-J Power Amplifier with Varactor Based Dynamic Load Modulation

    … energy efficiency and broadband operation in power amplifiers have been driving parameter in the research of wireless transmitters. This thesis presents the theory for a broadband design of a dynamic load modulated class-J power amplifier. Calculations show that a drain efficiency higher than …

    chalmers Repository record for A Class-J Power Amplifier with Varactor Based Dynamic Load Modulation (opens in a new tab)

  4. CMOS linear RF power amplifier with fully integrated power combining transformer

    … a fully integrated Radio-frequency (RF) linear Power Amplifier( PA) in complementary metal-oxide silicon (CMOS) technology. In this work we analyse the challenges in CMOS PA design as well as the state-of-the-art solutions. One such challenge presented by this technology is the low supply …

    brazil-ufrgs Repository record for CMOS linear RF power amplifier with fully integrated power combining transformer (opens in a new tab)

  5. High efficiency broadband power amplifiers using SiGe HBT BiCMOS technology

    … design challenges of high efficiency broadband power amplifiers (PAs) using silicon germanium (SiGe) heterojunction bipolar transistor (HBT) and establish design methodologies to address these challenges. Broadband amplification with high efficiency is becoming crucial for emerging wireless …

    gatech Repository record for High efficiency broadband power amplifiers using SiGe HBT BiCMOS technology (opens in a new tab)

  6. Interference Alignment with Distributed Antenna Systems

    … users in the cellular downlink. Because the power resources of each antenna in distributed antenna systems are geographically separated, practical implementations of distributed antenna systems require consideration of per-antenna power constraints on the transmit antennas. For this reason, …

    texas Repository record for Interference Alignment with Distributed Antenna Systems (opens in a new tab)

  7. Load Modulation of Harmonically Tuned RF Power Amplifiers

    … in both amplitude and phase, presenting peak power envelope swings exceeding ten times their average power level. In wireless communication systems, it is a significant challenge to transmit high peak-to-average-power-ratios signals whilst maintaining a high degree of energy efficiency. …

    bristol Repository record for Load Modulation of Harmonically Tuned RF Power Amplifiers (opens in a new tab) Download PDF for Load Modulation of Harmonically Tuned RF Power Amplifiers (opens in a new tab)

  8. DESIGN OF CLASS F-BASED DOHERTY POWER AMPLIFIER FOR S-BAND APPLICATIONS

    … front end systems with high output power and high linearity to meet minimum transmission requirements. Advanced modulation techniques, such as orthogonal frequency-division multiplexing (OFDM) require a large power amplifier (PA) dynamic range due to the high peak-to-average power …

    calpoly Repository record for DESIGN OF CLASS F-BASED DOHERTY POWER AMPLIFIER FOR S-BAND APPLICATIONS (opens in a new tab)

  9. Advanced Delta-Sigma Transmitter Architectures for High Performance Wireless Applications

    … also enable the use of high efficiency switching power amplifiers (PAs). This thesis was dedicated to enhancing the performance of DSM based transmitters. The first part of the thesis will focus on the design and evaluation of a novel high-pass (HP) DSM- based digital-IF transmitter architecture …

    calgary Repository record for Advanced Delta-Sigma Transmitter Architectures for High Performance Wireless Applications (opens in a new tab)

  10. Design of Multi-band/Wide-band High Efficiency Power Amplifiers

    … of the RF front-end in the transmitter, the power amplifier (PA) is used to convert the DC supply power into RF power. As the PA consumes most of the power in the transmitter, minimizing power dissipation of the PA would have a significant effect on the efficiency of the whole system. During …

    calgary Repository record for Design of Multi-band/Wide-band High Efficiency Power Amplifiers (opens in a new tab)

  11. Co-design of radio frequency architectures and communication algorithms for energy-efficient wireless systems

    … and broad coverage, all while maintaining strict power efficiency, robustness against interference and errors, and the ability to support multiple frequency bands and communication standards. This places significant stress on Radio Frequency (RF) front-end architectures, which are often limited by …

    bu Repository record for Co-design of radio frequency architectures and communication algorithms for energy-efficient wireless systems (opens in a new tab)

  12. Transmitter designs for sub-6 ghz and millimeter wave bands

    … However, the OFDM signal has a major drawback of high peak-to-average-ratio, which results in degraded power efficiency of the transmitter. On the other hand, to support higher data rate, mm-wave bands can support bandwidths up to 2 GHz without aggregating bands together. However, at …

    msu Repository record for Transmitter designs for sub-6 ghz and millimeter wave bands (opens in a new tab)

  13. Hybrid (Current/Voltage Mode) Digital Power Amplifier and Bidirectional Digital Front-End Circuits in Silicon

    … efficiency in the PBO state as well as maximum power is becoming more critical. From a receiver perspective, massive RF applications lead to a crowed spectrum, making receivers susceptible to mutual interference. Hence, along with cost and power consumption, interference robustness is becoming a …

    gatech Repository record for Hybrid (Current/Voltage Mode) Digital Power Amplifier and Bidirectional Digital Front-End Circuits in Silicon (opens in a new tab)

  14. Extended Bandwidth Doherty Power Amplifier for Carrier Aggregated Signals

    In the conventional classes of power amplifiers the efficiency drops at power back-off, whereas in order to maximize the spectral efficiency and data rate, wireless communication standards employ signals with high peak to average power ratio. This results in low average efficiency for power …

    waterloo Repository record for Extended Bandwidth Doherty Power Amplifier for Carrier Aggregated Signals (opens in a new tab)

  15. Analysis and Design of Envelope Tracking Power Amplifier

    … (PAPR) have been emerged. Hence, conventional power amplifiers must be operated in back-off to meet the stringent linearity requirements, resulting in a substantial efficiency degradation. Various power amplifier topologies (i.e. switch-mode, Doherty, out-phasing and envelope tracking) are the …

    poli-torino Repository record for Analysis and Design of Envelope Tracking Power Amplifier (opens in a new tab)

  16. Area and Power Reduction Techniques for Millimeter-Wave Phased-Array Transceiver Front-ends

    … MN, mixer-first RX with translational feedback, Cartesian phase shifters as a baseband beamformer, poly-phase filters, and LO generation in TSMC 28nm CMOS, occupying a total area of 0.53mm2. This RX achieves a NF of 7dB, gain of 26dB, input P1-dB of -20dBm with an 8-GHz 3-dB BW and a S11 …

    washington Repository record for Area and Power Reduction Techniques for Millimeter-Wave Phased-Array Transceiver Front-ends (opens in a new tab)

  17. Mixed-Signal Multimode Radio Software/Hardware Development Platform

    Radio frequency power amplifiers (PAs) are the most challenging part of the design of radio systems since they dictate the overall system's performance in terms of power efficiency and distortion generation. The performance is further challenged by modern modulation schemes which are characterized …

    waterloo Repository record for Mixed-Signal Multimode Radio Software/Hardware Development Platform (opens in a new tab)

  18. Efficiency and linearity enhancement techniques for switched-capacitor power amplifiers and transmitters

    … and wider bandwidth at increased output power (POUT) are required to meet the high demand for faster communication speeds and increased data traffic. Meanwhile, mobile and wearable applications require a smaller form factor and low-cost solutions. Low power consumption is also critical …

    msu

  19. Blocker Tolerant Radio Architectures

    … So the current research is focused on the power, area and performance optimization of various circuit building blocks of a radio for current and incoming standards. Firstly, a linearization technique for low noise amplifiers (LNAs) called, Robust Derivative Superposition (RDS) method is …

    tamu Repository record for Blocker Tolerant Radio Architectures (opens in a new tab)

  20. A Millimeter-Wave Three-Way Doherty Power Amplifier for 5G NR OFDM

    … reduce the impedance transformation ratio at back-off, and directly absorb the device parasitic capacitance. Its design procedure and trade-offs are discussed in detail. A 38-GHz PA prototype is implemented in the GlobalFoundries 45-nm CMOS SOI process, achieving 13.7% / 11.0% PAE at the …

    rice Repository record for A Millimeter-Wave Three-Way Doherty Power Amplifier for 5G NR OFDM (opens in a new tab)

Page 1 of 2