Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 20 of 99 for “"Power Take-off"”.

  1. A controllable power take-off for magnetohydrodynamic generators

    <p>Electrical power must be extracted from a magneto-hydrodynamic (MHD) generator by a power take-off (PTO) system that consolidates the current from the MHD channel's electrodes into a single load current.</p> <p>In the conventional PTO system constructed from diodes and resistors, desired …

    ut-knoxville Repository record for A controllable power take-off for magnetohydrodynamic generators (opens in a new tab)

  2. Optimised power take-off configuration for wave energy converters

    … converts the motion energy to electricity: the Power Take-Off system (PTO). On the one hand, efforts have been made to maximize the energy yield by optimizing the PTO; and on the other hand, the effect of the installed power on the annual energy yield has been investigated. Because maybe bigger …

    ghent Repository record for Optimised power take-off configuration for wave energy converters (opens in a new tab)

  3. The design and construction of a power take-off dynamometer

    Thesis (M.S.)--Michigan State College of Agriculture and Applied Science, 1952

    msu Repository record for The design and construction of a power take-off dynamometer (opens in a new tab)

  4. Optimal Electric Power Take-Off Strategy for Surface Riding Wave Energy Converters

    … the excitation forces from the ocean waves. The power capture from the linear generator is controlled by the power take-off (PTO) strategy. This study investigates the use of traditional PTO strategies such as passive, reactive PTO for the SR-WEC. Novel binary and binary-reactive PTOs are …

    tamu Repository record for Optimal Electric Power Take-Off Strategy for Surface Riding Wave Energy Converters (opens in a new tab)

  5. Power take-off and control for contra-rotating pump-turbines in hydropower storage

    … is expected to be driven by wind and solar power plants. However, these technologies are non-dispatchable and intermittent, and do not provide the natural inertial response that synchronous generators do. As these technologies further replace the traditional high-inertia power sources, …

    ghent Repository record for Power take-off and control for contra-rotating pump-turbines in hydropower storage (opens in a new tab)

  6. ELECTRICAL POWER TAKE-OFF SYSTEM DESIGN AND PERFORMANCE ASSESSMENT FOR POINT ABSORBER WAVE ENERGY CONVERTER

    … state of the art controls and the study of the power take-off (PTO) power loss model are demanded. This dissertation starts with the basic dynamics of the wave energy converter (WEC) buoy and electrical PTO, introduces essential mechanics of the WEC wave-to-wire model composing. Furthermore, the …

    mtu Repository record for ELECTRICAL POWER TAKE-OFF SYSTEM DESIGN AND PERFORMANCE ASSESSMENT FOR POINT ABSORBER WAVE ENERGY CONVERTER (opens in a new tab)

  7. Design, Analysis and Testing of a Self-reactive Wave Energy Point Absorber with Mechanical Power Take-off

    … beings. The total theoretical potential wave power on the ocean-facing coastlines of the world is around 30,000 TWh, although cannot all be adopted for generating electricity, the amount of the power can be absorbed still can occupy a large portion of the world's total energy consumption. …

    vt Repository record for Design, Analysis and Testing of a Self-reactive Wave Energy Point Absorber with Mechanical Power Take-off (opens in a new tab)

  8. IMPLEMENTATION AND OPTIMIZATION OF MULTI-RESONANCE AND PHASE CONTROL OF THE ELECTRICAL POWER TAKE-OFF ON A WEC ARRAY FOR IMPROVED PERFORMANCE

    … is more energy dense that of solar and wind powers. However, in order to implement full scale wave energy converters there needs to be additional development in wave forecasting, controls systems, power electronics, energy storage systems, grid integration, and the overall efficiency of the …

    mtu Repository record for IMPLEMENTATION AND OPTIMIZATION OF MULTI-RESONANCE AND PHASE CONTROL OF THE ELECTRICAL POWER TAKE-OFF ON A WEC ARRAY FOR IMPROVED PERFORMANCE (opens in a new tab)

  9. Experimental modelling of point absorber wave energy converter arrays with control design based on impedance matching

    … drijvende boei. Door gebruik te maken van een power take-off met generator wordt de golfenergie omgezet in elektriciteit. Door deze power take-off te controleren kan de energieabsorptie gemaximaliseerd worden. Vergelijkbaar met offshore windturbines zullen meerdere golfenergieconvertoren worden …

    ghent Repository record for Experimental modelling of point absorber wave energy converter arrays with control design based on impedance matching (opens in a new tab)

  10. Co-design Investigation and Optimization of an Oscillating-Surge Wave Energy Converter

    … of subsystems such as the geometry, power take-off, and controls is necessary. A codesign optimization in this paper seeks to include effects of all subsystems within one optimization loop in order to reach a fully optimal design for an oscillating-surge wave energy converter. A width …

    vt Repository record for Co-design Investigation and Optimization of an Oscillating-Surge Wave Energy Converter (opens in a new tab)

  11. An experimental and theoretical study of an omnidirectional pendulum energy harvester

    … forcing conditions but with an increase in the power take-off the dynamics of the energy harvester become generally more periodic. The dynamics of the system are highly dependent on the excitation frequency, excitation amplitude, damping ratio, and power take-off torque. In the experimental …

    strathclyde Repository record for An experimental and theoretical study of an omnidirectional pendulum energy harvester (opens in a new tab)

  12. Statistical analysis of safety and health issues

    … different types of safety and health projects: power-take-off entanglements, farm stress, and heart problems and diabetes, in additional the related statistical issues are discussed;In the power-take-off entanglements project, an experimental design was used to study the risk of entanglement in …

    iastate Repository record for Statistical analysis of safety and health issues (opens in a new tab)

  13. Self-Reacting Point Absorber Wave Energy Converters

    … wave energy converter (WEC) designs is undertaken in typical operating conditions. The designs are either currently, or have recently been, under development for commercialization. The experiments consist of a series of 1:25 scale model tests to quantify hydrodynamic parameters, motion …

    uvic Repository record for Self-Reacting Point Absorber Wave Energy Converters (opens in a new tab)

  14. Optimal Control of Wave Energy Converters

    … Displacement Hydraulic system which is the Power Take-off unit of the Wave Energy Converter. The simulation results show that the proposed optimal controllers can maximize the energy absorption when the wave estimation is accurate. The performance of the unconstrained controllers is close to …

    mtu Repository record for Optimal Control of Wave Energy Converters (opens in a new tab)

  15. The design and operation of X-rotor type wind turbines

    … global heating, the rate of deployment for offshore wind energy needs to increase significantly over the coming decades. From an engineering perspective, this can be facilitated by a reduction in the cost of energy, and the avoidance of structural barriers to the installation of offshore …

    strathclyde Repository record for The design and operation of X-rotor type wind turbines (opens in a new tab)

  16. Numerical modelling and control of an oscillating water column wave energy converter

    … the incident waves and the force caused by the power take-off (PTO) interact, control of the power take off (PTO) system can increase the total energy converted. A numerical model was developed to study the interaction of an OWC with the water and other structures around it. ANSYS AQWA is used …

    plymouth Repository record for Numerical modelling and control of an oscillating water column wave energy converter (opens in a new tab)

  17. Design, validation and application of wave-to-wire models for heaving point absorber wave energy converters

    … wave-structure hydrodynamic interaction and power take-off system), known as wave-to-wire models, are crucial in the development of successful wave energy converters. Hence, a comprehensive literature review of the different mathematical approaches suggested for modelling the different …

    maynooth Download PDF for Design, validation and application of wave-to-wire models for heaving point absorber wave energy converters (opens in a new tab)

Page 1 of 5