Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 20 of 22 for “"Power amplifiers Design"”.

  1. Advanced Power Amplifiers Design for Modern Wireless Communication

    … involved with signals with high peak-to-average power ratio (PAPR). Moreover, the development of next generation wireless communication systems requires the power amplifiers to operate over a wide frequency band or multiple frequency bands to support different applications. These wide-band and …

    unt Repository record for Advanced Power Amplifiers Design for Modern Wireless Communication (opens in a new tab)

  2. Temperature dependent RF and optical device characterization and its application to circuit design

    Opened per author's request. See ticket https://libanswers.library.gatech.edu/admin/ticket?qid=18577200

    gatech Repository record for Temperature dependent RF and optical device characterization and its application to circuit design (opens in a new tab)

  3. VHF bipolar transistor power amplifiers: measurement, modeling, and design

    Widely used design techniques for radio frequency power amplifiers yield results which are approximate; the initial design is usually refined by applying trial-and-error procedures in the laboratory. More accurate design techniques are complicated in their application and have not gained acceptance …

    vt Repository record for VHF bipolar transistor power amplifiers: measurement, modeling, and design (opens in a new tab)

  4. A 3.6 GHz Doherty Power Amplifier with a 40 dBm Saturated Output Power using GaN on SiC HEMT Devices

    This manuscript describes the design, development, and implementation of a linear high efficiency power amplifier. The symmetrical Doherty power amplifier utilizes TriQuint's 2nd Generation Gallium Nitride (GaN) on Silicon Carbide (SiC) High Electron Mobility Transistor (HEMT) devices …

    portland-state Repository record for A 3.6 GHz Doherty Power Amplifier with a 40 dBm Saturated Output Power using GaN on SiC HEMT Devices (opens in a new tab)

  5. Nonlinearity Analysis and Predistortion of 4G Wireless Communication Systems

    The nonlinearity of RF power amplifiers (PA) is one of critical concerns for RF designers because it causes spectral regrowth related to in-band and out-of-band spurious emissions control in communication standards. Traditionally, RF power amplifiers must be backed off considerably from the peak of …

    portland-state Repository record for Nonlinearity Analysis and Predistortion of 4G Wireless Communication Systems (opens in a new tab)

  6. Power Spectrum Prediction of Amplified Dual-Band LTE-Advanced Signals

    … the nonlinearity of a radio frequency (RF) power amplifier is an important issue for power amplifier designers. Since the nonlinearity is generated by the properties of physical components, it is hard to avoid it in producing power amplifiers. Power amplifier designers should know about the …

    portland-state Repository record for Power Spectrum Prediction of Amplified Dual-Band LTE-Advanced Signals (opens in a new tab)

  7. A 40 GHz Power Amplifier Using a Low Cost High Volume 0.15 um Optical Lithography pHEMT Process

    … which can perform in the higher frequency design space from a technical perspective. However, a cost effective solution must complement the technical merits for deployment. Thus a new 0.15 um optical lithography pHEMT process was developed at TriQuint Semiconductor to address this market …

    portland-state Repository record for A 40 GHz Power Amplifier Using a Low Cost High Volume 0.15 um Optical Lithography pHEMT Process (opens in a new tab)

  8. Load Modulated Balanced Amplifier (LMBA) with Antenna-VSWR Resilience for Energy- and Spectrum-Efficient Communications

    … substantially increase the peak-to-average-power ratio (PAPR) of transmitted signals. To enable power amplifiers (PAs) to operate efficiently under this conditions, load-modulated balanced amplifiers (LMBAs) have been developed as an effective solution while inherently supporting broadband …

    ucf Repository record for Load Modulated Balanced Amplifier (LMBA) with Antenna-VSWR Resilience for Energy- and Spectrum-Efficient Communications (opens in a new tab)

  9. Broadband Power Amplifier Design with High Power, High Efficiency and Large Back-off Range

    … different from any existing LMBAs and Doherty power amplifiers (DPAs) was presented, which is named as Pseudo-Doherty LMBA (PD-LMBA). Based on a special combination of control amplifier (carrier) and balanced amplifier (peaking) together with proper phase and amplitude controls, an optimal …

    ucf Repository record for Broadband Power Amplifier Design with High Power, High Efficiency and Large Back-off Range (opens in a new tab)

  10. Reconfigurable Load-Modulated Power Amplifier For Energy- and Spectrum-Efficient Wireless Communications

    … systems. These pose major challenges to design the power amplifiers (PAs) to accommodate the system level evolution. As the critical part, the power amplifiers (PAs) dominate the output power, efficiency, linearity and reliability of the radio frequency (RF) transmitter. Consequently, the …

    ucf Repository record for Reconfigurable Load-Modulated Power Amplifier For Energy- and Spectrum-Efficient Wireless Communications (opens in a new tab)

  11. Intrinsically Mode Reconfigurable Load Modulation Balanced Amplifier Leveraging Transistor's Analog-Digital Duality

    … to another has triggered many challenges on the design methodologies of RF designers. As the evolution ensued, the spectrally efficient modulation schemes have resulted in the substantial rise of PAPR, the peak-to-average power ratio. To enable the efficient amplification of the high PAPR …

    ucf Repository record for Intrinsically Mode Reconfigurable Load Modulation Balanced Amplifier Leveraging Transistor's Analog-Digital Duality (opens in a new tab)

  12. High-Efficiency Linear RF Power Amplifiers Development

    … systems require the use of linear RF power amplifier for higher data transmission rates. However, linear RF power amplifiers are inherently inefficient and usually require additional circuits or further system adjustments for better efficiency. This dissertation focuses on the …

    gatech Repository record for High-Efficiency Linear RF Power Amplifiers Development (opens in a new tab)

  13. Power amplifier design with GaAs mesfet

    This thesis reviews the design theory and technique of micro- and millimeter-wave solid state device power amplifiers. The internal device physics and characteristics of MESFET are discussed. An overview of nonlinear microwave circuit parameters is given. A conventional design approach with …

    ucf Repository record for Power amplifier design with GaAs mesfet (opens in a new tab)

  14. Reduced Third Order Intermodulation Distortion Utilizing a Push-Pull Class C VHF Transistorized Amplifier

    … reduced at VHF frequencies with an output power of two watt. The non-linear distortion of the amplifier is modeled using a power series. The resulting expression is used as the basis for choosing the push-pull configuration to reduce the third order intermodulation distortion. The amplifier …

    ucf Repository record for Reduced Third Order Intermodulation Distortion Utilizing a Push-Pull Class C VHF Transistorized Amplifier (opens in a new tab)

  15. A Solid State VHF Single Sideband Transmitter

    … a unique method of generating single sideband power, which is particularly useful in transistorized transmitters operating at VHF frequencies. Radio frequency power id developed by class C amplifiers, rather than conventional class A or B amplifiers. Currently, VHF power transistors are not …

    ucf Repository record for A Solid State VHF Single Sideband Transmitter (opens in a new tab)

Page 1 of 2