Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 44 for “"Pre-amplifier"”.
-
Low Noise Pre-amplifier/Amplifier Chain for High Capacitance Sensors
… is essential for detector systems. A low noise pre-amplifier/amplifier readout circuitry has been designed and fabricated in 0.13um IBM CMOS8RF process technology. The pre-amplifier/ amplifier chain employs correlated double sampling at the input to suppress the kTC noise without any additional …
-
A transistorized relay servo
… power transistors and a simple transistorized pre-amplifier. A permanent magnet, DC motor is used as a test vehicle to illustrate the feasibility of control without an amplidyne or mechanical relay. The "bang-bang" capability of the controller to operate as a near-ideal "relay" is emphasized. …
-
Design of a low-voltage, low-noise dynamic comparator and a 10-bit 8-MS/s time-assisted SAR ADC
… CDAC switching process are reviewed. The work presents proposals of a dynamic comparator topology, a SAR ADC topology with a hybrid dynamic comparator and another SAR ADC design with an original CDAC switching scheme. The proposed low-voltage dynamic comparator for low-power ADC applications …
-
2 um Lasers for Cryogenic-Silicon Gravitational Wave Detectors
… μm band must therefore be developed. The preferred architecture is a master oscillator followed by a chain of power amplifiers, sometimes referred to as a master-oscillator-power-amplifier (MOPA). Additionally, the coherent combination of several high power laser beams may be required. …
-
High Performance Circuits for Power Management and Millimeter Wave Applications
… management and a switchable harmonic mixer with pre-amplifier and poly-phase generator as a core part of a millimeter wave receiver are proposed, implemented and experimentally measured. First, two externally compensated low drop-out voltage regulators (LDOs) with high power supply rejection …
-
Development of a high energy diode-pumped chirped pulse amplification laser system for driving soft x-ray lasers
… room temperature and cryogenically-cooled Yb:YAG amplifier to produce 1.5 Joule pulses at up to 50 Hz repetition rate. Pulse compression results in 1 J pulses of 5 ps duration. A room temperature pre-amplifier maintains bandwidth for short pulse operation and a novel cryogenic cooling technique …
-
Testing and Packaging for MEMS Acoustic Emission Sensors
… cracks in structures and to check leakage in pressurized systems. The location of cracks in a structure or system leakage causes a high-frequency surface vibration while releasing ultrasonic energy. The frequency of this energy is typically between 30 kHz to 1MHz. The AE sensor can detect this …
-
Ytterbium-doped Fiber-seeded Thin-disk Master Oscillator Power Amplifier Laser System
… processing, directed energy and EUV generation. Presented in this dissertation is a high-power 1 μm ytterbium-based hybrid laser system with temporally tailored pulse shaping capability and up to 62 mJ pulses, with the expectation the system can scale to higher pulse energies. This hybrid system …
-
Demonstration of a compact 100 Hz, 0.1 J, diode-pumped picosecond laser
In this work I present an all laser diode pumped chirped pulse amplification laser system that is capable of producing 100 mJ laser pulses at 100 Hz repetition rate with durations of under 5 ps. The primary focus of this work consists of the development of two amplification stages that boost the …
-
A Wireless Surface Electromyography (WSEMG) System
… analysis may exercise multiple sensors, each representing a unique data channel, positioned about the patient's body. Data transmission cables are linked between the surface mounted sensor nodes and a backpack worn by the patient. As the number of sensors increases, the patient's freedom of …
-
Ultra-fine signal classification using memristor-enabled hardware
… 50mV DC offset from electrodes. The measurement presents that the memristor-based pre-amplifier is capable of achieving above 95% spike detection accuracy with hundreds of nanowatt power consumption per channel. This design indicates a promising approach to conduct spike-detection on-chip with …
-
Magic Angle Spinning Spheres and Improved Microwave Coupling for Magnetic Resonance
… the probe are separated along with placing the pre-amplifier in close proximity to the receive coil. This design can lead to an improved signal-to-noise ratio. The improved MAS DNP NMR instrumentation will allow for sufficient sensitivity to investigate complicated biological systems.
-
Developing an Automated Explosives Detection Prototype Based on the AS&E 101ZZ System
… hardware was developed to interface to the AS&E pre-amplifier boards, to collect image data from all three x-ray detectors, and to transfer the data to a personal computer. This hardware, the Differential Pair Interface Board (DPIB), is based on a Field Programmable Gate Array (FPGA) and can be …
-
Characterization of Optimized Si-MOSFETs for Terahertz Detection
… low noise setup comprising of a lock-in amplifier, low noise current pre-amplifier, and various low noise techniques has been assembled. Different biasing conditions and temperature were used to analyze the mechanisms of detection and find the best operating parameters. The devices that …
-
Caracterização de fitas supercondutoras 2G HTS em regime de Flux flow
… and above critical current (Ic) values. Also, a pre-amplifier circuit was developed for continuous monitoring of voltage rise in the samples during the current pulse. The exponential factor N characteristics were obtained from V-I measurements for four 2G tapes models from different companies in …
-
Amplification of 2um squeezed light
… light enable the reduction of quantum noise in precision interferometric measurements and are routinely employed in gravitational-wave detectors. Future gravitational-wave detector upgrades based on cryogenic silicon optics are expected to operate at longer wavelengths near 1984nm, to take …
-
Noise exposure and risk of hearing loss for Air Force welders
… via a two-channel system using a microphone, pre-amplifier and front-end unit for each channel. The signals were saved to digital audiotape or a digital oscilloscope and then analyzed with a real time analyzer and the digital oscilloscope. One channel was used normally and the other was varied …
Page 1 of 3