Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 184 for “"Preheat"”.
-
Effects of preheat on weldments of NICOP steel
… (HAZ) of weldments fabricated with and without preheat. Microhardness , scanning electron microscopy and transmission electron microscopy were used to determine the effect of preheating on the microstructure Similar microstructures in the preheat and non-preheat samples were observed. The …
-
Thermal energy transport in asphalt paving operations with base preheat
Includes bibliographical references (page 229).
-
Effects of preheat temperature and vitiation on reaction kinetics of higher hydrocarbon fuels
… The experimental conditions include high preheat temperatures (up to 650 K) and reduced O2 levels (down to 15% mole fraction in the oxidizer); the latter is relevant to vitiation, where there is partial pre-burning of the oxidizing flow. Furthermore, vitiation introduces combustion …
-
ON THE TOPOLOGY OF BUNSEN FLAMES IN THE BROADENED PREHEAT/THIN REACTION REGIME
Thesis (Ph.D.)--Michigan State University. Mechanical Engineering - Doctor of Philosophy, 2026
-
Mechanistic Investigation of Asphaltene-Induced Fouling in Preheat Trains of Refinery Crude Distillation Units
Asphaltene precipitation and its subsequent deposition is a growing problem for the oil and gas industry. Not only does it hinder the output of oilfields, but it also causes significant issues in downstream refining. Blending incompatible oils and operations at high surface temperatures are some of …
-
A simulation model capable of performing the calculations involved in defining a crude preheat train
… been developed for a system of ex changers to preheat the feed to a crude distillation unit. In conjunction, a Fortran program for the performance of the model calculations by digital computer was written. Two types of preheat system were simulated, a single train system and a split (or …
-
Laminar flame speed and stretch sensitivity of hydrocarbon fuels at high preheat, pressure and vitiation
… of laminar flame speed data of C₁-C₃ alkanes at preheat (300-650 K), pressure (1-10 atm) and significant oxidizer dilution (15-21 vol% O₂). Over 400 measurements are reported over a wide range of conditions along with comparison to predictions from leading chemical mechanisms. Unstretched flame …
-
Turbulent mixing and reacting flow characteristics of axisymmetric bluff-body stabilized propane-air flames, under inlet mixture stratification and preheat
… for a variety of inlet mixture compositions and preheating temperatures. The burner consists of three concentric disks that form two premixing cavities. Fuel (propane) is injected in the first cavity and is partially premixed with air flowing through the cavity system, resulting into a stratified …
-
Simulation Of An Energy Conservation Approach For Modification Of Air Conditioning System Employing Preheat Tanks And A Chilled Water Storage System
… modified air conditioning system, which employs preheat tanks and chilled water tanks (CHWT), in an effort to achieve energy conservation opportunities in selected buildings at the University of Alabama at Birmingham (UAB), which is located in a hot and humid climate region in the southeastern …
-
Studies of UHT-plant fouling by fresh, recombined and reconstituted whole milk : a thesis presented in partial fulfilment of the requirements for the degree of Doctor of Philosophy in Food Engineering
… of this study was to investigate the effects of preheat treatments on fouling by fresh whole milk (FWM), recombined whole milk (RCB) and reconstituted whole milk (Recon) in the high-temperature heater of indirect UHT plants. Various preheat treatments prior to evaporation during milk powder …
-
Thermodynamic analysis of single-screw oil-flooded refrigerant compressors
… included (1) the shaft power (99.9 kw), (2) the preheat power (14.8 kw), (3) the closed compression power (85.1 kw), (4) the oil shear power (8.1 kw), (5) the oil displacement power (4.3 kw) and (6) the external oil pumping power (0.85 kw). For this case, the model also predicted the …
-
Simulation Analysis of Ceramic Shell Representation and Process Parameters in IN718 Investment Casting
… Among the investigated process parameters, shell preheat temperature has the strongest influence on the evaluated outputs. Higher shell preheat gives preferable porosity indications, while lower shell preheat gives less favourable indications, especially when combined with lower mass flow. The …
-
Characterizing laser-heated plasma energy density distributions for magnetized liner inertial fusion
… National Laboratories [1]. It uses fusion fuel preheating via a laser. A subsequent cylindrical liner implosion and magnetic flux compression brings this fuel to fusion conditions. Experiments on the Z-facility at Sandia have produced compelling neutron yields in the range of 10¹² n/shot [2]. …
-
Effects of Temperature and Fuel Dilution on Soot Yields in an Inverted Gravity Flame Reactor
… co-flow diffusion flames varied by dilution and preheat are characterized by temperature and soot emission measurements. Flame conditions vary by fuel structure (ethane, ethylene, methane), fuel dilution with Ar (0-90%), and preheat of reagents. The measured maximum flame temperature (Tmax) is …
-
Fuel/air Ratio Control Recuperative Gas Fired Furnaces
The application of recuperation by combustion air preheat to industrial gas fired furnaces can result in an appreciable saving in fuel. The application of such recuperation has, however, been limited,since changes in the combustion air temperature can cause the fuel/air ratio to vary widely from …
-
Assessment and Analysis of Turbulent Flame Speed Measurements of Hydrogen-Containing Fuels
… pressure data (up to 20 atm), and add data at preheat temperatures up to 500 K. The addition of this data is of great importance as it allows for further exploration of thermodynamic and fuel effects on ST,GC¬. The analysis of this database reveals several key findings. Firstly, regardless of …
-
Studies of rich and ultra-rich combustion for syngas production
… potential and the second on the effect of preheat temperature. A primarily experimental investigation of the conversion of jet fuel and butanol to syngas was undertaken to understand the potential of these fuels for conversion. With these new data and previously-published experimental data, …
-
The feasibility of waste heat recovery and energy efficiency assessment in a steel plant
… following six areas: 1) recovering waste heat to preheat billets, 2) upgrading the charge end in the reheat furnace, 3) recovering waste heat to preheat combustion air in the ladle preheater, 4) replacing direct-fired natural gas heaters with indirect-fired natural gas heaters, 5) Oxyfuel …
-
Emission Modeling in Turbulent Premixed Flames
… small-scale eddies could penetrate into the preheat zone of the flames and enhance the mixing process. In this study, the effects of small-scale turbulence on emission (NOx and CO) formation in premixed flame fronts are investigated through the incorporation of turbulence induced diffusion in …
Page 1 of 10