Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 20 of 52 for “"Primary Particle Size"”.

  1. Characterization of primary particle size variation and its influence on measurable properties of aerosol soot

    … on precise measurement of their morphology (i.e. primary particle diameter, dp, and its polydispersity). For decades soot has been modeled as fractal-like aggregates of nearly equiaxed spherules. However, examination of the soot particles collected from different combustion environments shows that …

    ubc Repository record for Characterization of primary particle size variation and its influence on measurable properties of aerosol soot (opens in a new tab) Download PDF for Characterization of primary particle size variation and its influence on measurable properties of aerosol soot (opens in a new tab)

  2. Characterizing the structure of post-flame agglomerated soot using simulations and experiments

    Primary particle size distributions affect soot aggregate size, mass, mobility, and optical behavior. Prior studies report greater primary particle size variability between aggregates than within them. This implies aggregation of primary particles with similar flame origins, known as the external …

    ubc Repository record for Characterizing the structure of post-flame agglomerated soot using simulations and experiments (opens in a new tab) Download PDF for Characterizing the structure of post-flame agglomerated soot using simulations and experiments (opens in a new tab)

  3. Evaluation of rotating fluidized bed as a dry coater

    Coating of particles is normally carried out with the use of environmentally unfriendly solvents. Development of dry coating methods is therefore quite important. A Rotating Fluidized Bed was constructed, instrumented and verified as to operation. Twelve coating experiments were carried out with …

    njit Repository record for Evaluation of rotating fluidized bed as a dry coater (opens in a new tab)

  4. Soot Particle Sampling and Morphology Analysis in an Optically Accessible Diesel Engine

    … studies have primarily focused on exhaust soot particles, how these soot particles are formed in the first place is virtually unknown. To bridge this gap, this thesis presents a new experimental approach for collecting soot particles inside the cylinder of a single-cylinder light-duty diesel …

    unsw Repository record for Soot Particle Sampling and Morphology Analysis in an Optically Accessible Diesel Engine (opens in a new tab)

  5. On the Use of Laser-Induced Incandescence for Soot Diagnostics: From Theoretical Aspects to Applications in Engines

    … for measurements of soot volume fraction and particle size. The technique relies on detection of incandescent light from soot particles heated to around 4000 K using nanosecond laser pulses. A theoretical model for LII has been implemented and improved in order to provide a tool for predicting …

    lund Repository record for On the Use of Laser-Induced Incandescence for Soot Diagnostics: From Theoretical Aspects to Applications in Engines (opens in a new tab) Download PDF for On the Use of Laser-Induced Incandescence for Soot Diagnostics: From Theoretical Aspects to Applications in Engines (opens in a new tab)

  6. Titanium dioxide particle size effects on the degradation of organic molecules

    <p>Nanometer-size titania photocatalysts exhibit variations in chemical properties due to quantum effects on the semiconductor band gap and due to surface and crystalline properties. Degradation of organic molecules appears to be most efficient at particle sizes between 10 and 100 nm for anatase …

    iastate Repository record for Titanium dioxide particle size effects on the degradation of organic molecules (opens in a new tab)

  7. The fate of airborne nanoparticles released from a leak in a nanoparticle production process into a simulated workplace environment.

    A leak in nanoparticle production equipment can cause large quantities of nanoparticles to be emitted into a workplace environment. Toxicity studies have shown hazards of inhaling nanoparticles; however these studies may not be using the proper particles. Physical and chemical changes may occur as …

    umn Repository record for The fate of airborne nanoparticles released from a leak in a nanoparticle production process into a simulated workplace environment. (opens in a new tab)

  8. Modeling of Carbon Nanoparticle Formation in Combustion and Pyrolysis Environments and Its Application in the Carbon Black Industry

    Carbonaceous nanoparticles such as soot and carbon black (CB) are formed during the incomplete combustion or pyrolysis of hydrocarbons. Soot is a threat to human health and climate change, while CB has diverse applications that depend on the particle morphology, e.g., aggregate structure. …

    toronto-retro Repository record for Modeling of Carbon Nanoparticle Formation in Combustion and Pyrolysis Environments and Its Application in the Carbon Black Industry (opens in a new tab)

  9. Titanium dioxide photocatalysis: studies of the degradation of organic molecules and characterization of photocatalysts using mechanistic organic chemistry

    … first study focuses effects of photocatalyst particle size on the early chemical steps of degradation of two probe molecules, 4-methoxyresorcinol (MR) and 1-para-anisyl-1-neopentanol (AN) when the Millennium PC series anatase titania catalysts are used. These catalysts differ in particle size …

    iastate Repository record for Titanium dioxide photocatalysis: studies of the degradation of organic molecules and characterization of photocatalysts using mechanistic organic chemistry (opens in a new tab)

  10. Influence Of Suspended Particle Size And Composition On Particle Image Processing, Estuarine Floc Fractal Properties, And Resulting Estuarine Light Attenuation

    Understanding the nature of suspended particles is crucial to explaining water clarity issues in many estuaries, including the Chesapeake Bay and its tidal tributaries. Typical near surface estuarine particles are not individual sediment grains, but rather are clusters of inorganic and organic …

    wm-mary Repository record for Influence Of Suspended Particle Size And Composition On Particle Image Processing, Estuarine Floc Fractal Properties, And Resulting Estuarine Light Attenuation (opens in a new tab)

  11. Aggregation and Redispersion of Switchable Latexes

    … redispersed, as shown by recovery of primary particle size (measured by light scattering methods), but an input of energy was required. Sonication was the first method used, but lower-energy methods such as rotor-stators and a blender have also been successful in redispersing …

    queens Repository record for Aggregation and Redispersion of Switchable Latexes (opens in a new tab)

  12. Designing granules for abrasive cleaning (using high-shear granulation).

    … of a failure distribution curve (how many particles will fail per hundred impacts as a function of velocity). This is done using a "critical normal impact velocity" determined from the properties of the granule, properties of the impact surface and experimentally measured granule static …

    whiterose Repository record for Designing granules for abrasive cleaning (using high-shear granulation). (opens in a new tab) Download PDF for Designing granules for abrasive cleaning (using high-shear granulation). (opens in a new tab)

  13. The fine structure of cupric ferrocyanide semipermeable membranes

    … gels consist of loosely and randomly packed primary particles in the size range of 10 to 30 A. The pore space is the interstices between the particles. The primary particles are crystalline, the electron and x-ray diffraction patterns corresponding to the standard pattern of Cu2Fe(CN)6. …

    rice Repository record for The fine structure of cupric ferrocyanide semipermeable membranes (opens in a new tab)

  14. Predictive model for plume opacity

    … due to 1) the aerosol formed by condensation of primary sulfuric acid and water vapor onto polydisperse plume particles and 2) the presence of fine particles which grow into the visual size range by heterogeneous condensation and coagulation processes as the plume is cooled and diluted by mixing …

    vt Repository record for Predictive model for plume opacity (opens in a new tab)

  15. A Mechanistic Understanding of Agglomeration in Agitated Filter Dryers Across Scales

    … of salicylic acid were identified by modifying primary particle size. The resulting agglomerate growth and breakage dynamics were categorised using a regime map, where agglomerate growth is described as a function of maximum pore saturation and Stokes deformation number. This is the first regime …

    whiterose Download PDF for A Mechanistic Understanding of Agglomeration in Agitated Filter Dryers Across Scales (opens in a new tab)

  16. Application of X-ray microtomography to the description of single granules

    … clear in the performance indicators: increasing primary particle size, binder molecular weight and binder to solid ratio resulting in stronger/more difficult to dissolve granule.

    whiterose Download PDF for Application of X-ray microtomography to the description of single granules (opens in a new tab)

  17. In-situ generation of silica particles in solution styrene butadiene rubber – A possible material solution to improve the performance of rubber

    … of polymer solution. It means the silica particles were allowed to grow in the presence of rubber in the reaction mixture. It was observed that the sizes of the synthesized silica particles are rather larger than standard precipitated commercial silica particles. In depth morphological …

    qucosa-diss

  18. Synthesis and characteristic of doped CdS aerogels

    … semiconductor nanocrystals with mono-disperse size distribution and stabilization. The synthesis of aerogel network based on II–VI , III–V semiconductors is expected to have novel properties due to the marriage of the quantum-confined electro-optical properties of the nanoparticle blocks with …

    ttu Repository record for Synthesis and characteristic of doped CdS aerogels (opens in a new tab)

  19. A two-component aggregation model

    … aggregation model which allows specification of primary particle size, density, and fractal dimension for two different particle types was written. Three stickiness values are used, the stickiness of each particle type to itself and the stickiness between particle types. Aggregation mechanisms …

    wm-mary Repository record for A two-component aggregation model (opens in a new tab)

Page 1 of 3