Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 892 for “"Propeller"”.
-
Computational Modeling of Propeller Noise: NASA SR-7A propeller
The aerospace industry has been concerned with propeller noise levels for years. This interest is two-fold: government regulation and comfort in cabin. This report attempts to create a simulation mechanism needed to evaluate the far-field noise generation levels. However, in order to do that, the …
-
Aeroacoustic Implications of Installed Propeller Interactional Aerodynamics and Transient Propeller Motions
… aviation concepts have revived the interest in propeller-driven aircraft. A number of electric vertical take-off and landing (eVTOL) aircraft have been developed to cater to the demands of urban air mobility (UAM) and significant advancements have been made in unmanned aerial vehicles (UAV) …
-
Shrouded UAV Propeller Noise
… is to install an axisymmetric shroud around the propellers. However, the presence of the shroud will modify the noise produced by the propellers. This thesis describes an experimental, numerical, and theoretical investigation into the effect of a shroud on two significant propeller …
-
Surface piercing propeller performance
… in the efficiency (thrust) of surface piercing propellers; in particular with respect to the angle of the propeller shaft came to mind. Preliminary calculations based on the basic pitch/diameter geometry suggest that about 3-5% efficiency is lost if the shaft is parallel to the flow, compared to …
-
Investigation of propeller stall flutter
Propeller flutter can manifest in a variety of ways. This includes classical bending-torsion flutter, stall flutter and whirl flutter. Classical bending-torsion flutter for propeller blades is driven by the coupling, and excitement, of selected modes of motion. Such flutter problems are often a …
-
Analysis of convertiplane propeller-rotors.
… the classes of convertiplanes which use the same propeller-rotor to provide vertical thrust for take-off and landing and horizontal, axial thrust for normal cruising flight can satisfy many of tie needs for VTOL convertiplanes. A basis for evaluation of the performance of propeller-rotors for …
-
Automatic control of propeller pitch
… the feasibility of automatically controlling propeller pitch to reduce RPM fluctuations caused by variations in propeller speed of advance. The investigation was made ignoring the reduced frequency effect and power plant governing. A Victory Ship (AP2) was chosen as a prototype and a feedback …
-
Development and Implementation of a Propeller Test Capability for Gl-10 "Greased Lightning" Propeller Design
… energy and noise associated with electric propeller propulsion systems presents many challenges. NASA Langley has developed the Greased Lightning 10 (GL-10) vertical takeoff, unmanned aerial vehicle with ten individual motors and propellers. All are used for propulsion during takeoff and …
-
Multirotor Unmanned Aerial Vehicle Propeller Noise
… small UAVs in hover and static, isolated UAV propellers. A literature review identified that there is a multitude of shaft order tones and tones at harmonics of the blade passing frequency (BPF) in experimental sound pressure level spectra, but that the physical mechanisms generating these …
-
Unmanned Aerial Vehicle Propeller Tone Noise
… of multi-rotor Unmanned Aerial Vehicle (UAV) propellers operating in the hover condition are investigated. An experimental method for making high resolution measurements of the tonal noise from an isolated UAV propeller in the acoustic near-field is presented. Because of the high amplitude and …
-
Cyclic stresses in marine propeller shafting
… tailshaft and that the bending stresses when the propeller is "breaking water" (ship running light) are about 2½ times as great as when the propeller is fully submerged (ship at full-load draft). The experimental technique developed in this project may be used to advantage in future research on …
-
Feasibility of morphing aircraft propeller blades
… the feasibility of variable geometry aircraft propeller blades, the main focus being on the aerodynamic performance. A number of objectives are established to reach this goal, with the development of an aerodynamic model and a blade optimization scheme being among these. The choice of the blade …
-
Wind Tunnel Automation For Propeller Testing
An automated propeller test capability for the ODU Low-Speed Wind Tunnel Facility is demonstrated; implementing automation improved both ease of testing and quality of results. An experiment was performed with and without automation to compare results. Prior to this effort, propeller RPM and …
-
Aeroacoustics of Propeller Boundary Layer Ingestion
… investigates the aeroacoustics of a propeller ingesting turbulent boundary layers, with a focus<br/>on exploring parameter sensitivity, noise source identification, and flow-field behaviour.<br/>Two experimental setups were built and tested in the Aeroacoustic Facility at the …
-
Data-driven machine learning model for propeller design: Applying supervised regression algorithms to predict propeller blade geometry
… high demand for innovative and high performance propellers for marine vessels motivates propeller designers to strive for a more efficient and less resource costly design process. To create a more robust process, propeller designers look towards potential resource optimization tools in the form …
-
Using Single Propeller Performance Data to Predict Counter-Rotating Propeller Performance for a High Speed Autonomous Underwater Vehicle
The use of counter-rotating propellers is often desirable for aerospace and ocean engineering applications. Counter-rotating propellers offer higher peak efficiencies, better off-design performance, and roll control capabilities. But counter-rotating propeller matching is a difficult and complex …
-
Propeller caviation in solutions of polyethylene oxide.
… cavitation on a l4.8-cm diameter, two-bladed propeller were measured in homogeneous aqueous solutions of polyethylene oxide, WSR-301, at concentrations ranging from to 100 wppm (weight parts per million). Rotational speeds ranged from 1300 to 2000 rpm. At concentrations of 25 wppm and greater, …
Page 1 of 45