Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 99 for “"Reflected Shock"”.
-
Energy absorbed from reflected shock waves.
… describes the reflection of a finite amplitude shock wave off a non-rigid surface . The amount of energy absorbed by the shock reflecting surface was experimentally determined by the use of decigram charges of high explosive and photographs of the resulting shock wave. It was found that a \ inch …
-
Development of a Supersonic Reflected Shock Tunnel
A reflected shock tunnel capable of producing supersonic/hypersonic flows was developed. The facility as a whole is described and tested for purposes of calibration and demonstration. A method for producing diaphragms in-lab was developed, and demonstrated to produce diaphragms with good bursting …
-
Strip Film Schlieren-Interferometric Observation of the Effect of Reflected Shock-Boundary Layer Interaction on Reflected Shock Density in Several Gases
Made available in DSpace on 2014-12-09T18:12:20Z (GMT). No. of bitstreams: 1 6511775.pdf: 4880336 bytes, checksum: 148962069ae56c0ef97ba1d4085f9a6f (MD5) Previous issue date: 1965
-
Photographic investigation of reflected shock phenomena from decigram explosive charges
An investigation of the primary shock front and Mach Y-stem systems was conducted utilizing decigram explosive charges. Distance and arrival time data of the primary shock front was correlated with that of high yield explosions. A good correlation would indicate the feasibility of conducting …
-
Diesel Spray and Premixed Methane-Air Ignition Behind a Reflected Shock Wave
… and pressure conditions were created behind a reflected shock wave in a 76 mm square-channel shock tube. A common-rail piezoelectric diesel injector with 8 tip orifices was mounted in the centre of the shock tube end wall to replicate in-cylinder placement. A single pass 150 mm diameter z-type …
-
High-speed liquid-spray injection technique for combustion studies behind reflected shock waves
Master of Science (M.S.)
-
Chemiluminescence and Ignition Delay Time Measurements of C9H20 Oxidation in O2-Ar Behind Reflected Shock Waves
… and 2.0) and fixed pressure near 1.5 atm using a shock tube. Utilizing shock waves, high-temperature, fixed-pressure conditions are created within which the fuel reacts, where temperature and pressure are calculated using 1D shock theory and measurement of shock velocity. Of interest were …
-
The Effect of 2,5-Norbornadiene on the Ignition of Hydrogen and Methane Behind Reflected Shock Waves
… highly diluted in argon using the High-Pressure Shock Tube and Aerospace Shock Tube Facilities at Texas A&M University. Reflected-shock temperatures ranged from 1014 to 1459 K in the hydrogen mixtures and 1778 to 2227 K in the methane mixtures. Reflected-shock pressures remained near 1 atm for …
-
Wall Heat Transfer Effects In The Endwall Region Behind A Reflected Shock Wave At Long Test Times
Shock-tube experiments are typically performed at high temperatures (≥1200K) due to test-time constraints. These test times are usually ~1 ms in duration and the source of this short, test-time constraint is loss of temperature due to heat transfer. At short test times, there is very little …
-
Reaction Rate Measurement of C2H5OH→C2H4+H2O During Ethanol Pyrolysis Using H2O Time History Measurements Behind Reflected Shock Waves
… been studied under pyrolytic conditions behind reflected shock waves in the 1250 to 1677 K temperature range, at an average pressure of 1.31 atm for a mixture highly diluted in Ar. A laser absorption technique was utilized to measure Hv2O time histories, and the detailed kinetics mechanism …
-
An upper limit for the methane-oxygen initation reaction in the presence of iodine-131 behind reflected shock waves
<p>A one-inch diameter single-pulse shock tube was used to study the rate of methyl iodide formation from 815 to 1151K via the reaction CH(,4) + I (--->) CH(,3) + HI with the observed rate constant k(,40) = 10('14.5) exp(-33.7/RT) cm('3)/mole sec. Tracer quantities of iodine-131 were used to follow …
-
Laser Absorption Measurements of CO and H2O from Dimethyl Carbonate Combustion Behind Reflected Shock Waves for Safer Li-Ion Battery Applications
… and to improve a detailed kinetic model. Shock tubes were used to measure time histories of CO and H2O using tunable laser absorption techniques for the first time for DMC. Characteristic reaction times were also measured through OH* emission. Shock-tube spectroscopic measurements were …
-
A study of radiating argon flows at high opacities
… the various flows associated with a free piston reflected shock tunnel assembly. Experiments have been performed using argon as a test gas because the radiation loss with argon is quite considerable under the thermodynamic conditions experienced in this study. The nature of the experiments was …
-
Detonation Initiation Induced by Shock Reflection
Shock reflection driven detonation initiation was investigated in a square cross-section shock tube using novel stereo visualization. High-speed schlieren video captured the shock reflection and detonation onset through the side of the shock tube, and simultaneously, self-luminous imaging through …
-
Processes occuring in a pressure-driven shock tube
… the processes occurring within a pressure-driven shock tube are described in this work. Ideal incident and reflected shock-wave theory are reviewed. Nonequilibrium vibrational relaxation and laminar boundary layer theory are discussed.</p> <p>A numerical integration of the incident and reflected …
-
Demonstration of a High-Speed Endwall Imaging Setup for Studying Ignition Phenomena in a Shock Tube
Inhomogeneous combustion events in shock-tube experiments can be difficult to identify and can be an obstacle to data collection at certain conditions where such nonideal effects are encountered. Understanding these undesirable combustion events, which typically occur for undiluted mixtures at …
-
Driver-gas Tailoring For Test-time Extension Using Unconventional Driver Mixtures
… combustion chemistry at low temperatures in a shock tube, it is of great importance to increase experimental test times, and this can be done by tailoring the interface between the driver and driven gases. Using unconventional driver-gas tailoring with the assistance of tailoring curves, …
-
Calibration of a shock tube by analysis of the particle trajectories
… flow behind an imtermediate strength unsteady shock, a knowledge of the particle trajectories within the flow is sufficient. This principle has been applied to determine the variation of the physical parameters throughout the length of a conventional shock tube. The particle trajectories were …
-
Design of an Inexpensive PVC Shock Tube for Educational Use
… easy-to-assemble, -operate, and -disassemble shock tube platform experiment that can generate shock waves approaching Mach 2 at maximum pressures of ~100 psig with a helium driver gas. The experiment uses several inexpensive (<$5), unamplified piezoelectric sensors attached to a multichannel …
-
A New Shock-Tube Facility for the Study of High-Temperature Chemical Kinetics
A new stainless steel shock-tube facility designed for the study of chemical kinetics at elevated temperatures and pressures is described. It consists of a single-pulse shock tube capable of using both lexan diaphragms and die-scored aluminum disks of up to 4 mm thickness, and it has a relatively …
Page 1 of 5