Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 51 for “"Relative intensity noise"”.
-
Relative Intensity Noise (RIN) in High-Speed VCSELs for Short Reach Communication
… These optical power variations provide an intensity noise. Since optical transmission systems have a critical impairment due to this noise source, it is quite important to know how it can be defined and measured. Relative intensity noise (RIN) is a measure in order to quantify and determine …
-
Signal modulation and relative intensity noise properties of transistor laser and nano-cavity VCSEL
… optical response as well as ultra-low laser relative intensity noise (RIN) reaching the “standard quantum limit”. In addition, the unique three-port electronical/optical (E/O) characteristics permit electrical “read-out” of optical parameters, which benefits for high speed direct …
-
Relative intensity noise transfer in fiber raman amplifiers with multiple coherent or incoherent pumps
Fiber Raman amplifiers (FRAs) suffer from relative intensity noise (RIN) transfer from pumps to signals. RIN transfer for FRAs with single pump to one signal was well investigated. However, RIN transfer for FRAs with multiple pumps to multiple signals has not been investigated so far. We used an …
-
Characterization and comparison of optical source relative intensity noise and effects in optical coherence tomography
… investigates the effects of optical source noise in optical coherence tomography (OCT). While shot noise, thermal noise and relative intensity noise (RIN) (excess photon noise) constitute optical noise, RIN is the least understood and often the most significant factor limiting the …
-
Impact of Raman crosstalk and relative intensity noise transfer on RF overlay in optical passive networks
… overlay channels induced by 1490-nm optical intensity modulated digital data channel, considering modulation formats of non-return-to-zero (NRZ), return-to-zero (RZ), Inverse-RZ (IRZ), and Manchester coding, fiber length, optical power, optical modulation index and fiber polarization mode …
-
Investigation and development of a novel metrology standard for the measurement of relative intensity noise and frequency chirp of DFB lasers in optical networks
Laser diode Relative Intensity Noise (RIN) metrology capabilities have been developed and demonstrated, providing significantly improved sensitivity and accuracy than existing methods. This is a key parameter for laser components used in telecommunication systems due to the drive to reduce inherent …
-
Μελέτη ημιαγωγών λέϊζερ συντονιστών μικροδακυλίου για την υλοποίηση φωτονικών λειτουργιών σε αμιγώς οπτικά τηλεπικοινωνιακά δίκτυα
… reflectivity and the ring radius. Moreover, the Relative Intensity Noise spectra are extracted since the RIN value can be a critical parameter and limit the performance of optoelectronic circuits. In the second part of this thesis an experimental verification of the numerical results is …
-
Semiconductor Laser Device-Level Characteristics
… frequency responses for VCSEL and FP lasers, and relative intensity noise (RIN) for DFB and FP lasers have also been measured. Finally, the measurement of the frequency response of the optical pumping with 850nm VCSEL has been attempted.
-
Enhanced digital modulation of coherently coupled vertical cavity laser arrays: theory and application
… Additionally, the differential resistance, relative intensity noise, and harmonic distortion are measured to characterize the behavior of coherently coupled laser arrays in the locking region. Two-dimensional maps of total relative intensity noise and total harmonic distortion are created to …
-
Applications of digital adaptive filters to time-resolved optical microscopy
… We also describe our strategy to mitigate relative intensity noise (RIN) in ultrafast fiber lasers, which are an attractive alternative to bulk lasers for non-linear optical microscopy due to their compactness and low cost. The high RIN of these lasers poses a challenge for pump-probe …
-
Subcarrier multiplexing for fiber-based video distribution: A performance study.
… and clipping at threshold, and from noise sources (laser RIN (relative intensity noise), signal shot noise and preamplifier thermal noise at the receiver). We have also considered the possibility of using laser optical amplifiers to increase the system margin. Again, device …
-
Output Characteristics and High-Speed Modulation of Composite -Resonator Vertical -Cavity Lasers
… including small-signal direct modulation and relative intensity noise measurements. The measured data in this chapter is compared to theoretical models, and several figures of merit for high-speed operation are calculated. The thesis concludes with an evaluation of the novelty of the CRVCL and …
-
Fabrication and characterization of erbium doped waveguide amplifiers and lasers
… dependence on the waveguide width and the relative intensity noise (RIN) of the laser. The tunability of the lasing wavelength to the desired wavelength, after waveguide fabrication, by annealing was demonstrated. A novel planar waveguide laser configuration for single-mode operation around …
-
IMPACT OF GRATING DUTY-CYCLE RANDOMNESS ON DFB LASER PERFORMANCE
… suppression ratio (SMSR), and deteriorates the noise characteristics, i.e., broadens the linewidth and increases the relative intensity noise (RIN). With the grating DCR, the effective grating coupling coefficient decreases as evidenced by the reduced Bragg stopband width. However, the …
-
High-speed Modelocked Semiconductor Lasers And Applications In Coherent Photonic Systems
… respect to the laser linewidth (~ 3 MHz), the relative intensity noise (RIN) (< -150 dB/Hz), as well as the modal RIN (~ 3 dB reduction). MSL to MSL, and tunable laser to MSL synchronization is demonstrated by using a dual-mode injection technique and a modulation sideband injection technique, …
-
High-Speed Modulation of Semiconductor Lasers and Modulators
… enhancement of the high-speed modulation and relative intensity noise (RIN) spectra of a side-mode injection-locked FP laser system. Second, we investigate integrated electroabsorption modulator-lasers. They are more compact and have very good high-speed performance. We study injection locking …
-
Performance of MB-OFDM ultra-wideband signals over fiber transmission using a low cost electro-absorption modulator integrated laser
… the performance is mainly limited by signal to noise ratio, but mainly limited by EML response nonlinearities when modulation power is high. Theoretical analysis of the effect of fiber dispersion and EML response nonlinearities on system performance is carried out considering amplitude and phase …
-
Impact of optical transmission on multi-band OFDM ultra-wideband wireless system with fiber distribution
… chromatic dispersion induced laser phase to intensity noise or relative intensity noise (RIN) on system performance is carried out. Experiments are also conducted to verify our theoretical analysis. Simulation is also carried out to show the relationship between RIN and center frequency of …
-
Intracavity generation of high order harmonics
… the EUV. The requirement for HHG is a high peak intensity (>10¹³ W/cm²), which can be met by external amplification of the laser output. The method of amplification chosen for this work is a femtosecond enhancement cavity (fsEC), which stores and amplifies the output of a femtosecond mode-locked …
-
Raman fibre laser based amplification in coherent transmission systems
… from different aspects, including signal/noise power distributions, relative intensity noise (RIN), mode structures of induced Raman fibre lasers, and so on. It was found for the first time that RFL based amplification techniques could be divided into three categories in terms of the fibre …
Page 1 of 3