Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 260 for “"Residual strength"”.
-
Residual Strength of Franciscan-Derived Clay
… mantle on the hills throughout the region. Peak strength is the typical parameter tested to assess the strength of the soil. For the Franciscan-derived clay, the residual strength is the focus of this study to understand slope failure since the clay is the weakest portion of the matrix in the …
-
The Residual Strength of Liquefied Soil
… failure. To determine flow slide potential, the residual strength of liquefied soil is needed. However, this is an extremely difficult parameter to estimate for soil deposits due to spatial variability of soil properties, potential for the formation of water films, the intermixing of soils, and …
-
Residual strength of corroded reinforced concrete beams.
… none addresses the problems associated with the residual strength of reinforced concrete beams exhibiting both main and shear reinforcement corrosion simultaneously. The aim of this research, therefore, was to determine the residual strength of corroded reinforced concrete beams where various …
-
Time Dependent Model for Soils Near Residual Strength
… be expected to be unstructured and have residual strength. In the last decades research has been undertaken to characterise the time and rate dependent response of soils and describe it by means of a constitutive model. Most constitutive equations have been developed for a single stress …
-
Prediction of the residual strength of liquefied soils
… slide development requires evaluation of the residual strength of liquefied soil. This problem has been one of the most difficult in geotechnical earthquake engineering because the residual strength is difficult to be measured accurately. Empirical procedures based on back-calculation of …
-
The residual strength of a ship after an internal explosion
… structural plating. In order to analyze the residual strength of a ship after an internal explosion, a typical ship compartment was considered to be composed of flat square plates subjected to uniaxial compression, and the damage effects were examined independently. The holing was considered …
-
Peridynamics for Failure and Residual Strength Prediction of Fiber-Reinforced Composites
… utilized approaches. Predicting damage and residual strengths of composite materials involves capturing complex, distinct and progressive failure modes. The peridynamic laminate theory correctly predicts the load redistribution in general laminate layups in the presence of complex failure …
-
Residual Strength of Ultra-High Performance Concrete After Exposure to Elevated Temperatures
… of elevated temperatures on the compressive strength of ultra-high-performance fiber-reinforced concrete (UHPFRC). Two different mixtures of a commercially available UHPFRC were considered in this study. The standard mixture offered by the manufacturer incorporates only steel-fibers to …
-
Post-liquefaction Residual Strength Assessment of the Las Palmas, Chile Tailings Failure
Assessment of post-liquefaction residual strength is needed for the development of empirically-based, predictive correlations for earthquake engineering design. Previous practice commonly assigned negligible strengths to liquefied materials for engineering analysis, producing overly-conservative …
-
Residual strength assessment of corroded ships involved in ship-to-ship collisions
… of the present study is to estimate the ultimate strength of damaged ships considering the effects of material degradation due to corrosion. A review of the corrosion models, which can be used for the prediction of the thickness reduction of the hull, is included. The structural damage of …
-
A residual strength approach for the fatigue analysis of welded components / Abir Ghosh.
… be used to predict the variation in crack size, strength and inspection periods as well as endurances. Basic fracture mechanics and fatigue procedures are used to illustrate this new technique.
-
Measuring Liquefied Residual Strength Using Full-Scale Shake Table Cyclic Simple Shear Tests
… shake table tests to investigate liquefied residual strength of #2/16 Monterey Sand. A simple shear testing apparatus was mounted to a full-scale one-dimensional shake table to mimic a confined layer of saturated sand subjected to strong ground motions. Testing was performed at the Parson’s …
-
A Progressive Damage Methodology for Residual Strength Predictions of Center-Crack Tension Composite Panels
… was conducted to evaluate and develop residual strength prediction capability for laminated composites with through penetration notches. This is relevant to the damage tolerance of an aircraft fuselage that might suffer an in-flight accident such as an uncontained engine failure. An …
-
Experimental Investigations of Residual Strength and Repaired Strength of Corrosion Damaged Prestressed Bridge Beams
… number of structures in marine environments. The residual capacity of corrosion damaged prestressed I-beams and box beams needs to be accurately estimated to determine if damaged bridges need to be posted, and to help with making informed decisions related to repair, rehabilitation and replacement …
-
The residual strength determination due to fatigue loading by fracture mechanics in notched composite materials
… of this investigation is to predict the residual strength of notched composite Iaminates with various layups, subjected to low frequency fatigue loading with constant amplitude at room temperature, by using a material modeling approach, fracture and fatigue mechanics and the finite …
-
Use of Photogrammetry Aided Damage Detection for Residual Strength Estimation of Corrosion Damaged Prestressed Concrete Bridge Girders
… bridge girders with the estimation of their residual flexural capacity. The framework was implemented on four full-scale corrosion damaged girders from decommissioned bridges in Virginia. 3D point clouds of the girders reconstructed from images using Structure from Motion (SfM) approach were …
Page 1 of 13