Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 28 for “"Rotor-stator interaction"”.
-
Influence of vane sweep on rotor-stator interaction noise.
… this dissertation the influence of vane sweep on rotor-stator interaction noise is investigated. In an analytical approach, the interaction of a convected gust, representing the rotor viscous wake, with a cascade of finite span swept airfoils, representing the stator, is analyzed. The analysis is …
-
Wake Filling Techniques for Reducing Rotor-Stator Interaction Noise
… method for reducing the momentum deficit in a rotor wake and thus attenuate rotor-stator interaction noise. A secondary concern of the project was to reduce the amount of blowing required air for wake filling and thus limit the efficiency penalty in an aircraft engine environment. Testing was …
-
Reduction of Unsteady Rotor-Stator Interaction Using Trailing Edge Blowing
… adding mass flow at the trailing edges of four stators upstream of an aircraft engine simulator. By using trailing edge blowing to minimize the shed wakes of the stators, the flow into the rotor was made more uniform. In these experiments a reduced number of stators (four) was used in a 1/14 …
-
Numerical simulation of unsteady rotor/stator interaction and application to propeller/rudder combination
… has been developed in order to simulate unsteady rotor/stator interaction, and to predict the unsteady performance of a propeller and its rudder. The method is first developed and tested in two-dimensions by using a boundary element method in which a front hydrofoil is moving downward, while a …
-
Experimental Investigation of Flow Control Techniques To Reduce Hydroacoustic Rotor-Stator Interaction Noise
… along the forebody and propulsor fluid-structure interaction. The propulsor contains several locations of such interaction, one of which was investigated in this research. Specifically, this research focused on experimentally investigating active flow control techniques to reduce rotor-stator …
-
Investigation of the aerodynamic and acoustic performance of a low-pressure ratio tandem-blade compressor
… configuration is capable of reducing the rotor-stator interaction noise by reducing the radial wake distortion behind the rotor blades, especially at highly loaded conditions, i.e. higher rotor speeds. This is consistent with earlier studies which found that changes in spanwise circulation …
-
Application of boundary element methods (BEM) to internal propulsion systems; application to water-jets and inducers
… dipoles on the shed wake sheets from the rotor/ stator blades. The rotor- stator interaction is accomplished using an iterative procedure which considers the effects between the rotor and the stator, via circumferentially averaged induced velocities. Finally, the hydrodynamic performance …
-
Advanced Trailing Edge Blowing Concepts for Fan Noise Control: Experimental Validation
… edge blowing research performed to reduce rotor / stator interaction noise in turbofan engines. The existing technique of filling every velocity deficit requires a large amount of air and is therefore impractical. The purpose of this research is to investigate new blowing configurations in …
-
Performance improvements to the Naval Postgraduate School Turbopropulsion Labs Transonic Axially Splittered Rrotor
… (NPS TPL) Transonic Axially Splittered Rotor were investigated. Implementation of current NPS TPL design procedure that uses COTS software (MATLAB, SolidWorks, and ANSYS-CFX) for the geometric rendering and analysis was modified and documented. Numerical simulations were conducted and …
-
Conceptual Design and Technical Risk Analysis of Quiet Commercial Aircraft Using Physics-Based Noise Analysis Methods
… locations using physics-based methods for fan rotor-stator interaction tones and jet mixing noise. The analysis process was then used in combination with design of experiments to create response surface equations (RSEs) for the engine and aircraft performance metrics, geometric constraints and …
-
Generation of Downstream Vorticity Through the Use of Modified Trailing Edge Configurations
… velocity into the flow behind a cascade of GE Rotor B fan blades. These measurements were conducted in the Virginia Tech Low Speed Linear Cascade wind tunnel. The trailing edge configurations tested utilized passive techniques for producing streamwise vorticity, which in turn causes downstream …
-
The duct transmission of rotating acoustic modes in axial compressors
… body rotational model, it is shown that (1) the rotor lift noise does not propagate out to the far field and the lower frequency rotor noise experienced the largest decay, (2) only the lowest mode among the modes produced by the rotor-stator interaction radiates into the far field, (3) increasing …
-
Theoretical prediction of counter-rotating propeller noise
… radiated sound field generated by aerodynamic interactions between the blade rows. Here, however, the inputs to the formulae include a knowledge of the fluctuating blade pressure fields which cannot generally be assumed given and must therefore be calculated within the prediction scheme. In the …
-
Numerical simulation of steady and unsteady cavitating flows inside water-jets
… is solved simultaneously in order to take the interaction of all geometries (blades, hub and casing) into account. The integral equation and boundary conditions for the water-jet problem are formulated and solved by distributing constant dipoles and sources on blades, hub and shroud surfaces, …
-
Structural Characterization of F-type and V-type Rotary ATPases by Single Particle Electron Cryomicroscpy
… or hydrolysis. The rotation of the central rotor, which is powered by the flow of proton (or sometimes sodium ion) down the electrochemical gradient through the membrane-bound Fo/Vo region, leads to the chemical synthesis of ATP in F1/V1 region. The F1/V1 region, on the other hand, can …
-
Studies of the ERCOFTAC Centrifugal Pump with OpenFOAM
Numerical solutions of the rotor-stator interaction using OpenFOAM-1.5-dev was investigated in the ERCOFTAC Centrifugal Pump, a testcase from the ERCOFTAC Turbomachinery Special Interest Group. The case studied was presented by Combes at the ERCOFTAC Seminar and Workshop on Turbomachinery Flow …
-
Characterization and source separation of turbofan broadband noise using intra-stage measurements
… trailing edges (TE) of the fan blades and the rotor-stator interaction noise at the leading edges (LE) of the outlet guide vanes (OGV). Despite more than 50 years of research, the fan BB noise is not properly understood, and its rotor (fan) and stator (OGV) components haven’t been properly …
-
Parametric Study of Turbine Blade Internal Cooling and Film Cooling
… a row of holes; the Strouhal number (quantifying rotor-stator interaction) and coolant to mainstream density ratio. Results show a deterioration in film cooling effectiveness with on increasing the Strouhal number. Using a coolant with a higher density results in higher film cooling effectiveness.
-
Efficient Dynamic Unstructured Methods and Applications for Transonic Flows and Hypersonic Stage Separation
… store separation from a military aircraft, rotor-stator interaction in turbomachinery, and dynamic aeroelasticity. The dynamic unstructured technology (DUT) is potentially a strong approach to simulate unsteady flows around relative-moving bodies, by solving time-dependent governing …
-
Numerical simulations of the flow in the Francis-99 turbine
… in the turbine are analysed, and the main rotor-stator interaction frequencies are predicted correctly at all operating conditions. The main pressure oscillations occur at the frequencies which are multiples of the number of guide vanes and blades. Furthermore, the feasibility of …
Page 1 of 2