Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 12 of 12 for “"SOUTHWELL PLOT"”.
-
Techniques for measuring critical loads in the presence of non-negligible higher mode imperfections
<p>This thesis is concerned with the Southwell Plot method for measuring the critical load of thin-walled structural members whose postbuckling behavior is stable-symmetric.</p><p>In this method measurements are taken of the structure's central lateral deflection versus membrane compressive load P. …
-
Lateral stability of glulam arches
… of solution are given; iteration, determinant plot and Southwell plot. Experimental tests were carried out to check the validity of the theory. The results of the tests are presented and are shown to be satisfactory. A set of numerical results are given for a range of arches and load …
-
An experimental investigation of the bifurcation in twisted square plates
… with differing edge length/thickness ratios. A Southwell plot was used relating mean curvature to the ratio mean curvature/Gaussian curvature, from which the Gaussian curvature occurring at bifurcation was determined. The critical dimensionless twist ka was then calculated for each plate size. …
-
Bifurcation of a square plate twisted by corner forces
… point is determined by load-displacement plots. The critical value of Gaussian curvature at the centre of the plate is determined by the Southwell plot method. The critical value of Gaussian curvature is found to occur before the bifurcation point. Gaussian curvature is found to vary by an …
-
Stability analysis of a spaceframe structure
… the critical load are presented: determinant plot, Southwell plot, and load-deflection curves. The analysis is carried out for the plexiglass model of an actual conical spaceframe, made of glulam timber, and built for the storage of potash. The overall critical load for this structure is found …
-
Lateral stability of two-and three-hinged glulam arches
… iteration (eigen value problem) and determinant plot. This theoretical approach is verified by model tests with two- and three-hinged parabolic glulam arches in the laboratory. The method of solution for model test is the Southwell plot. The results of the tests are presented and are shown to be …
-
Experimental buckling criteria for thin pierced plates
… the inflection point criterion, and the Southwell plot method. The last was judged to be the most accurate and appropriate, and it was applied in studying the effects of the hole on the elastic buckling load. The critical load was found to be insensitive to hole size for both plain and …
-
Effect of the Initial Out-of-Straightness on the Lateral Torsional Buckling Strength of Steel Beams
… through examples. The load-deformation plots for beams with initial out-of-straightens as predicted by the formulations developed in the present study are then used to extend the Southwell plot technique, originally developed for buckling of column with initial out-of-straightness, to …
-
The structural properties of glassfibre reinforced plastics
… load experimentally, two methods were used. The Southwell plot method and electrical strain gauge method. The latter proved to be more reliable in predicting the buckling load than the former, especially for plates under uniaxial compression. Sample design charts for GRP plates that yield and …
-
Axial Compression Behavior of Unidirectional Carbon/Epoxy Tubes and Rods Before and After Impact
Compression tests were performed on damaged and undamaged rods and tubes made from unidirectional carbon/epoxy composite and lightweight core materials. Tested samples represent local members in an open, three-dimensional, composite lattice structure. Testing was performed in order to establish …
-
Stabilitní problémy prutů z vrstveného konstrukčního skla
Soudobá architektura se vyznačuje subtilními a transparentními konstrukcemi. Právě sklo umožňuje architektům realizovat jejich vize a představy. Sklo jako stavební materiál se stále častěji uplatňuje jako materiál primárních nosných konstrukcí. Vzhledem k absenci technických dokumentů upravujících …
-
A CONSISTENT APPROACH TO THE BUCKLING DESIGN ANALYSIS OF RIGID JOINTED STEEL-FRAMES SUBJECT TO SIDESWAY
ΣΕ ΠΟΛΛΕΣ ΔΙΑΔΙΚΑΣΙΕΣ ΠΟΥ ΑΦΟΡΟΥΝ ΤΗ ΜΕΛΕΤΗ ΤΟΥ ΛΥΓΙΣΜΟΥ ΣΕ ΠΛΑΙΣΙΩΤΙΚΕΣ ΚΑΤΑΣΚΕΥΕΣ, ΠΟΥ ΕΧΟΥΝ ΤΗ ΔΥΝΑΤΟΤΗΤΑ ΠΛΑΓΙΑΣ ΜΕΤΑΚΙΝΗΣΗΣ, ΟΙ ΜΗΧΑΝΙΚΟΙ ΠΑΡΑΚΙΝΟΥΝΤΑΙΝΑ ΠΡΑΓΜΑΤΟΠΟΙΟΥΝ ΜΙΑ ΚΑΤΑΣΤΑΣΗ, ΟΠΟΥ ΓΙΑ ΚΑΘΕ ΥΠΟΣΤΗΛΩΜΑ, ΘΕΩΡΟΥΜΕΝΟ ΣΑΝ ΜΕΡΟΣ ΤΟΥ ΠΛΑΙΣΙΟΥ, ΔΥΟ ΤΥΠΟΙ ΛΥΓΙΣΜΟΥ, Ο ΠΛΑΓΙΟΣ ΚΑΙ Ο ΜΗ ΠΛΑΓΙΟΣ ΝΑ …