Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 6 of 6 for “"Saw damage"”.
-
Impurity and defect mitigation for silicon photovoltaics
… that have been studied. </p> <p>Firstly, saw damage gettering which is designed to remove impurities from low quality silicon wafers which may have otherwise been discarded. Saw damage gettering removes impurities from the active region of the solar cell by capturing them in a surface …
-
Advanced Electron-Beam Techniques for Solar Cell Characterization
… to characterize the structural properties of saw-damage-induced defects and the non-destructive nature of SEAM could enable accurate optimization of saw-damage etch process duration. SEAM was also employed together with electron beam induced current (EBIC) to investigate defects in …
-
Nondestructive photoelastic characterization of monocrystalline silicon photovoltaic wafers
… and wafer handling stresses. Furthermore, a saw damage layer exists on the top and bottom surface of each wafer as a result of slicing the silicon ingot into wafers via a wire saw. Thinner wafers are more prone fracture under the combination of residual stress and external loads acting on …
-
The Design of Boron Epitaxial Emitter for IBC Solar Cells.
… thickness of raw substrate to be removed by saw damage removal and chemical polishing. The emitter is going to be applied to interdigitated back contact (IBC). The second purpose is to study the influence of thermal oxidation on emitter doping concentration profile. In the fabrication of bulk …
-
Experimental and theoretical evaluation of in-depth damage distribution in sawn silicon wafers
As-sawn silicon wafers have surface damage that needs to be removed before any further processing into solar cells. This damage distribution can vary with cutting parameters such as wire size, slurry particle/diamond grit size, and wire usage. To date, there is no simple way to measure the degree …
-
Plasma-based surface modification technologies for crystalline silicon photovoltaics
… if a flat rear surface is necessary, a polishing saw-damage removal followed by a plasma-texturing process on the front side could become an alternative for multicrystalline solar cells. With the multifunctional-layer approach a considerable cost benefit could be achieved due to the simple process …