Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 17 of 17 for “"Separation Location"”.

  1. Skin Friction and Cross-flow Separation on an Ellipsoidal Body During Constant Yaw Turns and a Pitch-up Maneuver with Roll Oscillation

    The skin friction and cross-flow separation location on a non-body-of-revolution (non-BOR) ellipsoidal model performing constant-yaw turns and a pitch-up maneuver, each with roll oscillation were studied for the first time. The detailed, low uncertainty, flow topology data provide an extensive …

    vt Repository record for Skin Friction and Cross-flow Separation on an Ellipsoidal Body During Constant Yaw Turns and a Pitch-up Maneuver with Roll Oscillation (opens in a new tab)

  2. Investigation of transonic flow separation phenomena on a two-dimensional airfoil

    … experimental study was made to investigate flow separation phenomena on airfoils at transonic speeds. The objective of the study was to determine the location and conditions under which local separation and fully separated flow will occur. A wind tunnel test was therefore conducted on a …

    ut-knoxville Repository record for Investigation of transonic flow separation phenomena on a two-dimensional airfoil (opens in a new tab)

  3. Optimal design of municipal and irrigation water distribution systems

    In two-dimensional flow, the point of flow separation from the surface coincides with the point at which the skin friction vanishes. However, in three-dimensional flow, the situation is much more complex and the flow separation is rarely associated with the vanishing of the wall shear stress except …

    vt Repository record for Optimal design of municipal and irrigation water distribution systems (opens in a new tab)

  4. Detailed Characterization of Turbulent Separated Flow Dynamics and Boundary Layer Evolution Over a Speed-Bump Geometry

    … frequency surface pressures to investigate the separation and reattachment dynamics. The source of low frequency unsteadiness has yet to be determined and is of great interest for aerospace structures. The upstream boundary layer dynamics were dominated by the pressure gradient when in the …

    washington Repository record for Detailed Characterization of Turbulent Separated Flow Dynamics and Boundary Layer Evolution Over a Speed-Bump Geometry (opens in a new tab)

  5. Laminar Near Wake of Hypersonic Blunt Bodies

    … are developed and presented for pressure minimum location, separation location, separation length, and viscous-inviscid interaction parameters. The dependence of these parameters on free-stream properties such as Mach and Reynolds number are highlighted. Viscous-inviscid interaction theories are …

    calgary Repository record for Laminar Near Wake of Hypersonic Blunt Bodies (opens in a new tab)

  6. Post-stall hysteresis and flow field unsteadiness on an NACA 0012 airfoil

    … with an advancing and retreating of the separation location across the surface.

    uiuc Repository record for Post-stall hysteresis and flow field unsteadiness on an NACA 0012 airfoil (opens in a new tab)

  7. Flow Control Over an Airfoil Using Synthetic Jet

    … frequencies of 0.4 Hz to 1.2 Hz while the jet location, jet angle, and jet width were fixed. The results showed that for both angles, the optimal amplitude and frequency were 4.0 and 0.8 Hz, respectively. As the amplitude increased, the lift-to-drag ratio went up, and the variance in frequency …

    ut-knoxville Repository record for Flow Control Over an Airfoil Using Synthetic Jet (opens in a new tab)

  8. Control of mean separation in a compression ramp shock boundary layer interaction using pulsed plasma jets

    … investigated for use in controlling the mean separation location induced by shock wave-boundary layer interaction. These synthetic jet actuators are driven by electro-thermal heating from an electrical discharge in a small cavity, which forces the gas in the cavity to exit through a small hole …

    texas Repository record for Control of mean separation in a compression ramp shock boundary layer interaction using pulsed plasma jets (opens in a new tab)

  9. Exploring the Structure and Dynamics of Shock/Turbulent Boundary Layer Interactions Generated by Swept Compression Ramps in a Mach 2 Freestream

    … effect the extent of subsonic flow has on the separation location. Two swept compression ramp cases are investigated at Mach 2 freestream conditions – a high sweep of 30 degrees and a low sweep of 10 degrees both having the same compression angle of 22.5 degrees in the vertical plane. Using a …

    ut-knoxville Repository record for Exploring the Structure and Dynamics of Shock/Turbulent Boundary Layer Interactions Generated by Swept Compression Ramps in a Mach 2 Freestream (opens in a new tab)

  10. Control of Low-Speed Turbulent Separated Flow Over a Backward-Facing Ramp

    … devices (LEBU’s) +a + a placed near the baseline separation location reduce flow separation and increase pressure recovery. Spanwise cylinders reduce flow separation but decrease pressure recovery downstream. Riblets, passive porous surfaces, swept grooves, Helmholtz resonators, and arches and …

    odu Repository record for Control of Low-Speed Turbulent Separated Flow Over a Backward-Facing Ramp (opens in a new tab)

  11. Investigation into noise emitted by bluff bodies with large roughness

    … and is thought to be caused by sharp edge separation. A bluff body roughness noise model has been developed based on the model of Howe and a Green's function tailored to the bluff body geometry, calculated using the Boundary Element Method. The application to rough circular cylinders using …

    soton Download PDF for Investigation into noise emitted by bluff bodies with large roughness (opens in a new tab)

  12. Flow Control of Airfoil at Post-Stall Conditions by Multiple Frequency Applied SAADO Jets

    Flow separation over lifting aerodynamic components, such as airfoils and wings, occurs during stall conditions which are caused by adverse changes (i.e.; high angle of attack, inflow conditions, etc.) in the operating conditions of aerodynamic components. During stall conditions, the flow over …

    odu Repository record for Flow Control of Airfoil at Post-Stall Conditions by Multiple Frequency Applied SAADO Jets (opens in a new tab)

  13. Characterizing the Wake and the Performance of a Marine Hydrokinetic Turbine in a Tandem Array Configuration

    … tests were performed for a fixed range of separation distances between each set of the devices. For each separation distance, a mechanical power extracted from the flow was measured. In addition, velocity profiles incident on the downstream turbine were measured at each separation location …

    bucknell Repository record for Characterizing the Wake and the Performance of a Marine Hydrokinetic Turbine in a Tandem Array Configuration (opens in a new tab)

  14. CFD Modeling of Separation and Transitional Flow in Low Pressure Turbine Blades at Low Reynolds Numbers

    … Reynolds numbers. In this regime, boundary layer separation may be more likely to occur in the turbine flow passages. For accurate CFD predictions of the flow, correct modeling of laminar-turbulent boundary layer transition is essential to capture the details of the flow. To investigate possible …

    vt Repository record for CFD Modeling of Separation and Transitional Flow in Low Pressure Turbine Blades at Low Reynolds Numbers (opens in a new tab)

  15. Computational Sensing and Closed-Loop Active Flow Control of Airfoil at Post-Stall Conditions

    Flow separation over lifting aerodynamic components, such as airfoils and wings, occurs during stall conditions which are caused by adverse changes (i.e. high angle of attack, inflow conditions, etc.) in the operating conditions of aerodynamic components. During stall conditions, the flow over …

    odu Repository record for Computational Sensing and Closed-Loop Active Flow Control of Airfoil at Post-Stall Conditions (opens in a new tab)

  16. An experimental study of flow over a 6 to 1 prolate spheroid at incidence

    In two-dimensional flow, the point of flow separation from the surface coincides with the point at which the skin friction vanishes. However, in three-dimensional flow, the situation is much more complex and the flow separation is rarely associated with the vanishing of the wall shear stress except …

    vt Repository record for An experimental study of flow over a 6 to 1 prolate spheroid at incidence (opens in a new tab)

  17. Effect of leading edge tubercles on airfoil performance.

    … measurements have indicated that the region of separation and reattachment for airfoils with tubercles is restricted to the trough between the tubercles rather than extending across the entire span. Hence, leading-edge separation is initiated at the troughs but occurs at a higher angle of attack …

    adelaide Repository record for Effect of leading edge tubercles on airfoil performance. (opens in a new tab)