Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 431 for “"Shear strain"”.
-
Wear, Friction and High Shear Strain Deformation of Metallic Glasses
… Pt57.5Cu14.7Ni5.3P22.5 (Pt-BMG) were compared. Shear band formation on the edges of the scratch groove with spallation was found to be the primary failure mechanism in progressive scratch tests. The wear behavior and the scratch response of model binary Ni-P metallic glasses was systematically …
-
Using Differential Shear Strain Measurements to Monitor Crosstie Support Conditions in Railroad Tracks
… crosstie support assessment and monitoring using strain gauges to measure differential rail shear strain in ballasted railroad tracks due to applied railcar wheel loads. These differential shear strain measurements can be related to applied wheel loading and crosstie support reactions through the …
-
Statistical Analysis of a Three-dimensional Axial Strain and Axial-shear Strain Elastography Algorithm
… Ultrasound elastography is a well-established strain estimation technique. Until recently, mainly 1D elastography algorithms have been developed. A few 2D algorithms have also been developed in the past. Both of these two types of technique ignore the tissue motion in the elevational direction, …
-
Measurements of the effective thermal conductivities of granular solids and oxide melts under shear strain by a new technique
… for water. For water with turbulent flow and at shear rates up to 0.55 sec⁻¹, the effective conductivity increased by a factor up to ~ 2.7 which is well short of the order of magnitude increase deemed desirable for heat transfer through the slag layer in the rotary scrap-melting furnace. For …
-
A micromechanical approach for predicting the complex shear modulus and accumulated shear strain of asphalt mixtures from binder and mastics
… to predict mastics' performance parameters - shear modulus (G*) and accumulated permanent shear strain (γacc) and then same properties for asphalt mixtures, in order to find a correlation between the three materials. Mastics were obtained by mixing the PG64-22 asphalt with three types of …
-
I, Crystallization and morphological studies of ICI's intermediate temperature semicrystalline (ITX) polymer and, II, The influence of deformation (shear strain) during bond formation on adhesive bond strength
… Dow DAF® 821 and Du Pont Surlyn® 1601. Lap shear bonds were sheared (// or ⟂ to load) during preparation to induce molecular orientation within the adhesive, before the mechanical properties were evaluated. The measured DAF 821 tensile strengths were similar, however, the Surlyn bond …
-
Pore Pressure Generation and Shear Modulus Degradation during Laminar Shear Box Testing with Prefabricated Vertical Drains
Liquefaction is a costly phenomenon where soil shear modulus degrades as the generation of excess pore pressures begins. One of the methods to mitigate liquefaction, is the use of prefabricated vertical drains. Prefabricated vertical drains provide a drainage path to effectively mitigate the …
-
Simplified Stress Analysis of Axisymmetric Solder Joint Under Thermal Loading
A strain model is developed based on the elastic beam theory to estimate the maximum shear strain in an array of solder joints in a uniform Ball Grid Array (BGA) electronic package subjected to a thermal loading. An assumption of parabolic variation for the cross-sectional area and second moment of …
-
Improvements in the pore-water pressure measurements and free-vibration decay with combined resonant column and torsional shear (RCTS) testing device
… resonant column (RC) and cyclic torsional shear (TS) device is employed to study the threshold shear strain of excess pore-water pressure, 𝛾 [superscript PP over subscript t], in uncemented granular soils. Reconstituted specimens of uncemented sand were constructed underwater and then …
-
Study of deformation-induced structures in a Zr-based bulk metallic glass via high energy x-ray diffraction
… (BMG). The study is divided into three parts: Strain evolution during in-situ compression, strain distribution maps in mechanically-imprinted BMG, and residual strain around a single shear band. 1. Strain evolution during in-situ compression The structural rearrangements occurring during …
-
Laboratory studies of till deformation with implications for Des Moines Lobe motion and sediment transport
… whether basal fills have experienced the high strains required of this model;To establish field criteria for identifying highly sheared till, a ring-shear device is used to study both clast-fabric development and mixing between lithologically-distinct till units as a function of shear strain. …
-
Textural and Physical Properties of Fat-Free Turkey-Beef Frankfurters: Effects of Non-Meat Ingredients and End-Point Temperature
… values (total energy and peak force) but higher shear stress and shear strain. In addition, higher salt levels resulted in lower cooking loss, moisture content, protein content, and darker frankfurters. Increasing AW level reduced (P<0.05) penetration values (total energy and peak force), shear …
-
Evaluation of One-Dimensional Seismic Site Response Analyses at Small to Large Strain Levels
… their variabilities to predict site response at shear stress levels approaching the shear strength of the soil have not been demonstrated. This study evaluates the performance of different soil models employed in each code to predict the nonlinearity behavior of soil over a wide range of strain …
-
Quantification of porosity, separated fluid-solid shear wave fields and coupling density with inversion recovery magnetic resonance elastography in porous phantoms and in vivo brain
… based on magnetic resonance imaging (MRI) and shear waves that depicts biomechanical properties of biological tissues. In MRE, quantitative parameter maps are usually reconstructed under the assumption of monophasic viscoelastic media. Conversely, the poroelastic model, consisting of a solid …
-
Elasto-Plastic Analysis of Column-Grid-Array Solder Joints
… of the columns and calculation of the maximum shear strain associated with this displacement. A simple equation to estimate the thermally-induced end displacement of a column within a CGA assembly is reviewed, which assumes the columns offer negligible resistance to thermal expansion of the …
-
Grain-scale Comminution and Alteration of Arkosic Rocks in the Damage Zone of the San Andreas Fault at SAFOD
… evidence of repeating episodes of compaction, shear, dilation, and cementation. The subsidiary faults are grouped into three size classes: 1) small faults, 1 to 2 mm thick, that record an early stage of fault development, 2) intermediate-size faults, 2 to 3 mm thick, that show cataclastic grain …
-
An investigation of droplet growth and phase separation in an oil and water emulsion under controlled shear and temperature conditions
… primarily using optical methods. The effects of shear strain and temperature on phase separation, droplet growth, and emulsion’s physical characteristics are reported. The Taylor Couette flow reactor is used to detect the onset of phase separation. Optical microscopy is used to confirm that the …
Page 1 of 22