Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 19 of 19 for “"Shear strength of soils--Testing."”.
-
Field measurements of the linear and nonlinear shear moduli of soils using drilled shafts as dynamic cylindrical sources
… for a generalized field method to evaluate the shear modulus of soils in the linear and nonlinear strain ranges was developed. The field set-up utilizes a cylindrical, axisymmetric source that, in this work, was simply a drilled shaft. The test procedure involves applying vertical dynamic loads …
-
The undrained behavior of saturated, dilatant silts
… solution from soil pore water are the cause of the erratic undrained behavior often observed in triaxial tests on saturated, dilatant silts. The literature indicates that ground water contains various amounts of dissolved gases and that gases dissolved in soil pore water will have sufficient …
-
Direct simple shear tests on overconsolidated Anderten clay
<p>Determining the shear strength behaviour of a very stiff calcareous clay in the Direct-Simple Shear tests is the purpose of this thesis. The clay tested is the MLK Arderten Clay from West Germany.</p><p>For the Direct-Simple Shear tests, a trimming device was prepared to get the required size of …
-
Influence of method of compaction on the structure and as-compacted strength of leda clay
The engineering behavior of compacted clay has been extensively investigated by many researchers. It is widely accepted that the composition and structure of compacted clays are among the fundamental factors influencing the engineering properties of clays. Moreover, the structure is strongly …
-
The effects of grain characteristics on the shear strength of cohesionless soils
Thesis (Ph. D.)--Michigan State University, 1985
-
The Anisotropic and isotropic strength behavior of an illitic clay
The cause and the nature of anisotropy in a cohesive soil was investigated by direct shear and triaxial compression tests. Laboratory techniques and procedures used to prepare isotropic clay samples are given where consolidation was accomplished under hydrostatic pressure. Direct shear tests were …
-
A model for predicting narrow tool behavior under dynamic conditions
… operations are performed at speeds in the range of 2-8 km/h, and experimental studies show that tool forces increase significantly with tool speed. This effort of developing a model for predicting the forces on narrow tools under dynamic conditions was carried out in three steps. First, a series …
-
Undrained Cyclic Loading of Low Plasticity Silty Soils in the Pacific Northwest Using Laboratory and Field Cyclic Shear Testing
The cyclic behavior of a fine-grained low plasticity silty soil (plasticity index of approximately 15) at a site in Portland, Oregon, is characterized using a field and laboratory cyclic shear test program. The field cyclic tests were performed using the NHERI@UTexas large mobile shakers T-Rex and …
-
Undrained Cyclic Shear Resistance of Low Plastic Silts
… may be susceptible to liquefaction or cyclic softening, as their plasticity indices ranges between non-plastic to low plasticity. While the majority of past studies have focused on liquefaction of sand and cyclic behavior of clays, there is not enough data on the cyclic response behavior of …
-
Methodology for calculating shear stress in a meandering channel
Shear stress in meandering channels is the key parameter to predict bank erosion and bend migration. A representative study reach of the Rio Grande River in central New Mexico has been modeled in the Hydraulics Laboratory at CSU. To determine the shear stress distribution in a meandering channel, …
-
Reconstruction, characterization, modeling and visualization of inherent and induced digital sand microstructures
Strain localization, the phenomenon of large shear deformation within thin zones of intensive shearing, commonly occurs both in-situ and in the laboratory tests on soils specimens. The intriguing mechanism of strain localization and how it will affect the general behavior of soil specimens have …
-
Geomaterial gradation influences on interface shear behavior
… and have served throughout human history as one of the basic materials for developing civilizations. In terms of human activity, the handling of particulate materials consumes approximately 10% of all the energy produced on earth. Advances in the study and understanding of particulate materials …
-
Stress-Strain-Strength Behavior of Florida Sands and Silty Sands
Understanding the mechanical response of granular materials is fundamental to geotechnical engineering design. The presence of fines significantly influences the stress-strain-strength behavior, particularly when the material response is controlled by fines content. In this study, Florida sands …
-
Strength Property Variability in Microbial Induced Calcite Precipitation Soils
… practices commonly used today and has a variety of potential applications. This research focuses primarily on its use as a soil stabilization technique using the bacteria Sporosarcina Pasteurii and a single injection point percolation method adapted from previous research in granular soils. This …