Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 16 of 16 for “"Shock-induced separation"”.
-
Numerical investigation of the wall temperature effects on shock-wave turbulent boundary layer interactions
The shock-wave turbulent boundary layer interaction (STBLI) is an important phenomenon in many practically relevant high-speed flow applications such as re-entry vehicles, air-breathing engines, rocket nozzles, etc. STBLI occurs in supersonic flow near solid surfaces where a shock wave is generated …
-
Hybrid RANS-LES modeling of high-speed shock turbulent boundary layer interactions
… RANS/LES studies of supersonic and hypersonic shock turbulent boundary layer interactions (STBLIs) are considered. The first simulation studies an attached hypersonic turbulent boundary layer at Mach $7.2$ and $Re_\theta \approx 3300$ through $8^{\circ}$ compression corner with cold walls …
-
CFD Analysis of a Slatted UH-60 Rotor in Hover
… higher thrust conditions. It was also found that shock induced separation near the blade tip was the limiting factor for the baseline UH-60 rotor in hover, causing an increase in rotor power and resulting in a reduction of figure of merit for the baseline rotor at higher thrust values. The shock …
-
Conditionally Analyzed Mean Velocity and Turbulence Measurements in a Plume-Induced Boundary Layer Separated Flowfield
The shock-induced separation process was found to dramatically increase the streamwise and transverse Reynolds normal stresses (which both peak near reattachment), the primary shear stress, and the normal stress anisotropy. The shock-separated shear layer consists of only a single layer with a …
-
Numerical Solution of the Euler and the Navier-Stokes Equations for a Compressible Flow Problem
… Mach numbers considered. A supersonic bubble, a separation bubble, and a shock induced separation were observed from the calculations of the flow properties in the flow field.
-
Stability and unsteadiness of transitional shock-wave/boundary-layer interactions in supersonic flows
… location on the interaction between an oblique shock-wave and a boundary-layer. A large set of direct and large eddy simulations are performed with an in-house high-order fully-parallelised finite difference compressible Navier-Stokes solver to study the inherent instability and unsteady …
-
High resolution algorithms for the Navier Stokes equations for generalized descretizations
… value problems, Ringleb’s flow, an inviscid shock reflection, a flat plate boundary layer, and a shock induced separation over a flat plate. Three dimensional results include the ONERA M6 wing. All of the unstructured grids were generated using an advancing front mesh generation procedure. …
-
Experimental studies of unstart dynamics in inlet/isolator configurations in a Mach 5 flow
… Unstart proceeds with the formation of a shock system that propagates upstream at an average velocity of about 37 m/s (in the lab frame of reference), which is five percent of the freestream velocity. Unstart is seen to be associated with strong shock-induced separation that leads to …
-
An experimental investigation of the use of air jet vortex generators to control shock induced boundary layer separation
… showed that their effectiveness in delaying shock induced boundary layer separation was not as good as conventional vane type generators. Recent low speed wind tunnel tests carried out at City University indicated that the strength of the vortex could be increased considerably by using …
-
Numerical prediction and characterization of shock-buffet in transport aircraft
… based simulations in the prediction of unsteady shock-buffet phenomenon. Three studies are conducted: a 2D validation study, a 3D validation study, and the pinnacle of this work which presents a novel shock-buffet prediction on an industrially-relevant aircraft confguration. Two dimensional …
-
IMPROVING JET ENGINE AERODYNAMIC DESIGN VIA NOVEL COMPONENT SHAPING AND ANALYSIS
… at different rotational speeds. The use of shock control bumps is found to be beneficial on transonic fan and compressor blades. It is shown that shock control can delay and reduce separation for a highly-loaded compressor blade, increasing its efficiency without the need for 3D deformations …
-
Three Problems Involving Compressible Flow with Large Bulk Viscosity and Non-Convex Equations of State
… we consider the reflection of an oblique shock from a laminar flat plate boundary layer. The flow is taken to be two-dimensional, steady, and the gas model is taken to be a perfect gas with constant Prandtl number. The plate is taken to be adiabatic. The full Navier-Stokes equations are …
-
Effect of Nozzle Pressure Ratio on Thrust and Flow Behavior in a Supersonic De Laval Nozzle
… pressure is lower than the ambient pressure, shock-induced separation may occur within the divergent section of the nozzle, potentially degrading nozzle performance. Understanding the aerodynamic behavior of nozzles operating under off-design conditions is therefore important for improving …
-
STREAmSML: A GPU-enabled platform for sensing, modeling and control of compressible turbulent flows
… such as supersonic turbulent boundary layers and shock boundarylayer interactions (SBLI) pose significant challenges for flow control due to strong compressibility effects, shock-induced separation, and nonlinear multiscale turbulence. At the same time, rapid advances in machine learning have …
-
Control of mean separation in a compression ramp shock boundary layer interaction using pulsed plasma jets
… investigated for use in controlling the mean separation location induced by shock wave-boundary layer interaction. These synthetic jet actuators are driven by electro-thermal heating from an electrical discharge in a small cavity, which forces the gas in the cavity to exit through a small hole …
-
Numerical and experimental investigation of VG flow control for a low-boom inlet
The application of vortex generators (VGs) for shock/boundary layer interaction flow control in a novel external compression, axisymmetric, low-boom concept inlet was studied using numerical and experimental methods. The low-boom inlet design features a zero-angle cowl and relaxed isentropic …