Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 20 of 33 for “"Signal generators"”.

  1. Compensation for Impairments of Frequency Converters in Millimeter Wave Vector Signal Generators

    … thereby limiting the achievable output signal quality and capacity. In this work, two signal generation architectures and the accompanying compensation schemes to mitigate the impairments are proposed for the generation of wideband modulated signals at mm-wave frequencies. The frequency …

    waterloo Repository record for Compensation for Impairments of Frequency Converters in Millimeter Wave Vector Signal Generators (opens in a new tab)

  2. Homogeneous and heterogeneous enzymeimmunoassays for the home detection of fertility : a thesis presented in partial fulfilment of the requirements of the degree of Doctor of Philosophy in Biochemistry at Massey University

    … One of the major difficulties in preparing a signal generator for use in home tests is the separation of the unconjugated enzyme material from the desired signal generators. In this thesis a new procedure was developed for the purification and isolation of the complex range of signal …

    massey Repository record for Homogeneous and heterogeneous enzymeimmunoassays for the home detection of fertility : a thesis presented in partial fulfilment of the requirements of the degree of Doctor of Philosophy in Biochemistry at Massey University (opens in a new tab)

  3. Understanding Quadrature Modulation by Designing a 7MHz IQ Test Bench to Encode the Polybius Square

    … techniques. Quadrature modulation utilizes two signals I and Q, 90° out of phase from each other, to greatly increase communication data rates. Using Desmos, a thorough mathematical analysis of waveform mixing is presented, and constellation diagrams are plotted from the results. From this an …

    portland-state Repository record for Understanding Quadrature Modulation by Designing a 7MHz IQ Test Bench to Encode the Polybius Square (opens in a new tab)

  4. Constrained-Random Stimuli Generation for Post-Silicon Validation

    … A method to design in-field programmable signal generators, which are placed on-chip, can directly expand compacted cubes to extensive random, yet functionally compliant, sequences for post-silicon validation. This approach is extended to also support sequential constraints, as well as the …

    mcmaster Repository record for Constrained-Random Stimuli Generation for Post-Silicon Validation (opens in a new tab)

  5. A digitally based pattern generator for an electron beam welder

    … have been created by the interaction of two signal generators. In an effort to suit a production environment, a more repeatable and accurate means of control than manual setting of test instruments was developed.</p><p>The heart of the system consists of seven pairs of low-cost programmable …

    ut-knoxville Repository record for A digitally based pattern generator for an electron beam welder (opens in a new tab)

  6. A chirped, pulsed laser system and magneto-optical trap for rubidium

    … and computer control for several arbitrary signal generators linked to drivers for acousto-optic and electro-optic modulators. This chirped, pulsed laser system will be used to perform state manipulations on the 85Rb MOT cloud using two-photon Raman transitions in an adiabatic rapid passage …

    soton Download PDF for A chirped, pulsed laser system and magneto-optical trap for rubidium (opens in a new tab)

  7. Wideband direct conversion IQ modulators in indium phosphide DHBT technology

    … across the full bandwidth of existing vector signal generators and also extend that bandwidth beyond the current state of the art. I employed a circuit architecture in which the limiting factor for modulator bandwidth was the device switching time, which enabled modulation across carrier …

    uiuc Repository record for Wideband direct conversion IQ modulators in indium phosphide DHBT technology (opens in a new tab)

  8. Integration and testing of a digital transceiver for a dual frequency, pulse-doppler radar

    … of the digital transceiver included laboratory signal generators, spectrum analyzers and oscilloscopes. The digital transceiver was able to function at pulse repetition rates exceeding 2 kHz, with a single transmit channel and three receive channels active. The lowpowered monostatic prototype …

    cape-town Repository record for Integration and testing of a digital transceiver for a dual frequency, pulse-doppler radar (opens in a new tab)

  9. A new overmodulation method based on a proportional reference signal generator

    Thesis (Ph. D.)--Michigan State University. Department of Electrical and Computer Engineering, 2000

    msu Repository record for A new overmodulation method based on a proportional reference signal generator (opens in a new tab)

  10. Development of a radiative transport based, fluorescence-enhanced, frequency-domain small animal imaging system

    … coupled device camera, an image intensifier, signal generators, and an optical switch. Time-dependent data were obtained in the frequency-domain using homodyne techniques on phantoms with 0.2% to 3% intralipid solutions. Through collaboration with Transpire, Inc., a fluorescence-enhanced, …

    tamu Repository record for Development of a radiative transport based, fluorescence-enhanced, frequency-domain small animal imaging system (opens in a new tab)

  11. Detection and suppression of common-mode noise in capacitive fingerprint sensors

    … are used properly for sampling the desired signal, it should be theoretically possible to filter out the common-mode noise. By utilizing signal generators, a multitude of different common-mode noise injections were emulated onto a fingerprint sensor. By applying different combinations of the …

    chalmers Repository record for Detection and suppression of common-mode noise in capacitive fingerprint sensors (opens in a new tab)

  12. Skeletal muscle pericytes as signal mediators in the vessel wall

    … with the hypothesis that pericytes could act as signal generators for hyperpolarization and vasodilatation in the vessel wall. The coupling with endothelial cells might relay an electric signal further along the vessel wall and lead to “EDHF mediated” dilations [48]. Interestingly in tissue …

    lmu-germany Repository record for Skeletal muscle pericytes as signal mediators in the vessel wall (opens in a new tab)

  13. A Fast Pixelated Thermal-Neutron Detector

    … out by the 8×8 pixel H12700A MAPMT. The pixel signal is strongly dependent on position and in general several pixels will register a signal (a hit) above a given threshold. To optimize planned detector operation at ESS, the number of pixels above set thresholds was investigated, with the …

    lund Repository record for A Fast Pixelated Thermal-Neutron Detector (opens in a new tab) Download PDF for A Fast Pixelated Thermal-Neutron Detector (opens in a new tab)

  14. High Frequency Generation from Carbon Nanotube Field Effect Transistors Used as Passive Mixers

    … harmonic mixer to convert high frequency signals to lower frequencies where they can be detected by a standard spectrum analyzer. By using this detection method, a new regime of high frequency CNT FET behavior is available for study. In this dissertation, we describe the design and …

    maryland Repository record for High Frequency Generation from Carbon Nanotube Field Effect Transistors Used as Passive Mixers (opens in a new tab)

  15. Drop-on-Demand Inkjet Drop Formation and Deposition

    … charge-coupled-device (CCD) camera, and signal generators, the imaging system based on flash photography was used to capture sharp images with a temporal resolution of 200 ns and a spatial resolution of 0.81 micron/pixel. First, the dynamics of DOD drop formation was studied …

    gatech Repository record for Drop-on-Demand Inkjet Drop Formation and Deposition (opens in a new tab)

  16. DESIGN OF A SECURE ELECTROMAGNETIC BUILDING

    … on the environment required for wireless signals that are present in the local surrounding area. For the purpose of designing a “smart” surface, classical passive Frequency Selective Surface (FSS) designs attenuating more than 60dB being very difficult, due to this poor filtering obtained …

    whiterose Download PDF for DESIGN OF A SECURE ELECTROMAGNETIC BUILDING (opens in a new tab)

  17. Low-Power RF Front-End Design for Wireless Body Area Networks

    … of the proposed RF front-end. Two quadrature signal generation techniques were proposed and implemented for generation of quadrature frequency sources. The two quadrature voltage controlled oscillators (QVCOs) were designed using our proposed current-reuse VCO with two damping resistors. A …

    vt Repository record for Low-Power RF Front-End Design for Wireless Body Area Networks (opens in a new tab)

  18. High Performance RF Circuit Design: High Temperature, Ultra-Low Phase Noise, and Low Complexity

    … transmitter design, ultra-low phase noise signal generators, and compact and low complexity polar transmitter design. Increase in the ambient temperature can impact the performance of the entire communication system. However, the RF hardware is main part of the system that is under the …

    vt Repository record for High Performance RF Circuit Design: High Temperature, Ultra-Low Phase Noise, and Low Complexity (opens in a new tab)

  19. Development of Signal Sources for Millimeter and Submillimeter Wave Output

    … in the area of millimeter and submillimeter wave signal generation and are directed into two paths that are separate, but related. The first involves the development of a W-Band oscillator using Raytheon's Metamorphic High Electron Mobility Transistor (MHEMT) substrate. The second involves the …

    gatech Repository record for Development of Signal Sources for Millimeter and Submillimeter Wave Output (opens in a new tab)

Page 1 of 2