Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 98 for “"Solids Loading"”.
-
The effect of particle size distribution on the rheology of ultrafine coal-water slurries
… it has been found that the maximum solids loading for ultrafine coal slurries ranges from 55 to 60 percent by weight as compared to 70 to 75 percent solids reported for coarser slurries. It was further shown that as particle size decreases there is an increase in slurry viscosity and …
-
Aerobic stabilization of waste activated sludge
… was investigated using a continuous-feed with solids-liquid separation and solids recycle flow scheme. A kinetic model to predict process performance was established which considered solids retention time and a coefficient representing the rate of sludge stabilization. Validity of this model …
-
Freeze Casting of Aqueous PAA-Stabilized Carbon Nanotube-Al2O3 Suspensions
… The dispersant, dispersant amount, pH and solids loading were examined to determine the best conditions for freeze casting. Based on adsorption and viscosity data, optimal conditions for freeze casting were found with Poly(acrylic acid) (PAA) dispersant, at 2.00 wt% (of Al2O3), pH of 9.5, …
-
Fabrication of porous ceramics and composites by a novel freeze casting process
… of freeze casting. Basic factors such as initial solids loading, cooling rate, and sintering temperature that would affect the final morphologies and the effect of additives have been studied. Porous alumina ceramics with lamellar microstructure exhibited compressive strengths up to 123 MPa for …
-
Reducing the Dosage of Cellulose Deconstructing Enzymes through Fed-Batch, Simultaneous Saccharification and Fermentation in Submerged Versus Solid State Bioreactor
… enzyme dosages of 33, 67, 100, and 133% at 14% solids loading. Ethanol titer and productivity were similar for trials with 67% or higher of the normal enzyme dosage, while 33% enzyme dosage was much lower. Subsequent trials evaluated fedbatch SSF in the submerged bioreactor using S. cerevisiae, …
-
Seasonal influent characterization, model calibration, SRT and energy usage for nitrogen removal at a full scale wastewater plant
… difference in terms of nitrate removal capacity. Solids Residence Time (SRT) is a very important operational parameter in a full-scale system and directly influences the effluent quality. Higher SRTs are associated with high bioreactor biomass concentrations, which can provide improved effluent …
-
A Comparison of Microstructure and Uniaxial Compressive Response of Ice-Templated Porous Alumina Scaffolds Fabricated from Two Different Particle Sizes
… sintered alumina scaffolds as a function of solids loading and freezing front velocity (FFV). For comparable solids loading and FFV, particle size effects on the microstructure of the scaffolds are observed to be significant. Moreover, transition of the pore morphology with the increasing …
-
Integrated biological processes for conversion of AFEX(TM) pretreated biomass to ethanol
… in the biochemical route include the high enzyme loadings needed, long enzymatic hydrolysis time, slow xylose fermentation and low ethanol productivity, which result in a high production cost. Ammonia Fiber Expansion (AFEXTM) is a leading alkaline pretreatment. It provides a biomass substrate with …
-
CHANGES IN POPLAR DIGESTIBILITY DUE TO OVEREXPRESSION OF LACCASE GENES
… content. Alkaline pretreatment was carried at 3% solids loading and 10mL of 62.5 mM NaOH to make biomass more accessible to enzymatic hydrolysis. The samples were washed three times and dried overnight to determine the pretreatment mass loss. The pretreatment liquor was evaluated for glucose and …
-
Particle structure and pulp chemistry in aqueous processing of muscovite clay minerals
… aqueous media as a function of pH, temperature, solids loading, ionic strength and leaching time. Various characterisation techniques, including solid and solution nuclear magnetic resonance spectroscopy and X-ray photoelectron spectroscopy, were used to probe reaction-induced physicochemical …
-
Utilization of a combined activated sludge fixed film media system for treatment of a high strength, high ammonia, industrial wastewater
… may be maintained with little or no increase in solids loading to the clarifier. The ideal combined system can treat higher organic and ammonia loadings than a conventional system, and is more resistant to temperature changes and shock loadings. Overloaded plants can be outfitted with media as an …
-
The influence of enzymatic liquefaction and slurry rheology on high-solids cellulose hydrolysis
… bioproducts would benefit significantly if high solids concentrations (low water-to-biomass ratios) could be processed effectively. However, the fibrous nature of lignocellulosic biomass makes effective reaction mixing difficult, resulting in mass transfer limitations that reduce process yields. …
-
The design and testing of a short HRT attached growth pre-fermenter system: SCVFA production by two media types and two feed sources
… chemical oxygen demand (sCOD) and suspended solids analysis. Turbidity analysis was attempted but was not continued for the duration of the research. Metabolic fingerprinting, using the BIOLOG plate assay, provided a snapshot of the biofilm's grouped microbial metabolic activities present at …
-
Simulation of agricultural air seeding systems using the discrete element method and computational fluid dynamics
… for the horizontal distributor tube showed that solids loading ratios between 0.5 and 3.0 did not have a significant effect on average seed velocity. The horizontal and horizontal-vertical tubing simulations generated average seed velocity data and flow patterns that corresponded well with values …
-
Variations of alkalinity, pH, oxidation reduction potential, and conductivity in single and multi-stage sludge digestion systems
… and ORP in relations to the COD and Solids (Volatile Solids) loading of both Single and Multi-Stage systems. From the results, the following remarks can be made:</p><p>-In terms of COD and Solids Loading the superiority of Multi-Stage over the Single Stage system was clearly …
-
Polymer-Particle Composite Material Failure Characterization in Quasistatic Compression and Dynamic Impact Regimes
This work focuses on high solids loading (≥80% weight) polymer-particle composites, a specific subset of heterogeneous materials where particles are suspended in a polymer matrix. These composites exhibit complex behaviors in mechanical environments including viscoelasticity, pressure dependent …
-
MICROSCOPIC AND LABORATORY SCALE CHARACTERIZATION METHODS TO EVALUATE BIOMASS DECONSTRUCTION
… enzymatic hydrolysis method at high-solids loading to study the impact of drought and extreme weather conditions on biomass deconstruction. At the laboratory scale, high solids loading results in improper mixing and low saccharification due to low water availability. This was overcome …
-
Electrophoresis of TiO2 Films
… high-quality TiO2 coatings. Sedimentation tests (solids loading, pH, and concentration of deflocculant) were done to assess optimal EPD parameters. EPD was done using Ti foil substrates as cathode and anode, using variable parameters: Voltage, deposition time, electrode distance, substrate …
-
Study of Freeze-Cast Porous Silica Nanoparticle-Based Composites
… effect depends on composition and initial solids loading. After sintering at 1250 °C for 1 h, a ceramic containing 10 vol% kaolinite and 8 vol% silica has a maximum strength while maintaining a ~69% porosity. The kaolinite-silica composites with lower solids loading exhibit faster sintering …
-
Regeneration of ammonia from ash produced in a flue gas desulfurization process involving Ca(OH)²/NH³ injection
… process (i.e. pH, temperature, solids loading, and gassing flow rate) are investigated through experimentation using the laboratory scale reactor. The ammonia regeneration process is also modeled using material balance equations for each of the three phases: solid ash, aqueous, …
Page 1 of 5