Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 137 for “"Solids retention time"”.
-
Effect of Solids Retention Time on Activated Sludge Properties and Effluent Quality
The effect of solids retention time (SRT) or sludge age on activated sludge properties and effluent quality was investigated using laboratory scale reactors. It was found that an increase in SRT resulted in an increase in effluent solution polysaccharide, with the < 3,000 daltons (3K) size fraction …
-
The Effects of Temperature and Solids Retention Time on Activated Sludge Treatment Performance
… clarifier was used to determine the effects of solids retention time (SRT) and temperature on treatment performance while simulating the full scale activated sludge process. Four bench-scale reactors, operating at SRTs of 20, 10, 5 and 2 days, were fed settled municipal wastewater collected …
-
Solids retention time-dependent phototrophic growth and microbial population dynamics in wastewater treatment
… polishing and treatment. Specially, because solids retention time (SRT) is a key design and operational parameter in bioreactor operation, the research determined the effect of SRT (equal to hydraulic retention time or HRT) on phototrophic growth, bioreactor performance and microbial …
-
Effect of Solids Retention Time on the Denitrification Potential of Anaerobically Digested Swine Waste
… reactors were used to test the effect of solid retention time (SRT) on CH4 yield, total ammonia nitrogen (TAN) concentrations, % volatile solids (VS), chemical oxygen demand (COD) and volatile fatty acids (VFA) removal, readily biodegradable COD concentration and the denitrification potential …
-
The Effects of Dissolved Oxygen Concentration and Biological Solids Retention Time on Activated Sludge Treatment Performance
… the effects of DO concentration and biological solids retention time (BSRT) on treatment performance using the activated sludge process. The four reactors, operating at BSRTs of 20, 10, 5, and 2 days, were fed settled municipal wastewater collected from the Kuwahee wastewater treatment plant in …
-
Effects of Solids Retention Time and Feeding Frequency on Performance and Pathogen Fate in Semi-continuous Mesophilic Anaerobic Digesters
… as energy (methane gas) and a soil amendment (biosolids). Small-scale, or household, semi-continuous anaerobic digesters have been used in developed and developing countries for many decades to produce biogas from human and livestock waste, which is used for heating, lighting, and cooking. This …
-
An evaluation of biological solids retention time on the biosorption of uranium by municipal wastewater treatment plant mixed liquor suspended solids
… uranium accumulation on mixed liquor suspended solids (MLSS) and to determine biological treatability parameters in an activated sludge wastewater treatment environment. In order to evaluate the impact of MLSS composition on uranium uptake, preliminary batch experiments were performed using MLSS …
-
The effect of ammonial loading, solids retention time and operating temperature on the biological nitrification and denitrification of high ammonia landfill leachate
The effect of ammonia loading, solids retention time and operating temperature (20, 17, 14, 12 and 10 °C) on the treatment of high ammonia landfill leachate (200, 300, 600, 1000, 1500 and 2000 mg NH4-N/L), was investigated. Two biological, single-sludge, nitrification-predenitrification systems …
-
Enhanced Biological Phosphorus Removal for Liquid Dairy Manure
… (ii) effects of dissolved oxygen and solids retention time on the efficiency of EBPR, and (iii) effectiveness of gravity thickening for reducing the volume of harvested EBPR aerated mixed liquor. Two pilot-scale EBPR systems were used in this study. The ratio of the manure chemical …
-
Aerobic stabilization of waste activated sludge
… was investigated using a continuous-feed with solids-liquid separation and solids recycle flow scheme. A kinetic model to predict process performance was established which considered solids retention time and a coefficient representing the rate of sludge stabilization. Validity of this model …
-
BIOAUGMENTATION OF ANAEROBIC DIGESTION WITH A COMMERCIAL BIOCATALYTIC ADDITION
… 0, 5000 and 10000 mg/l, under steady states at solids retention time of 20 days. The biocatalytic addition also did not give any improvement at varying levels of biocatalyst dosage. The solids retention time was then 10 days and the free fatty acids content was 10000 mg/I. It was concluded that …
-
A respirometric investigation of the activated sludge treatment of BKME during steady state and transient operating conditions
… activated sludge bioreactors. The effects of the solids retention time (SRT) and the presence of an aerobic selector on the activated sludge treatment of BKME during steady state and transient operating conditions were investigated. Respirometric methods for the study of activated sludge kinetics …
-
Operation of an activated sludge plant for fellmongery wastewater treatment : a thesis submitted in partial fulfilment of the requirements of the degree of Master of Technology in Environmental Engineering at Massey University, Palmerston North, New Zealand
… by high total and volatile suspended solids concentrations, and high organic nitrogen concentrations. The plant was experiencing frequent problems that were attributed to the high influent suspended solids load coupled with ineffective solids management. Operation of bench-scale …
-
Exocellular Polymeric Substances, Bioflocculation and Sludge Settling Properties in a Combined Anaerobic/Activated Sludge Process
… (fully aerobic system) revealed that the minimum solids contact chamber hydraulic residence (HRT) time in which bioflocculation occurs satisfactorily (effluent SS concentrations < 20 mg/L) is 15 min; however, in the combined anaerobic/aerobic system HRT< 100 minutes resulted in poor floc settling …
-
Membrane Fouling Characterisation in Aerobic Submerged Membrane Bioreactors
… were analysed under different operating flux, solids retention time (SRT) and membrane material. Micro-structural analyses of the foulants on the membrane surfaces showed that dominant foulants were different under different flux conditions. Membrane fouling occurred through a biofilm dominated …
-
Fabrication of TIO₂-embedded PVDF membranes and their application in algae membrane bioreactor systems
… fed with artificial wastewater at a target solids retention time (SRT) of 25 days. Under steady-state conditions, the MBR systems had an average algae biomass concentration of 2350 mg/L (COD unit) with simultaneous removal of about 78% of phosphorus and 34% of nitrogen form wastewater. The …
-
MODELING THE TRANSFER AND TRANSFORMATION OF PERFLUOROOCTANESULFONIC ACID (PFOS) AND PRECURSOR COMPOUNDS DURING WASTEWATER TREATMENT VIA THE BIOWIN 6.0 PLATFORM
… on the production of wastewater treatment solids and the concentrations of these PFAS in the biosolids were analyzed and are summarized in this report. Modeling results concluded that the concentration PFOS in sludge is dependent on the operational decisions, such as solids production, …
-
Evaluation and modeling of a membrane activated sludge system
… of operating conditions ranging 1 to 15 day(s) solids retention time (SRT) and 4 to 12 hours hydraulic retention time (HRT). Although the membrane reactor was able to provide good to excellent separation of particulates from the liquid in the mixed liquor over these operating conditions, the …
-
Model of anoxic-aerobic wastewater treatment at Phoenix 91st Avenue Plant.
… operating parameters which include the effect of Solids Retention Time (SRT), the internal recycle flow rate and distribution, and aeration tank DO concentrations. Two models were developed for comparison. The first model was based on Michaelis-Menton kinetics. The second model was a modified …
Page 1 of 7