Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 27 for “"Source follower"”.
-
Dark Current RTS-Noise in Silicon Image Sensors
… Telegraph Signal (RTS) noise is a random noise source defined by discrete and metastable changes in the magnitude of a signal. Though observed in a variety of physical processes, RTS is of particular interest to image sensor fabrication where progress in the suppression of other noise sources …
-
Adaptive Analog VLSI Signal Processing and Neural Networks
… exhibited by the learning rule. We introduced a source-follower floating-gate synapse as an improvement over our earlier source-degenerated floating-gate synapse in terms of relative weight decay cite{kn:Dugger2004}. A larger network of source-follower floating-gate synapses was fabricated and an …
-
A study of two wideband CMOS LC-VCO structures
… (Design A) uses two VCO cores and has an extra source-follower buffer while the other (Design B) uses one VCO core with a bank of switched capacitors. The 90-nm CMOS prototypes operate from a supply of 1.2 V. The Design A prototype has a 28.20% tuning range and a phase noise of ‒90.98 dBc/Hz at …
-
Design and Automatic Calibration of Analog Filters for VLSI Applications
… work presents a tunable bandstop filter based on source follower. The filter is designed using a source follower architecture with partial positive feedback and feed-forward paths using a 0.18µm CMOS technology. The filter consumes about 1.4 mW from a 1.8V power supply, and it is designed to have …
-
Hybrid Photonic–Electronic Neuromorphic Integrated Circuits
… ferroelectric field-effect transistor (FeFET), a source-follower buffer, and a silicon PIN microring modulator. The FeFET stores the memory state electronically through a retained threshold-voltage shift after program and erase pulses. The stored FeFET state is then read as an electrical response, …
-
A GaAs cermet gate charge-coupled device
… A GaAs CMCCD with an on-chip GaAs MESFET source follower amplifier has been produced using a six mask level fabrication procedure. The CMCCD and the output source follower amplifier are demonstrated to operate at 100 MHz. Charge transfer efficiencies of 1.00 and 0.998 for 100 MHz operation …
-
Design and characterization of integrating silicon junction field-effect transistor amplifiers for operation in the temperature range 40-77 K.
… 77 K and measurements revealed that a balanced source follower or a common-source amplifier with active load can operate well down to 38 Kelvin with extremely low power dissipation. The open gate equivalent input noise voltage was found to be optimum below 77 K, due to a decrease in the gate …
-
Design of a low power switched-capacitor pipeline analog-to-digital converter
… are proposed. First, a high speed switched source follower (SSF) sample and hold amplifier without feedthrough penalty is implemented and simulated. The SSF sample and hold amplifier can achieve 6 Bit resolution with sampling rate at 10Gs/s.Second, a novel rail-to-rail time domain comparator …
-
Design techniques for high intermediate frequency bandpass (sigma/delta) modulator.
… Radio applications. Proposed OTA uses super source follower input stage to enhance its voltage-to-current conversion linearity. The design has been simulated using TSMC 0.18 μm CMOS process. The OTA has small signal transconductance of 0.9 mA/V, IM3 below -79 dB (for 0.3 Vpp input), …
-
Critical design issues for gallium arsenide VLSI circuits.
… and proposing an alternative gate, namely the Source Follower DCFL (SDCFL), to improve the noise margin and speed. Suggesting various buffering schemes to maintain high speed in areas where the fanout loading is high (eg. clock drivers). Comparing various adder types in terms of delay-power and …
-
Improved Gain Stability of a Digital Imager Using a Charge Feedback Amplifier
… output amplifier structures: the traditional source follower (SF) and the charge feedback amplifier (CFA). In studies of other solid state detectors, the CFA has shown a greater stability against variations in certain system parameters and environmental conditions such as operating …
-
An Active Quasi-Circulator IC and Technique for 1-255 MHz Resonance-Based Spectroscopic Impedance Plethysmography
… MHz. In addition to the AQC, the IC features a source-follower DAC, excitation signal generation, and frequency downconversion. Electrical and human test results demonstrate, for the first time, spectroscopic plethysmography for resonance-based measurements, thus laying the groundwork for future …
-
Design of Adaptive Amplifiers with DC Varying Inputs
… four cascading stages, i.e., three simple common source amplifier stages and one source follower. The units are tuned to perform a nonlinear voltage transfer while keeping a local linearity. These units are combined to implement the characteristics needed for the signal enhancement. The circuit …
-
A Highly-Sensitive Global-Shutter CMOS Image Sensor with On-Chip Memory For Hundreds of Kilo-Frames Per Second Scientific Experiments
… switch. The 4T back-end circuitry consists of a source follower, in-pixel current source and 2 switches. The pixel design is unique because of the following. In a relatively small area, 15.1um x 15.1um, it performs CDS that limits the noise stored in the pixel memories to less than 0.33mV rms and …
-
CMOS/Bipolar current conveyor design and development
… Supply Rejection Ration (PSRR) of the current follower (mirror) by increasing its output impedance. Several types of current mirror were compared using analytical and simulation methods, using a new generic low frequency transistor model which was used to highlight the differences in impedance …
-
Low-power amplifiers for space application
… (common-emitter, common-base, common-source, common-gate, emitter-follower, and source-follower) are evaluated for integral nonlinearity. The results of this analysis are used to predict the integral nonlinearity of three of the four amplifiers studied. In two of these three cases, the …
-
CMOS Contact Imagers for Spectrally-multiplexed Fluorescence DNA Biosensing
… ADCs is presented. By eliminating the in-pixel source follower, power consumption is reduced, compared to the conventional active pixel sensor. A 64×64 prototype with a 10μm pixel pitch has been fabricated in a 0.35μm standard CMOS technology and validated experimentally. Fourth, a …
-
Feasibility study of silicon pixel detector
… non-uniformity of the threshold voltage of the source follower transistor in the pixel. Our study shows that monolithic silicon pixel detector is feasible to be built in the custom twin-tub CMOS fabrication process. This is good because a well-established fabrication process already exists. Our …
-
Integrating logarithmic wide dynamic range CMOS image sensors
… response, the pixel non-ideal effects such as source follower gain, body effect and subthreshold effect are characterised and included as an improved model to the reference voltage.</p> <p>Measurement results from fabricated chips using UMC 180 nm technology are presented and analysed. A …
-
Laser Driver Design in 0.18 um CMOS Technology
… consists of a cascode differential pair with a source follower voltage buffer, while stage two consists of a shunt inductively peaked differential pair using active inductors. A differential pair composed of large transistors is used in an open drain configuration for the output stage. …
Page 1 of 2