Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 20 of 103 for “"Stability limit"”.

  1. The enhanced binary single machine equivalent method for transient stability limit searching

    … systematic approach to search for the transient stability limits (TSLs) of multi-machine power systems. The algorithm is an extension of the SIME method [1] and provides an approach to estimate a transient stability margin for a given scenario – where the system operating conditions and a …

    adelaide Repository record for The enhanced binary single machine equivalent method for transient stability limit searching (opens in a new tab)

  2. ADVANCEMENTS IN THE CHARACTERIZATION OF STABILITY LIMIT STATES FOR STEEL I-SECTION MEMBERS SUBJECTED TO FLEXURE

    … the cross section occurs prior to the strength limit. This region is represented by a linear interpolation between anchor points corresponding to the elastic buckling and the plateau strengths. Proper determination of the anchor points at the transition between the plateau and the inelastic …

    gatech Repository record for ADVANCEMENTS IN THE CHARACTERIZATION OF STABILITY LIMIT STATES FOR STEEL I-SECTION MEMBERS SUBJECTED TO FLEXURE (opens in a new tab)

  3. Quantifying the Effect of Air Conditioning Dynamics on Power System Stability Limits

    … variations directly to changes in assessed stability limits. This connection is first considered at an area-wide level, before a bus-level locational sensitivity metric is introduced. Stability limits are assessed using PowerWorld for power flow and dynamic simulations with differing dynamic …

    tamu Repository record for Quantifying the Effect of Air Conditioning Dynamics on Power System Stability Limits (opens in a new tab)

  4. The ADI-FDTD Method for High Accuracy Electrophysics Applications

    … FDTD method is explicit, its time-step size is limited by the well-known Courant-Friedrich-Levy (CFL) stability limit. The CFL stability limit can render the simulation inefficient for very fine structures. The Alternating Direction Implicit FDTD (ADI-FDTD) method has been introduced as an …

    maryland Repository record for The ADI-FDTD Method for High Accuracy Electrophysics Applications (opens in a new tab)

  5. Sensitivity analysis of the transient energy function method

    … has been achieved in power system transient stability assessment using the transient energy function (TEF) method. Due to the continued development and enhancement, the TEF method now provides accurate and reliable stability assessment;An inherent advantage of the TEF method is the …

    iastate Repository record for Sensitivity analysis of the transient energy function method (opens in a new tab)

  6. Energy Margin Calculation by the Relevant Fault-on Trajectory Method

    … simulation technique for power system transient stability analysis can be greatly enhanced if it can indicate the degree of stability by producing a stability index. Often referred to as Energy Margin, the stability index offers additional insight into the transient stability problem being …

    mcmaster Repository record for Energy Margin Calculation by the Relevant Fault-on Trajectory Method (opens in a new tab)

  7. Compressive Response of Tapered Curved Composite Plates

    … based on the non-linear analysis in which the stability limit load is calculated from the non-linear load-deflection curve. In the present thesis, a simplified methodology is developed to predict the stability limit load that requires the consideration of only two load steps. The stability …

    concordia Download PDF for Compressive Response of Tapered Curved Composite Plates (opens in a new tab)

  8. Design and model: Intelligent solid-state current limiter to prevent sympathetic tripping problem on power and energy applications

    … that transferring power near the system voltage stability limit is a major cause of the Sympathetic Tripping Problem. Limiting fault current and using synchronous condensers for reactive power support were shown to solve the Sympathetic Tripping Problem.

    ttu Repository record for Design and model: Intelligent solid-state current limiter to prevent sympathetic tripping problem on power and energy applications (opens in a new tab)

  9. An analysis of the influence of some external disturbances on the aerodynamic stability of turbine engine axial flow fans and compressors

    … disturbances on turbine engine compressor stability; and, in so doing, to gain added physical insight into the destabilizing processes. The objectives were accomplished through the development of a one-dimensional, time-dependent mathematical compressor model for analysis of planar …

    utk-theses Repository record for An analysis of the influence of some external disturbances on the aerodynamic stability of turbine engine axial flow fans and compressors (opens in a new tab)

  10. Processing, microstructural evolution and electrochemical performance relationships in solid oxide fuel cells

    … and surface adsorption-diffusion of oxygen) limit performance. Optimization of microstructures resulted in total resistances as low as 0.040 Ohm cm². Studies on Ag composites revealed that incorporation of up to 25 vol% oxide particles (LSM and YSZ) with sizes comparable to the Ag grains …

    must-thes Repository record for Processing, microstructural evolution and electrochemical performance relationships in solid oxide fuel cells (opens in a new tab)

  11. SERIES COMPENSATED TRANSMISSION LIVES

    … the line voltage profiles within reasonable limits. Using a line voltage tolerance of ± 5 percent it was found that the steady state limit was dictated by this constraint rather than by the displacement angle between the voltages behind the synchronous reactances of the two equivalent …

    sask Repository record for SERIES COMPENSATED TRANSMISSION LIVES (opens in a new tab)

  12. Accurate solutions of elastic and acoustic waves propagation problems by the linear elements with reduced dispersion

    … at small time increments; i.e., smaller than the stability limit, in the 2-D and 3-D cases for elastodynamics problems. For the 2-D acoustic wave propagation problems, the most accurate results can be obtained with time increments close to the stability limit. Numerical solutions of wave …

    ttu Repository record for Accurate solutions of elastic and acoustic waves propagation problems by the linear elements with reduced dispersion (opens in a new tab)

  13. Investigation of the effects of preheating on the characteristics of micro combustion

    … for micro combustors to achieve wide flame stability, high combustion efficiency and clean combustion with low pressure loss, due to the associated downscaling problems, such as high heat loss ratio and small residence time. In order to overcome the issues associated with smaller residence …

    auckland-ms Repository record for Investigation of the effects of preheating on the characteristics of micro combustion (opens in a new tab)

  14. Fluid Release During Eclogite Formation, North Qaidam Terrane, Western China

    … increase as the P-T path crosses the terminal stability boundary of hydrous minerals. Fluid release rates spike at ~560 kg/m<sup>3</sup>/Myr at the stability limit of amphibole and ~510 kg/m<sup>3</sup>/Myr at the stability limit of lawsonite. Such spikes in fluid release rates are interpreted …

    central-wash Repository record for Fluid Release During Eclogite Formation, North Qaidam Terrane, Western China (opens in a new tab)

  15. Swarm Behavior to Mitigate Rebound in Air Conditioning Demand Response Events

    … DR events, as well as the negative effects, a stability and resilience analysis were performed on multiple populations and verified with agent based modeling simulations. At the core of this study is an added thermostat criterion created from the combination of a proportional gain and the …

    boise Repository record for Swarm Behavior to Mitigate Rebound in Air Conditioning Demand Response Events (opens in a new tab)

  16. A Mechanistic Force Model and Stability Analysis for Contour Turning

    The stability variations in axial contour turning are investigated via a frequency domain analysis. Three-dimensional stability-limit diagrams, third dimension being the toolpath, are generated for machining a workpiece with concave-convex contours. The reasons for the stability variations along …

    uiuc Repository record for A Mechanistic Force Model and Stability Analysis for Contour Turning (opens in a new tab)

  17. Lattice instability in supersaturated solid solutions

    … to solve guest atoms over the thermodynamical stability limit. The guest atoms are point defects, which amount can be varied by changing the concentration. The increasing amount of point defects makes the lattice unstable against schare, which may ends up in an order-disorder transition. In …

    qucosa-diss

  18. Real-time Aeroelastic Hybrid Simulation for a Base-pivoting Model Building in a Wind Tunnel

    … (SDOF) RTAHS system, analyzing its stability, implementing a 2-DOF RTAHS system, and examining the effects of stiffness non-linearity on a model building. This study assesses the stability limit of the RTAHS system, considering mass ratio, actuator delay and the interaction between …

    toronto-retro Repository record for Real-time Aeroelastic Hybrid Simulation for a Base-pivoting Model Building in a Wind Tunnel (opens in a new tab)

  19. Compressor stability management

    … and are thus undesirable. In order to prevent stability problems, a passive technique, involving fuel flow scheduling, is currently employed on gas turbines. The passive nature of this technique necessitates conservative stability margins, compromising performance and/or efficiency. In the …

    gatech Repository record for Compressor stability management (opens in a new tab)

Page 1 of 6