Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 10 of 10 for “"Stall cells"”.
-
Effect of inlet strut length on the stalling characteristics of an axial-flow compressor
… for their effect on the inlet flow field and stalling characteristics of the compressor under clean and distorted inlet conditions. Data were obtained from one stationary and six blade-mounted high-response pressure transducers, and from a circumferentially- traversed directional probe. The …
-
Experimental and computational study of three-dimensional separation and its control using passive vortex generators
… the issue of three-dimensional separation of the Stall Cell type on rectangular unswept wings and also the control of Stall Cells using passive vortex generators. The problem was approached experimentally and computationally. Flow visualization tests, pressure measurements and Stereo Particle …
-
Development of a Pulse Modulator for Active Flow Control in Turbomachinery
… operation is often plagued by rotating stall and surge. Rotating stall and surge can result in loss of engine performance, rapid heating of the blades, and severe mechanical stresses. Traditional methods for suppressing rotating stall and surge only partially protect against rotating …
-
Analysis of the Effects of Inlet Distortion on Stall Cell Formation in a Transonic Compressor Using CREATE-AV Kestrel
… to capture and analyze the processes leading to stall inception for both uniform and distorted inlet conditions. The distortion profile used contains a 90 degree sector of lower total pressure at the inlet. The observed fan behavior at stall inception is compared to previous research, and it is …
-
An experimental study of exit flow patterns in a multistage compressor in rotating stall
… axial-flow compressor operating in rotating stall are analyzed. Procedures used to digitize analog voltages and calibrate pressure transducers are presented. From total and static pressures measured at the exit of the test compressor, stall cell Mach number distributions are calculated and …
-
Exploration of stall dynamics on a high-speed CRM wing
… Washington. The tufts showed a leading edge–tip stall at every tested condition, with separation delayed to higher angles of attack at higher Reynolds numbers (Re). Approximate Reynolds number independence was observed for Rec > 10^6, based on the mean aerodynamic chord. The separation point …
-
Time-resolved measurements of a transonic compressor during surge and rotating stall
… (about 20:1), good efficiency and sufficient stall margin. The rotor was tested without the presence of a stator (or any of the following seven stages) at the NASA Lewis single-stage, high-speed, core-compressor test-rig. The measurements were obtained with a single circumferential, …
-
Physics based modeling of axial compressor stall
… rates by fluid dynamic instabilities such as stall and surge. These instabilities can lead to engine failure and loss of engine power which can compromise the aircraft safety and reliability. Therefore, a better understanding of how stall occurs and the causes behind its inception is extremely …
-
Separating flows around swept and unswept wings with laminar and turbulent free stream conditions
… the wing merge downstream to form the so-called stall cells, regions of reversing flow with a size comparable to the chord. The location of the mean turbulent separation can be defined only when considering the time averaged flow and it does not manifest in the instantaneous flow realisations. As …
-
Structural Dynamics Design of Steam Turbine Blades with Friction Contacts for Renewable Energy
L'abstract è presente nell'allegato / the abstract is in the attachment