Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 30 for “"Structural wood"”.
-
Finite Element Analysis of Unbraced Structural Wood I-Joists Under Construction Loads
… the lateral and rotational response of unbraced wood composite I-joists to worker loads. All experimentation and modeling was conducted on simply supported I-joists varying from 11-7/8 inches to 14 inches in depth and 20 feet to 24 feet in length. I-joists were subjected to static and dynamic …
-
Simulation based modeling of the elastic properties of structural wood based composite lumber
The importance of wood-based composite lumber is increasing in the US market for construction materials. Manufacturers of such composites strive to make their products more competitive by increasing their value. This dissertation describes the development of simulation models that can aid these …
-
re:Engineered: Exposing the the Architectural and Environmental Possibilities of New Structural Wood Composites
While wood is indisputably the most sustainable building material used in the Built Environment, very little of it is recycled at the end of a building’s life. Although both lumber quality and supply continue to decline annually, we persist with our view of wood only as a disposable commodity that …
-
Effect of sapstaining fungi on structural wood integrity of radiata pine (Pinus radiata D. Don)
… degradation of unseasoned radiata pine sapwood using four independent methods: i) toughness and weight loss measurements, ii) chemical analysis of wood composition, iii) enzyme assays and iv) light and scanning electron microscopy. Several isolates of albino-strains, potential candidates …
-
Penetration and permanence of an organophosphate and a pyrethroid in structural wood for insect control
… loss of chlorpyrifos from the surface of the wood but relatively stable below-surface concentrations. Similar studies with 0.5% permethrin [(3-phenoxypheny]) methyl] (+) - cis, trans-3-(2,2-dichloroethenyl)-2,2dimethylcyclopropane-carboxylate] applied to the same wood types revealed comparable …
-
The role of communications in emerging markets for wood products : the case of structural wood products in nonresidential construction
… between marketing communications and wood use. This investigation was conducted among architects within the context of the North American nonresidential construction market, where the structural use of wood is low compared to steel and concrete. Among architects, wood was deemed to be …
-
An exploratory analysis of chinese building specifiers -- : their knowledge of wood products & contributions to material
… construction market is currently dominated by structural materials of concrete, steel, and masonry with little wood use. Wood frame construction is new to the Chinese market and therefore, the acceptance and knowledge of architects, structural engineers, and developers about wood products are …
-
A Comparison of Epoxy Adhesives to Common Nails as Fastening Methods in Selected Structural Applications of Wood-Frame Construction
… compare the strength upon failure of structural wood joints fastened with epoxy to that of structural wood joints fastened with common nails. The design of this study was a 2 x 5 factorial that included two independent variables, fastening method and joint type. Seven specimen of each …
-
Strength Evaluation of Wood I-Joist with Sinusoidal Web
Wood I-joists are highly efficient, lightweight structural members used for long span applications. However, because of the high strength to stiffness ratio and thin--walled nature of the web, buckling or sudden loss of stability is a primary concern. Recently at West Virginia University a new …
-
Sustainable Hemp Industrial Panels (SHIP) and Its Industrial Possibilities for the Replacement of Oriented Strand Board (OSB)
… for oriented strand board (OSB), a commonly used structural wood product. Given hemp's historical and environmental advantages, including rapid growth, carbon sequestration capacity, and material strength, this research investigates its performance when combined with Urea-Formaldehyde (UF) resin, …
-
Development of tension and compression creep models for wood using the time-temperature superposition principle
… creep on the safety and serviceability of modem wood structures and structural wood composites. Long-term creep models were developed for wood in tension and compression using the Time-Temperature Superposition Principle (TTSP). The principle states that the long-term response of a polymer at …
-
Analytical Evaluations of Buckling Behavior of Wood Composite I-Joist with Sinusoidal Web
… buckling is an important limit state for wood composite I-joist because the in-plane bending stiffness is typically greater than torsional lateral bending stiffness. Web local buckling is another important limit state because of the thin-walled web configuration. To increase the buckling …
-
Isotope ratios in source determination of formaldehyde emissions
Formaldehyde emissions from non-structural wood composites are regulated and the regulation target is urea-formaldehyde (UF) resin. UF resins are hydrolytically unstable and constantly emit formaldehyde as a function of temperature and relative humidity. When heated, wood also generates …
-
Comparison of creep/duration of load performance in bending of Parallam® parallel strand lumber to machine stress rated lumber
… of load (DOL) performance of a new structural wood composite material called Parallam® parallel strand lumber (PSL) to two grades of machine-stress-rated (HSR) Douglas-fir lumber is presented in this thesis. Evaluation of the creep/DOL performance was made on nominal 2x4 members …
-
Lateral Torsional Buckling of Wood Beams
Structural wood design standards recognize lateral torsional buckling as an important failure mode, which tends to govern the capacity of long span laterally unsupported beams. A survey of the literature indicates that only a few experimental programs have been conducted on the lateral torsional …
-
Novel Liquid extraction method for detecting Native-wood Formaldehyde
… the allowable formaldehyde emissions from nonstructural wood based composites. Two main sources of formaldehyde emission in non-structural wood based composites are adhesive and wood. Adhesives are quite well known and great efforts have been conducted to decrease their formaldehyde content; …
-
Simulated Response of Degrading Hysteretic Joints With Slack Behavior
… and slack behavior; a mechanically-based structural stiffness model explains the interaction of one bolt with another bolt within a joint; an analytically-based failure model computes the stresses at each time step and initiates failure if crack length equals fastener spacing; a stochastic …
-
Aspects of Wood Adhesion: Applications of 13C CP/MAS NMR and Fracture Testing
… types of adhesives used in the production of structural wood-based composites. Much is unknown about various aspects of adhesion between these two types of resins and wood. The present research describes the development of techniques which will permit an enhanced understanding of 1.) the …
-
Identifying barriers to waste diversion : improving collection and quality of construction and demolition waste flow information
… C&D waste flows model was developed to determine structural wood product use, including softwood lumber, softwood plywood, OSB, glulam, I-joists and LVL, in US single family residences between 1950 and 2008. The results from this model demonstrated a product level of resolution in stocks and C&D …
-
Intelligent Roof Truss Digitalization of the building Process
Sweden has a big market for different wood and timber products, but the raw material usage still can be improved and optimized to its full strength and potential. The modern building and construction industry uses wood according to its specified property values in the different strength classes. …
Page 1 of 2