Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 153 for “"Subcooled"”.
-
Subcooled Flow Boiling and Condensation
… problems in two different flow regimes; subcooled water-steam bubbly condensing flow and subcooled flow boiling, in vertical conduits under low pressure and mass flux conditions, were investigated.</p> <p>For subcooled water-steam condensing bubbly flow, experiments were carried out to …
-
TEMPERATURE PROFILES IN SUBCOOLED NUCLEATE BOILING
<p>An experimental study of temperature profiles in the near vicinity of a horizontal copper surface on which water was boiled is reported in this thesis. A series of three tests is reported for heat fluxes of 20,000, 50,000 and 100,000 BTU/HRFT2 respectively. Four levels of subcooling were …
-
Collapse of steam bubbles in subcooled water
… at an orifice and rising freely through water, subcooled from 5 K to 36.6 K at pressures of 1 bar and 2 bar, has been analysed theoretically and experimentally. Orifice diameters were 1 mm and 2 mm, and steam flow rates of 0.5, 1 and 1.5 g/min were used. The data indicate a decrease in collapse …
-
Subcooled film boiling in non-aqueous fluids.
Subcooled film boiling has been investigated experimentally for vertical up-flow in a directly heated tube using the refrigerants R-12, R-22 and R-134a as test fluids. The data cover a mass flux range of 530 to 3000 kgm$\sp{-2}$s$\sp{-1},$ an inlet subcooling range of 6 to 28$\sp\circ$C and a …
-
Modelling of subcooled liquid hydrogen fueling system
… where high energy density is required. Subcooled Liquid Hydrogen (sLH2) is of significant importance due to its superior volumetric energy density and higher mass flow rates, outperforming compressed gaseous hydrogen in terms of rapid and high-capacity refuelling. However, challenges …
-
Bubble Nucleation in Saturated and Subcooled Boiling
<p> An experimental investigation is reported for water boiling at atmospheric pressure on a copper surface. Bubble nucleation at an artificial site was observed for five heat fluxes between 11,000 and 20,000 BTU/Hr Ft^2, and subcooling from 0° to about 30°F. Using Wiebe's correlation for heat flux …
-
Subcooled Forced-Convection Film Boiling in a Vertical Annulus
Made available in DSpace on 2014-12-10T22:48:20Z (GMT). No. of bitstreams: 1 7317497.pdf: 8594517 bytes, checksum: 8dc75893ecd55a11c9690718d7b1df74 (MD5) Previous issue date: 1973
-
Pool boiling studies on nanotextured surfaces under highly subcooled conditions
Subcooled pool boiling on nanotextured surfaces is explored in this study. The experiments are performed in an enclosed viewing chamber. Two silicon wafers are coated with Multiwalled Carbon Nanotubes (MWCNT), 9 microns (Type-A) and 25 microns (Type-B) in height. A third bare silicon wafer is used …
-
Vapor Bubble Detachment in Subcooled Pool Boiling at Zero Gravity
The mechanism of vapor bubble detachment at zero gravity has been studied both analytically and numerically. Instead of analyzing the force balance, this study emphasizes momentum conservation, the time integral of the force. The liquid velocity is derived from the velocity potential. Heat and mass …
-
Density measurements in subcooled water at pressures up to 400 MPa
… of temperature and pressure. The density of subcooled water is basically obtained by measuring, at constant mass, the equilibrium pressure by changing the temperature avoiding crystallization. Furthermore, since the paramount goal of performing accurate experimental measurements is the …
-
Experimental Study on the Subcooled Boiling Flow via Optical Measurement Techniques
A series of experimental work to investigate the subcooled boiling flow in a vertical square upward flow channel is described. As experimental methods, high-speed photography and infrared (IR) thermometry were employed simultaneously. The research scope explored includes (i) measurement issues of …
-
Numerical Simulations of Subcooled Nucleate Boiling for a Power Electronic Device
… a system is by liquid cooling with phase change (subcooled nucleate boiling) as an energy transport phenomenon. To develop such cooling systems, a mathematical model with a numerical solution procedure is needed to predict the physical properties. To achieve this, a literature study has been …
-
Numerical modeling of subcooled nucleate flow boiling in engine cooling systems
The demands for high power and low emissions put focus on energy efficiency when developing new engines. An important part is the engine cooling system, which cools the engine structure below damaging temperatures. For high temperatures in the cooling system there is a risk that boiling occurs and …
-
An Investigatio of Subcooled flow Boiling with Emphasis o nits Initiation
Made available in DSpace on 2017-07-06T18:55:40Z (GMT). No. of bitstreams: 2 Nourmohammadi_Khosrow_MS.pdf: 44965532 bytes, checksum: e061f1448c007bf887afc3534ab2da4a (MD5) license.txt: 4813 bytes, checksum: 715c4321821a960fa1a1e91d2ac7ebce (MD5) Previous issue date: 1980
-
A study on the thermal-hydraulic structure in subcooled flow boiling
this is the author’s version of a work that was accepted for publication in International Journal of Heat and Mass Transfer. Changes resulting from the publishing process, such as peer review, editing, corrections, structural formatting, and other quality control mechanisms may not be reflected in …
Page 1 of 8