Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 10 of 10 for “"Suction/blowing"”.
-
Use of the turbulence kinetic energy equation in prediction of nonequilibrium turbulent boundary layers
… direction as well as boundary layers with suction, blowing or zero mass addition at the wall. The turbulence kinetic energy equation is solved simultaneously with the longitudinal momentum and continuity equations to provide an independent means for determining the effective viscosity which …
-
Application of control methods to fluid mechanics problems: flow past a cylinder
… by means of steady mass transpiration (suction/blowing) on the cylinder surface. Initially, suction/blowing has been applied in three regimes of the cylinder surface, namely: (a) the front stagnation point region, (b) the sideway region, and (c) the rear stagnation point region. The …
-
Computational Solution of Tail Buffet Response and Active Flow Control
… number on tail buffeting. The use of an adaptive suction-blowing flow control method for tail-buff et alleviation is also computationally studied.
-
Numerical Investigation of Hypersonic Conical Boundary-Layer Stability Including High-Enthalpy and Three-Dimensional Effects
… crossflow instability was investigated utilizing suction/blowing at the wall in the LinCS/DNS framework. Results show good agreement with previous computational investigations, and that the proper basic flow computation/formation of the vortices is very sensitive to grid resolution.
-
Boundary Layer Control and Wall-Pressure Fluctuations in a Serpentine Inlet
… the simulator speed was 40 krpm. Boundary layer suction, blowing, and their combination were used to minimize the inlet's flow separation. The effectiveness of the suction alone and the blowing alone was shown to be approximately equivalent, and the effectiveness of the combined use of both was …
-
OPTIMIZATION OF BLOWING AND SUCTION CONTROL ON NACA0012 AIRFOIL USING GENETIC ALGORITHM WITH DIVERSITY CONTROL
… NACA 0012 airfoils upper surface simulating the blowing and suction control under Re=500,000 and angle of attack 18 degree. Nearly 300 numerical simulations are conducted over a range of parameters (jet location, amplitude and angle). The physical mechanisms that govern suction and blowing flow …
-
Wind tunnel test section design active flow control implementation
Submission original under an indefinite embargo labeled 'Open Access'. The submission was exported from vireo on 2025-10-19 without embargo terms
-
A Computational Analysis of the Leading-Edge Vortex Dynamics and its Control During Transient Pitching Cycles
… include camber morphing, popup tabs, suction/blowing, and variations thereof (Gardner et al., 2023). The primary end-goal of such devices is to assist in load alleviation during transient conditions like gusts, crosswinds, or wake that can potentially excite a dynamic aeroelastic …
-
Έλεγχος της μετάβασης και αποκόλλησης οριακού στρώματος και της απόδοσης αεροτομής με ενεργητική καθοδήγηση της ροής
… appropriately modified to allow simulations of blowing and/or suction of the boundary layer. Air flow simulations around an NACA0012 airfoil were carried out, in order to assess the effect of specific factors on the flow characteristics. A detailed study was made concerning the active boundary …
-
Experimental evaluation of a propulsive wing concept
… Results from the airfoil test indicated that the suction-enabled airfoil was accurately modeled during the design phase. A large reduction of drag was also observed for the suction-enabled airfoil. Lift and drag compared well between computational predictions and experimental measurements for the …