Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 58 for “"TURBINE CASCADE"”.
-
Development of a transonic turbine cascade facility
… the design and initial testing of a transonic turbine cascade facility. It is specifically concerned with the best way to obtain flow periodicity and repeatability through the cascade by the use of tailboards at the cascade exit. The problem of how to achieve flow periodicity and repeatability …
-
Reynolds stress measurements downstream of a turbine cascade
… flow downstream of a large-scale linear turbine cascade. A rotatable X-wire hot-wire probe that allows redundant data to be taken with solution for mean velocities and turbulence quantities by least-squares fitting procedures was developed. This measurement technique was verified in a …
-
Tip leakage flow in a linear turbine cascade
… of flow in the tip clearance gap of a linear turbine blade cascade. The cascade was designed and built to be geometrically similar to the earlier VPI&SU cascade; however, the new cascade also had a tip gap (2.1 percent of blade height) and two endwall boundary layer bleeds upstream of the …
-
Tip leakage losses in a linear turbine cascade
… production was performed on a large-scale linear turbine cascade having a tip gap measuring 2.1% of the blade height. The Reynolds number based on axial chord and cascade exit velocity was 4.5x10⁵. The experimental work began with a visualization study of the flow in and around the tip gap. The …
-
Experimental and numerical investigation of transonic turbine cascade flow
… study of the flowfield through a two-dimensional cascade of the high pressure turbine blades of a jet engine is presented. The main interest is the measurement and prediction of the mass-averaged total pressure losses. Other experiments, such as flow visualization, are aimed at the validation of …
-
Tip leakage loss development in a linear turbine cascade
Tip leakage losses were studied in a linear turbine cascade with a tip clearance gap equal to 2.1 percent of blade height. The blades of the cascade have a turning angle of 109.4 degrees, an aspect ratio of 1.0, and an axial chord length of 235.2 mm. The cascade was located at the exit of a low …
-
Unsteady shock wave effects on transonic turbine cascade performance
… assessment of unsteady shock wave effects on turbine blade performance has been developed. A novel shock-generation system utilizing a shotgun blast has been implemented into the Virginia Tech Wind Tunnel Transonic Cascade Facility. Specialized optical systems and high-performance pressure …
-
Experimental and computational investigation of flow through an annular turbine cascade
… experimental measurement location. An annular turbine cascade, designed for laser-Doppler velocimetry, was modified to obtain blade passage midspan surface pressure measurements. A range of predicted subsonic and transonic midspan surface pressures were compared favorably with experimental …
-
Measurement and prediction of the flow through an annular turbine cascade
An annular turbine cascade was designed and manufactured for laser Doppler velocimetry and probe measurements in a small-scale rig. The purpose of the experiment was to determine the limitations of these measurements in a confined annulus, and to compare the experimental results with numerical …
-
Evaluation of a Heat Flux Microsensor in a Transonic Turbine Cascade
… (HFM) versus an HFM deposited directly on a turbine blade to measure heat flux in a transonic cascade are investigated. The HFM is a thin-film sensor, 6.35 mm (0.250") in diameter (for an insert gage, including the housing) which measures heat flux and surface temperature. The thermal time …
-
Measurements of pressure and thermal wakes in a transonic turbine cascade
… temperature in the wake of a cooled transonic turbine cascade with heated flow are presented in this thesis. The experiment was conducted in the Virginia Tech Cascade Wind Tunnel. A dual hot wire aspirating probe was used to make high frequency, unsteady total pressure and temperature …
-
Experimental Acquisition Of An Endwall Heat Distribution In A Linear Turbine Cascade
… The experiment was conducted in a linear cascade test section, consisting of four turbine vanes with upper and lower bleed flows. Linear Cascade can reflect most of the flow characteristics in real gas turbine nozzles. This experiment exhibits some other advantages, such as geometric …
-
Steady and Unsteady Heat Transfer in a Film Cooled Transonic Turbine Cascade
… waves emerging from the trailing edge of modern turbine nozzle guide vanes and impinging on downstream rotor blades is modeled in a linear cascade. The Reynolds number based on blade chord and exit conditions (5*10^6) and the exit Mach number (1.2) are representative of modern engine operating …
-
An interferometric study of unsteady passing shock flow in a turbine cascade
… by a passing shock in a linear transonic turbine cascade. A 15 mW Helium-Neon laser was used as the light source. An intensified charge-coupled device (CCD) was used to capture images, allowing the required 100 ns shutter times to “freeze” the passing shock. High frequency Kulite pressure …
-
Laser anemometry and viscous computation of the flow through an annular turbine cascade
An annular turbine cascade, designed for laser-Doppler velocimetry , was further modified to provide additional laser and pressure probe access. The purpose of the research was to devise laser anemometry measurement techniques in a confined annulus and improve the ability to compare numerical …
-
Detection of secondary flow in a turbine cascade using a tracer gas technique
… vortices and the passage vortex, within a plane turbine blade cascade. Fluid motion was determined using a tracer gas technique. Ethylene was injected into the pressure-side and suction-side legs of the horseshoe vortex, near the leading edge of the cascade. Ethylene concentrations were …
Page 1 of 3