Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 41 for “"Thermal actuation"”.
-
Fully Compliant Tensural Bistable Mechanisms (FTBM) with On-Chip Thermal Actuation
… with optimization. In a coupled design approach, thermal actuators were optimized to the force and displacement requirements of the bistable mech-anisms, and selected FTBM devices were combined in switching systems with the result-ing Thermomechanical In-plane Microactuators (TIMs) and Amplified …
-
Development of a light-powered microstructure : enhancing thermal actuation with near-infrared absorbent gold nanoparticles.
… as microscale pumping and particle manipulation. Thermal actuation has been used with asymmetric geometry to create large deflections with high force relative to electrostatically driven systems. However, many thermally based techniques require a physical connection for power and operate outside …
-
Mid-infrared fibre lasers for use in wavefront coe=rrection in advanced gravitational wave detectors
… were identified as promising light sources for thermal compensation and actuation systems. This was primarily due to their compactness, high output power in the mid-IR and excellent beam quality. Two erbium-based fibre laser systems were considered, one which operated around a wavelength of …
-
Site-Specific Radio Frequency Heating of Nanomaterials and Conductive Polymers
… RF heating is beneficial to 1) trigger thermal actuation without a direct connection to a power source and 2) exhibit site-specific actuation without having drawbacks (ex. limited movement and complexity in design for selective actuation). Non-contact, site-specific thermal actuation by …
-
On-Chip Actuation of Compliant Bistable Micro-Mechanisms
… be switched in either direction using on-chip thermal actuation. The energy storage and bistable behavior of the mechanisms are achieved through the elastic deflection of compliant segments. The pseudo-rigid-body model was used for the compliant mechanism design, and for analysis of the …
-
High-Resolution Thermal Measurements in Fluids
Based on the thermal measuring methods for mass-flow sensors a thin-film sensor is presented allowing flow-rate measurements of down to 1 milligramm per hour, as required for application in medical dosing systems. <br>Due to the fast response of the sensor to thermal actuation and its low power …
-
Steady and Unsteady Thermo-Strucural Simulation of Thermally Actuated Micro- and Nano-Structures
… and fixed boundary conditions which are either thermally positioned, buckled, or actuated. The study begins with simulating a pinned-pinned beam in micro-scale and nano-scale. The steady state thermo-structural equation is solved numerically using an implicit Finite Difference method implemented …
-
Applications of polarized metallic nanostructures.
… MEMS applications. This work characterizes the thermal properties of gold nanoparticles on surfaces for spatially-targeted thermal actuation in MEMS systems. The second project deals with metalized nanopore membranes for use in microfluidic applications. For this project several models and …
-
Shaping Radiation Contours with a Parabolic Active Reconfigurable Origami Reflector Antenna
… provide intuitively compliant regions for actuation and act as a natural pivot for further folding of the structure. In order to exhibit the utility of the fold regions within origami, ARORA was designed with strategically placed shape memory alloy (SMA) wires in the antenna structure with …
-
Effect of Phase Transformation on Stress Redistribution and Damage Evolution During Actuation Fatigue in Shape Memory Alloys
… SMA bars under both pseudoelastic and thermal actuation loading paths. These notches are tailored to achieve stress concentrations of varying magnitude in order to see how different stress concentrations affect the phase transformation within a single phase transformation cycle. The …
-
Integration of carbon nanotube and vanadium dioxide thin films in photo-thermal actuators
… (SWNT) as a light absorber in VO2 photo-thermal actuators. The recent strong interest in VO2 among applied researchers has been driven by the drastic and reversible changes in the properties of this smart material, such as electrical resistivity and optical transmissivity, across its …
-
Characterizations of spatio-temporal complex systems
… of these rolls at a global scale. A laser based thermal actuation system is developed to reproducibly impose initial states for the fluid flow and construct ensembles of trajectories in the neighborhood of defect nucleation. This is used to extract the modes and their growth rates, characterizing …
-
Wall-based feedback control of a compressible laminar boundary layer subjected to free-stream vortical disturbances
… considers blowing and suction and wall thermal actuation to attenuate the Klebanoff modes. This further develops the works of Cathalifaud & Luchini [13] on spatial control for the incompressible linear boundary region equations and of Zuccher, Luchini & Bottaro [72] for the …
-
Fabricating of Stable Thin Film Microdevices with UV Laser
… sensors and actuators, where small structural, thermal, or material changes can produce disproportionate performance drift over time. This thesis investigates drift mitigation strategies in two ultraviolet (UV) laser–fabricated micro-devices that operate in distinct but complementary domains: …
-
Contacts with Dynamically Tunable Adhesion and Friction via Active Materials with Thermally Modulated Stiffness
… materials with tunable stiffness. In particular, thermally responsive polymers, which can exhibit significant changes in Young’s modulus of two to three orders of magnitude, show great promise for maximizing adhesion and friction control. However, systems that rely on thermal actuation often …
-
Controlled, Tailorable Release of Therapeutics from Poly(ester urea) Matrices for Pain Management
… were used to achieve sustained drug delivery, thermal actuation, multimodal analgesia, in vivo compatibility, and effective pain inhibition for 3-4 days. Overall, this work highlights the use of PEUs as a matrix for analgesia delivery that provides effective, sustained, and superior pain …
-
3D PRINTING OF MULTI-FUNCTIONAL HYDROGELS
… segmented dual-gel tubes composed of an active thermally responsive swelling gel (poly N-isopropylacrylamide; pNIPAM) and a passive thermally non-responsive gel (polyacrylamide; pAAM). The dual-gel structures are able to achieve reversible shape deformation including uniaxial elongation, radial …
-
Methods for nano-precise overlay in advanced in pick-and-place assembly
… overlay in multi-field patterning, including thermal-actuation based substrate-distortion-control, and genetic algorithm-based template topology-optimization. Separately, we have realized that localized overlay errors can be introduced in J-FIL due to sub-micron sized particles, which are …
-
A Thermally actuated microelectromechanical (MEMS) device for measuring viscosity
A thermally actuated non-cantilever-beam micro-electro-mechanical viscosity sensor is presented. The proposed device is based on thermally induced vibrations of a silicon-based membrane and its damping due to the surrounding fluid. This vibration viscometer device utilizes thermal actuation through …
-
Cantilever beam microactuators with electrothermal and electrostatic drive
… circuits. Magnetically, electrostatically and thermally driven microactuators have been reported previously. These actuators have applications in many fields from optics to robotics and biomedical engineering. At NJIT cleanroom, mono or multimorph microactuators have been fabricated using CMOS …
Page 1 of 3