Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 12 of 12 for “"Two-phase flow simulation"”.
-
Stabilised level set methods for two-phase flow simulation
This work is dedicated to the numerical simulation of two-phase incompressible flows with a velocity field imposed or computed from a Navier-Stokes solver. The main objective is to accurately track the interface between the two fluid phases of a domain that is subject to an imposed or computed …
-
Performance evaluation of a gasifier cooling jacket by means of a homogeneous two-phase flow simulation model
… inner wall, and increase the cooling water mass flow rate. A one dimensional homogenous steady state two-phase flow simulation model was developed to simulate the thermo-hydraulic performance of the Gasifier jacket concepts. Boundary conditions including the heat flux profile, high-pressure …
-
Non-equilibrium two-phase flow simulation of an open feed water heater in the HPLWR power plant
… water reactor (HPLWR), using a non-equilibrium two-phase flow approach. The main reason is to evaluate the potential improvement in accuracy when predicting operating conditions compared to an equilibrium steady state approach. The simulation developed consists of three integrated sub-models …
-
Water management of proton exchange membrane fuel cells : two-phase flow simulation in gas diffusion layers and channels
… can accumulate within porous electrodes and flow channels, leading to flooding that impedes the reverse transport of reactant gases to the reaction zone, thereby reducing fuel cell efficiency. A comprehensive understanding of two-phase flow behavior within gas diffusion layers and channels is …
-
Two-Phase Flow Simulation in Porous Media Geometries Reconstructed from micro CT Data : Application to Fluid Transport at Low Capillary Numbers
… drug delivery, are often simulated as a single phase or multiphase continuum using Darcy’s law. Darcy’s law considered being the most used model of many approaches for simulating the flow through porous media, where the Darcy model assumes a simple proportional relationship between the …
-
CFD Simulation for the Erosion on Electrical Submersible Pump Due to Viscosity and Air Presence
… can erode hydraulic as well as secondary flow paths which can lead to damage of the pump resulting in affects ranging from performance degradation to pump failure. This study is focused on CFD (Computational Fluid Dynamic) based evaluation of erosion in ESP pump section under different …
-
Pneumatic conveying in the dense and dilute phase
… parameter is the solid concentration and solid flow behaviour after going through a pipe bend. The relationship between solid concentration and other parameters, like particle size, conveying velocity, pipe wall roughness etc, is a complex one. Computational fluid dynamics (CFD) was being used …
-
Numerical investigation of two phase flow using automatic controller system and chaotic approach
… and intelligent system to recognize the two-phase water-air flow regime in a vertical tube based on fuzzy logic and genetic algorithm is proposed. Two approaches, volume of fluid (VOF) and Eulerian model, were used for the numerical simulation of gas-liquid two-phase flow. Four different …
-
Melt extraction from a permeable compacting mantle
… and three-dimensional numerical solutions to a two-phase fluid flow problem. The context of these investigations is the evolution of a viscous permeable matrix with a small fraction of melt that is representative of partial melt in the Earth's mantle. The matrix compacts under gravity as melt …
-
Mechanistic modeling of evaporating thin liquid film instability on a bwr fuel rod with parallel and cross vapor flow
… rod with simultaneous parallel and cross flow of vapor. Interest in this problem has been motivated by the fact that the liquid film on a full-length boiling water reactor fuel rod may experience significant axial and azimuthal heat flux gradients and cross flow due to variations in the …
-
Multiphase flow modeling and deposition of hydrates in oil and gas pipelines
Multiphase flow is a ubiquitous feature of oil and gas production and hence, all flow assurance issues involve multiphase flow. The risk of plugging due to gas hydrate formation remains one of the most prevailing flow-assurance problems in deepwater subsea oil and gas operations. Due to the …
-
Two-Phase Flow Pressure Drop Across Thick Restrictions of Annular Geometries
… the methods of predicting the steady-state two-phase flow (steam and water) pressure drop across the restrictions of annular geometries formed when tubes extend through circular holes in tube support plates. Two approaches are discussed and a detailed sample calculation of the one selected …