Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 12 of 12 for “"Uniform Flow Distribution"”.
-
Achieving Uniform Flow Distribution in Compact Irrigation Splitter Boxes with High Flow Rates
… their allotted portion, regardless of the flow rate in the system. Each splitter box usually includes two compartments, separated by a wall that acts as a weir for the water to flow over. The water in the supply pipe enters the box and fills the upstream compartment until it spills over the …
-
Three-dimensional numerical study of proton exchange membrane fuel cell design
… cells because they are the first stage of the flow distribution system. A non-uniform flow distribution across the active reaction area within PEM fuel cells will probably lead to an unbalanced use of the precious catalyst, and a lower overall efficiency of the device than expected. A …
-
Optimization of channel geometry in a proton exchange membrane (PEM) fuel cell
… important components of the PEM fuel cell. The flow distribution inside the bipolar plate should be uniform. Non-uniform flow distribution inside the bipolar leads to poor performance of the fuel cell and wastage of expensive catalyst. A single channel PEM fuel cell is taken and electrochemical …
-
A study on two-phase flow characteristics in cross-linked microchannel heat sinks
… and industry. Obtaining heat sink designs with uniform flow distribution is strongly desired. Mal-distribution in a standard straight microchannel heat sink has become a problematic issue in this research area. A cross-linking scheme, introduced in the channel core promises an appropriate …
-
Modeling of controlled-shear affinity filtration using computational fluid dynamics and a novel zonal rate model for membrane chromatography
… fouling and cell cake formation allowing for a uniform filtrate flux that maximizes membrane column performance. However, the fundamental hydrodynamics and mass transfer kinetics within the CSAF device are poorly understood and, as a result, the industrial applicability of the technology is …
-
Sedimentation between parallel plates
… in which settling length is strictly limited. Flow between parallel rough and smooth plates has been modelled together with sediment concentration profile. Accurate description of boundary layer flow requires the solution of Navier-Stokes equations, and due to the complexity of the equations to …
-
Design and monolithic 3D printing of a split-and-recombine micromixer and a microfluidic concentration gradient generator
… fluidic behavior, mixing efficiency, and flow distribution across increasingly functional architectures. The first iteration established the baseline performance of the Split-andrecombine (SAR) micromixing units and the hydraulic resistor network responsible for gradient formation. Surface …
-
Comparison of Experimental Methods in the Measurement of Wind Turbine Wakes
… of measurements inside the facility, the flow distribution was measured upwind of the turbine to obtain a profile. This was completed through the development of a structure to orientate pitot tubes in front of the area of the turbine. The device allowed for various fan configuration …
-
Heat transfer in high current density electrical machines
… direct liquid cooled machines suffer from a non-uniform flow distribution, which affects the stator temperature distribution. To investigate this problem, an efficient thermo-fluid model was developed to predict the flow and temperature distribution in an oil-cooled stator. This was compared to …
-
Optimization for Fuel Cells/Fuel Cell Stacks Using Combined Methods---CFD Modeling Analysis, and Experiments
… design is introduced in order to decrease mal-distribution and non-uniform output performance between individual cells in order to improve the stack performance. Novel stack architecture includes a novel external bifurcation flow distribution delivery system. One major issue of uniform …
-
ENERGY MICROPILES AND THERMO-ACTIVE FOUNDATIONS: EXPERIMENTAL INVESTIGATION, NUMERICAL MODELLING, AND EMERGING APPLICATIONS
… chips. Extensive monitoring under varied flow regimes and hydraulic connections (series and parallel) provided robust, high-resolution data for both single-pile and group performance evaluations. Building upon the experimental evidence, calibrated three-dimensional finite element models …
-
Výpočtové modelování distribuce toku pracovních látek v procesních zařízeních
Nerovnoměrná distribuce toku látek je stav, při němž vzniklé lokální teplotní či rychlostní extrémy mohou významně ovlivnit provoz zařízení. Přesto se současná průmyslová praxe věnuje predikci distribuce toku látek jen velmi omezeně, především v rámci analýzy příčin provozních potíží zařízení a v …