Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 20 of 70 for “"VSWR"”.

  1. Determination of the Residual VSWR [Voltage Standing Wave Ratio] of a Slotted Line.

    … terminated in its characteristic impedance, the VSWR as determined by a movable probe in the slotted line will be 1.0. However, in practice this is not possible, particularly in the case of coaxial slotted lines where matching elements, adapters and connectors are utilized. The devices mentioned …

    unm Repository record for Determination of the Residual VSWR [Voltage Standing Wave Ratio] of a Slotted Line. (opens in a new tab)

  2. Millimeter-Wave VSWR Resilient Built-In Self-Test Electronics For Phased Array Applications

    … terminations in which they were designed for (VSWR). This issue compromises both the array’s radiation pattern, as well as the electronics’ performance in both linearity and efficiency. Reconfigurable amplifiers can compensate for this impedance mismatch and maintain the electrical performance, …

    gatech Repository record for Millimeter-Wave VSWR Resilient Built-In Self-Test Electronics For Phased Array Applications (opens in a new tab)

  3. Load Modulated Balanced Amplifier (LMBA) with Antenna-VSWR Resilience for Energy- and Spectrum-Efficient Communications

    … steering, with the voltage standing-wave ratio (VSWR) reach up to 6 : 1. Such impedance fluctuations directly impact the performance of power amplifiers (PAs) and can cause system level degradation such as main beam distortion. To address aforementioned challenges, a one-dimensional …

    ucf Repository record for Load Modulated Balanced Amplifier (LMBA) with Antenna-VSWR Resilience for Energy- and Spectrum-Efficient Communications (opens in a new tab)

  4. The Use of Compensation With Directional Couplers

    … for measuring voltage standing wave ratio (VSWR). The reflectometer system is analyzed, and an improved coaxial system is presented which more accurately measures VSWR.

    unm Repository record for The Use of Compensation With Directional Couplers (opens in a new tab)

  5. Slot line investigations.

    … and the design and construction of a slot line VSWR jig. Measurements of slot wavelength are presented with a comparison made to theoretical values. The results of VSWR measurements are also presented. Experimental work was performed in the 1GHz to 12GHz frequency range.

    nps Repository record for Slot line investigations. (opens in a new tab)

  6. Load Variation Resilient and Average Efficiency Enhanced Power Amplifiers for 5G/6G Beamforming System

    … resiliency (Voltage-Standing-Wave-Ratio (VSWR) resiliency) to front-end architectural synthesis for Power Amplifiers (PAs). To improve circuit integration and performance for Time-Division Duplex (TDD) operation in beamforming systems, Chapter 3 focuses on the co-design of a …

    waterloo Repository record for Load Variation Resilient and Average Efficiency Enhanced Power Amplifiers for 5G/6G Beamforming System (opens in a new tab)

  7. STUDY OF MULTI- AND BROAD-BAND INTERNAL ANTENNAS FOR MOBILE APPLICATIONS

    … (design #2) are 185MHz (7%) and 105MHz (4.1%), VSWR in less than 2, respectively. Two layers Planar Inverted F Antenna (PIFA) with the modification of the ground and radiating element was studied. The inserted T-shaped or L-shaped ground and inserted a slot and slits on radiating elements help …

    siu-theses Repository record for STUDY OF MULTI- AND BROAD-BAND INTERNAL ANTENNAS FOR MOBILE APPLICATIONS (opens in a new tab)

  8. Beaidžio kambario kalibravimas /

    … measure the reflectivy of the RF room using the VSWR method and the existing loses of the chamber using the normalized site attenuation method. The VSWR method is measured using one antenna, to measure the amount of power that is reflected from the walls, ceiling and floor back to the antenna. …

    vilnius Repository record for Beaidžio kambario kalibravimas / (opens in a new tab)

  9. New Designs for Wideband Hemispherical Helical Antennas

    … directivity, and voltage standing-wave ratio (VSWR) are calculated for several designs. The impacts of tapering as well as tilting of the metallic strip on radiation characteristics are examined. Also, matching of the proposed hemispherical antennas to 50â ¦ transmission lines is addressed. A …

    vt Repository record for New Designs for Wideband Hemispherical Helical Antennas (opens in a new tab)

  10. Analysis and Design of a Broadband Antenna for Software Defined Radio

    … capable of achieving an instantaneous 3:1 VSWR bandwidth and omnidirectional radiation coverage spanning a bandwidth greater than 20:1. The antenna is designed to accommodate the very large bandwidth requirements of software-defined radios and to minimize the effective volume of the overall …

    uiuc Repository record for Analysis and Design of a Broadband Antenna for Software Defined Radio (opens in a new tab)

  11. Manipulation of antenna-mode radar cross-section in patch antennas

    … points on a fixed Voltage Standing Wave Ratio (VSWR) circle on a Smith chart. The behavior was simulated at the fundamental frequency and the first and second harmonics. The patch antenna and the various loads were fabricated, and the actual change in RCS was measured in an anechoic chamber. The …

    uiuc Repository record for Manipulation of antenna-mode radar cross-section in patch antennas (opens in a new tab)

  12. Broadband base isolated asymetrically fed VHF antenna

    … The equalizer network reduced the antenna VSWR to 7:1. A 2 dB attenuator is required to reduce this VSWR to an acceptable 3.5:1.

    njit Repository record for Broadband base isolated asymetrically fed VHF antenna (opens in a new tab)

  13. A Coplanar Waveguide UWB Antenna With Notch Filter

    … It operates from 3.1 GHz to 10.6 GHz with a VSWR < 2 in the pass bands, and a VSWR > 2 in the stop bands. The selected frequencies demonstrate nearly omni-directional characteristics in radiation patterns. Comparing with other published UWB antenna designs, relatively reasonable group delay …

    uvic Repository record for A Coplanar Waveguide UWB Antenna With Notch Filter (opens in a new tab)

  14. Case study of normal and high glucose laden cell response to cellular phone radiation using GTEM cell

    … fields, voltage standing wave ration (VSWR) and return loss calculations. In the biological effects studies, the blood samples were placed at the testing area inside the GTEM cell operated at 850 and 900 MHz and at 2 W and 60 W power levels; the frequencies and power respectively …

    missouri Repository record for Case study of normal and high glucose laden cell response to cellular phone radiation using GTEM cell (opens in a new tab)

  15. Communications antenna for a micro RPV

    … provides the lowest voltage standing wave ratio (VSWR) and a nearly hemispherical radiation pattern. The data was generated at frequencies near 1 GHz using two method of moments computational electromagnetic codes: PATCH and NEC-Win.

    nps Repository record for Communications antenna for a micro RPV (opens in a new tab)

  16. Design of microstrip patch antenna for the NPSAT1

    … design requirements for the antennas include a VSWR of less than or equal to 2:1 for 50 omega reference impedance. The study includes of the development of a threedimensional antenna model, antenna simulation, and analysis of results based on various outputs of the CST Microwave Studio Finite …

    nps Repository record for Design of microstrip patch antenna for the NPSAT1 (opens in a new tab)

  17. High Linearity Full Duplex System Implemented with Novel Impedance Matching Network

    … network, the IIP3 can reach +60dBm with a VSWR of 1.5:1. Additionally, the overall cancellation depth from TX to RX is larger than 60dB.

    washington Repository record for High Linearity Full Duplex System Implemented with Novel Impedance Matching Network (opens in a new tab)

  18. DESIGN OF ULTRA-WIDEBAND ANTENNAS WITH SIGNAL REJECTION CHARACTERISTICS FOR BIOMEDICAL APPLICATIONS

    … like linear phase, low dispersion and VSWR ≤ 2 throughout the entire band. Linear phase and low dispersion are marked by low values of group delay and is imperative for transmitting and receiving a pulse for distortion free communication. VSWR ≤ 2 is required for proper impedance …

    uab Repository record for DESIGN OF ULTRA-WIDEBAND ANTENNAS WITH SIGNAL REJECTION CHARACTERISTICS FOR BIOMEDICAL APPLICATIONS (opens in a new tab)

  19. The Study and Implementation of Electrically Small Printed Antennas for an Integrated Transceiver Design

    … maintains 2:1 Voltage Standing Wave Ratio (VSWR) or equivalently has 10-dB return loss. Ansoft High Frequency Structure Simulator (HFSS) is used to simulate expected resonant frequency, bandwidth, VSWR, and radiation pattern characteristics. Ansoft HFSS simulation is used to provide a good …

    ku Repository record for The Study and Implementation of Electrically Small Printed Antennas for an Integrated Transceiver Design (opens in a new tab)

Page 1 of 4