Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 42 for “"Vibration--Mathematical models"”.
-
Application of adaptive trusses to vibration isolation in flexible structures
… techniques for using adaptive trusses for active vibration isolation in flexible structures. Passive methods have been used almost exclusively in the past for vibration isolation, although in the more recent literature active techniques have been proposed in an attempt to achieve greater isolation …
-
The influence of a mass on the free flexural vibrations of a circular ring
… solution was obtained for the free flexural vibrations in the plane of a thin circular ring containing a point mass. As a degenerate case of the general solution, the solution for a uniform ring alone was derived from the general solution by taking the point mass to be zero. Numerical …
-
An investigation of flow-induced vibrations of a steam-generator tube
A typical failure in a heat exchanger is the breakdown of a tube due to impact-sliding wear. We investigate the dynamic behavior of a tube subjected to cross flow and study the stability of periodic solutions, bifurcations, and the route to chaos. The fluid-stiffness-controlled mechanism is chosen …
-
Gravity's effect on centrifugal pendulum vibration absorbers
… dynamics and performance of centrifugal pendulum vibration absorbers (CPVAs). CPVAs are passive devices, consisting of movable masses suspended on a rotor, which act to reduce torsional vibrations in internal combustion engines and other rotating systems. When the system axis of rotation is not …
-
A reduced-order crawler crane model with active control to attenuate the transient vibrations
The nonlinear differential equations describing the motion of a crawler crane in a plane are formulated by applying Lagrange's equation to the system kinetic energy, potential energy and virtual work. The transient response of the crane system due to the vertical drop of the suspended load is …
-
In-plane blade-hub dynamics of horizontal-axis wind turbines with tuned and mistuned blades
Understanding vibration of wind turbine blades is of fundamental importance. This study focuses on the effect of blade mistuning on the coupled blade-hub dynamics. Unavoidably, the set of blades are not precisely identical due to inhomogeneous materials, manufacturer tolerances, etc. This work is …
-
Stochastic autoparametric interaction in aeroelastic structures under wide band random excitation
… not previously reported in nonlinear random vibration literature. These include multiple solutions and jump phenomena at internal detuning slightly shifted from the exact combination internal resonance condition (i.e., when the frequency of the third normal mode is greater than the sum of the …
-
Experimental determination of the impulse response function for elastic vibrating systems
An experimental method for determination and analysis of the impulse response function of linear, elastic, vibrating systems is developed. A deconvolution method is developed for estimation of the impulse response function. The estimator is shown to be unbiased in the presence of measurement noise. …
-
Transient behavior of centrifugal pendulum vibration absorbers with tautochronic epicycloidal paths
Thesis (M.S.)--Michigan State University. Department of Mechanical Engineering, 2007
-
Gravitation effects on centrifugal pendulum vibration absorbers linear analysis
… on the dynamic response of centrifugal pendulum vibration absorbers (CPVAs). This analytical study considers small amplitude motions of the absorbers so that linear vibration tools can be applied. The motivation of the study is to determine the behavior of CPVAs at low rotor speeds, where gravity …
-
Modeling of multiple layered piezoelectric actuators in active structural control
The design and analysis of finite length, multiple layered, induced strain actuators is investigated. A model of an arbitrary multiple layered actuator is utilized to predict the applied force and moment from the i<sup>th</sup> layer onto a structure. The transverse equations of motion of a simply …
-
Model reduction of nonlinear structural systems using nonlinear normal modes and component mode synthesis
Thesis (Ph. D.)--Michigan State University. Department of Mechanical Engineering, 2003
-
The fundamental frequencies of plates with a core
Thesis (Ph. D.)--Michigan State University. Department of Mathematics, 2005
-
Response of a nonlinear two-degree-of-freedom system to a horizontal harmonic excitation
An elastic structure containing a fluid subjected to a horizontal sinusoidal excitation is investigated. The system is found to include cubic nonlinearities. The system response is determined by using the multiple scales asymptotic approximation method. The method predicts that primary resonances …
-
The independent quadratic optimisation algorithm for the active control of noise and vibration / Neil C. Mackenzie.
… control strategy, for active noise and vibration control systems, that does not require identification of the cancellation path transfer function. The Independent Quadratic Optimisation algorithm, developed in this work, is meant to optimise the coefficients of the control filter …
-
Diagnostics, prognostics and fault simulation for rolling element bearings
Vibration signals generated from spalled elements in rolling element bearings (REBs) are investigated in this thesis. A novel signal-processing algorithm to diagnose localized faults in rolling element bearings has been developed and tested on a variety of signals. The algorithm is based on …
-
Dynamics of horizontal axis wind turbines and systems with parametric stiffness
… wind turbine blade under bend-bend-twist coupled vibrations is investigated. The potential and kinetic energy expressions for a straight nonuniform blade are written in terms of beam parameters. Then, the energies are expressed in terms of modal coordinates by using the assumed modes method, and …
-
Active vibration control of composite structures
The vibration control of composite beams and plates subjected to a travelling load is studied in this dissertation. By comparing the controlled as well as uncontrolled responses of classical and refined structural models, the influence of several important composite structure properties which are …
Page 1 of 3