Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 131 for “"Wake region"”.
-
AN EXPERIMENTAL STUDY OF THE NEAR-WAKE REGION OF SURFACE-MOUNTED RECTANGULAR FLAT PLATES
… and the vortex structures produced in the wake. The plate acts as a bluff body when oriented normal to the flow. When angled with respect to the flow, a low-aspect-ratio flat plate may be used as a vortex generator. In this thesis, the flow over a surface-mounted flat plate is examined …
-
Effect of Passive Clean Air Injection Into the Wake Region of a Moving Ground Vehicle
<p>The wake region on a moving ground vehicle is responsible for 70% of the aerodynamic drag when the speed of 90km/h is achieved. The topic of wake region manipulation has been revisited multiple times and with varying techniques. When manipulating the flow utilizing a fully passive method, …
-
Experimental measurement of base pressure coefficients for deflector plates with air injected into the wake region
Electronic Thesis or Dissertation
-
Time-resolved heat transfer measurements and analysis in the wake region of a cylinder in crossflow
… entire cylinder. In the attached boundary layer region, the heat flux signal was sinusoidal at the shedding frequency for the steady cases and at the driving frequency for the pulsating case. In the wake, however, the fluctuations were less organized in all cases. Here the magnitude of the …
-
The effect of freestream oscillatory motion on heat transfer in the wake region of a cylinder in crossflow
… shown that the heat transfer in the separated (wake) region is extremely sensitive to freestream turbulence. Hot wire anemometer measurements using a single wire probe have also been obtained in the wake region. Local mean and fluctuating velocity distributions around the cylinder wall are in …
-
Particle Image Velocimetry (PIV) measurements in the wake of a cascade of compressor blades at stall
… the trailing edge of the blade well into the wake region. Flow visualization techniques were used to observe and record the behavior of the region of flow separation. The PIV data showed that the separated regions continued to grow up to approximately 10% of blade chord length past the …
-
Circulation control for download wake reduction on a scaled V-22 model
… wing to reduce the size of the download in the wake region brought upon by the airflow from the proprotors. The techniques being used in this experiment are the implementation of blowing slots across the leading edge and trailing edge, activation of one or both of the blowing devices, and …
-
Experimental study of turbulent flow around trapezoidal cylinders in uniform flow
… of streamwise aspect ratio (AR) on asymmetric wake flows around right-angled trapezoidal cylinders with AR (upper cylinder length to height ratio) = 1, 2, 3, 4, and 5 using a particle image velocimetry (PIV) technique. The Reynolds number based on the free-stream velocity and cylinder height …
-
Cooling tower recirculation as influenced by the local atmospheric flow field, a numerical study
… entrains fluid from the plume into the separated wake region from which it is ingested into the cooling tower. The ingested stack effluent enters at an elevated temperature and humidity relative to the ambient and thus reduces the efficiency or effective size of the cooling tower.</p><p>A survey …
-
Direct numerical simulations of aeolian noise generated by a circular cylinder in subsonic and transonic conditions
… of the cylinder. In the oscillating near-wake region, the hydrodynamic component dominates over the acoustic component at most frequencies, except at the vortex-shedding frequency where they exhibit comparable strengths. Furthermore, within the oscillating near-wake region, the overall …
-
ΑΕΡΟΔΥΝΑΜΙΚΗ ΑΝΑΛΥΣΗ ΚΑΙ ΒΕΛΤΙΣΤΟΠΟΙΗΣΗ ΑΙΟΛΙΚΩΝ ΕΝΕΡΓΕΙΑΚΩΝ ΣΥΣΤΗΜΑΤΩΝ
… THE WORK FOCUSES ON THE ANALYSIS OF THE WAKE EFFECTS IN WIND PARKS A PHENOMENON THAT CAUSES REDUCTION OF THE ENERGY OUTPUT ANDTHE LIFE TIME OF THE WIND TURBINES OF THE PARK. THE KERNEL OF THE WHOLE ANALYSIS IS THE NUMERICAL SIMULATION OF THE FLOW AROUND A STAND ALONE WIND TURBINE,AIMING …
-
Flow Visualizations and Measurements of Turbulent Structures in Drag-Altered Axisymmetric Compressible Base Flows
… present in the recompression and reattachment regions of the flowfield are shown to de-stabilize the turbulent structure organization. The mean structure statistics of all drag-altered flowfields demonstrate that the dominant organization present upstream is significantly weakened or lost due …
-
Asymmetrical localised synthetic jets in three-dimensional flows over bluff and streamlined bodies
… flow separation of the boundary layer and the wake region. A bluff body, an 80 mm side-supported sphere, was tested at a Reynolds number of 5 x 104 in a closed test section wind tunnel in the UNSW Aerodynamics Laboratory. Surface pressure measurements on the sphere showed a delay in flow …
-
Turbulence studies of the flow of dilute polymer solution about circular cylinders
… and turbulence microscale were taken in the near wake region of a circular cylinder for several degradation states of polymer flow. Additionally, the effects of polymer degradation upon hot-film anemometer operations were determined. the results of this study substantiated the determinations on …
-
Tip Clearance Effect on Convective Heat Transfer in Micro Scale Pin Fins
… over the heated surface. Nusselt number and wake length for a range of tip clearances were presented and compared with full-height pin fin. Experimental and numerical results showed that a tip clearance can significantly enhance heat transfer in the wake region. Simulations revealed that tip …
-
Reynolds number effects on turbulent wakes generated by rectangular cylinders with streamwise aspect ratios between 1 to 4
… number on the separated shear layer and near wake of rectangular cylinders in uniform flow are investigated experimentally using a particle image velocimetry system. Four length-to-height ratios (AR = 1, 2, 3 and 4) are examined at Reynolds numbers (based on freestream velocity and cylinder …
-
Wake Filling Techniques for Reducing Rotor-Stator Interaction Noise
… for reducing the momentum deficit in a rotor wake and thus attenuate rotor-stator interaction noise. A secondary concern of the project was to reduce the amount of blowing required air for wake filling and thus limit the efficiency penalty in an aircraft engine environment. Testing was …
-
An experimental investigation of large-scale structures in supersonic reattaching shear flows
… the shear layers, at reattachment, and in the wake region of a supersonic base flow. Single-pulse side and end views were obtained at several streamwise locations to characterize the evolution and three-dimensionality of the large-scale motions. From statistically significant ensembles, spatial …
-
A computational aeroacoustic investigation of a horizontal axis wind turbine
… at locations downstream of the rotor in the wake region. Higher tip pitch angles were found to result in less noise.
Page 1 of 7