Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 28 for “"Weak inversion"”.
-
On designing coarse grain reconfigurable arrays to operate in weak inversion
… patent held by Sima, et al, was analyzed in weak inversion across four transistor technology nodes (180nm, 130nm, 90nm, and 65nm). Previous was also expanded from strong inversion across 180nm, 130nm, and 90nm technology nodes to also include 65nm. The UMUX-LRB interconnection network is …
-
FPGA interconnection networks with capacitive boosting in strong and weak inversion
… in reconfigurable arrays, operation in weak inversion region has been suggested. Current programmable interconnections cannot be directly used in this region due to a very poor propagation delay and sensitivity to Process-Voltage-Temperature (PVT) variations. This work also focuses on …
-
A Design Basis for Composite Cascode Stages Operating in the Subthreshold/Weak Inversion Regions
… the devices operating in the various regions of inversion.
-
Design, fabrication, and testing of temperature compensated MAGFET
… on dc behaviour of MOS transistors operating in weak inversion is derived on the basis of previous publications. The bipolar like source to drain transfer characteristics of MOS transistor in weak inversion was used to implement a voltage source that is proportional to absolute temperature …
-
Current-Mode Analog Multiplier Based on Trasnlinear Loops
… technology usingCMOS transistors operating in weak inversion. A thorough analysis of the proposed designis performed using Spectre and monte-carlo simulations. The multiplier consumes a lowpower of 0:6W and supports an input range of ±200nm while operating from 0.8V supply.The proposed …
-
Characterization and modeling of nanoscale multi-gate MOSFETs
… valid in all regions of operation, i.e. from weak inversion to strong inversion in the below and above threshold voltage regions. First, symmetrical Double-Gate MOSFETs (DG MOSFETs) are studied, whereas the study of all other types of multi-gate MOSFETs (triple-gate and gate-all-around) is …
-
Design of a Cost-Efficient Reconfigurable Pipeline ADC
… the transistors in the OTA tend to operate in weak inversion region due to the scaling of the bias current. The transistor in subthreshold is very slow due to the small transit frequency. In order to get a better tradeoff between the transconductance efficiency and the transit frequency, …
-
Performance characteristics and design of voltage references
… MOS transistors operating in deep weak inversion is also discussed. An analytical formulation of the weak-inversion MOS voltage reference shows that the MOSFET-based structure has even lower temperature sensitivity than the basic bandgap circuits. The issue of practicality of the …
-
Design and Simulation of Sine-Gordon Lattice System
… circuit that exploits bulk voltages under weak inversion to realize the sine function in the sine-Gordon lattice system and the complete circuit of the sine-Gordon cell is also created utilizing this MOS translinear sin(x) circuit.
-
High Gain Low Power Operational Amplifier Design and Compensation Techniques
… little alteration. MOS devices are used in the weak inversion region or the subthreshold inversion region to minimize dc source power. A feasible configuration for high gain, low power op amp design utilizing subthreshold operation along with active operation is proposed. This op amp uses …
-
Design of large time constant switched-capacitor filters for biomedical applications
… voltage of 1.6V and all transistors operate in weak inversion with currents in the range of tens of nano-amperes.
-
Design of CMOS Four-Quadrant Gilbert Cell Multiplier Circuits in Weak and Moderate Inversion
… introduced by drift currents when designing in weak and moderate inversion. This concept allows for linear multiplier designs with larger input currents which results in dramatic improvements in bandwidth over traditional weak inversion circuits. Three multiplier circuits are simulated and …
-
ANALYSIS AND DESIGN OF LOW VOLTAGE AND LOW POWER ANALOG CIRCUIT BLOCKS
… Amplifiers using MOS transistors biased in the weak inversion region. The design procedure in Chapter-1 starts with a standard low-pass gm-C synthesis from a normalized double terminated LC ladder. Later, a new method for scaling of the filter for maximization of dynamic range is described. …
-
Bandgap Reference Design at the 14-Nanometer FinFET Node
… is the diode-connected MOSFET operating in weak inversion. In addition to conducting appreciable current at voltages significantly lower than the power supply, the diode-connected MOSFET reduces the total area for the bandgap implementation. Reference voltage variations across Monte Carlo …
-
Simulation of total ionizing dose and random dopant fluctuations in sub-100 nm transistor nodes
… of the irradiated devices during the weak inversion of the parasitic transistor induced in the device. Their effect is negligible, however, when the parasitic channel is fully formed.
-
Low-power current-mode ADC for CMOS sensor IC
… using transistors operating in subthreshold or weak inversion region of operation, to work in low-voltage and low current supply. The DNL and INL plots are given in simulation results section. The area of the overall ADC was 0.046 mm2 only.
-
Low-power CMOS front-ends for wireless personal area networks
… higher transconductance to bias current ratio in weak inversion could be exploited in developing low-power wireless front-ends, if circuit techniques are employed to mitigate the higher device noise in subthreshold region. The first fully integrated subthreshold low noise amplifier was …
-
Feedforward Artificial Neural Network Design Utilising Subthreshold Mode CMOS Devices
… mismatch of components problems associated with weak inversion conduction, and so be used to implement networks which can be trained to perform practical tasks. A new four-quadrant analogue multiplier, one of the most important cells in the design of artificial neural networks, is developed. …
-
A Low-Power Analog-Signal-Processing-Unit For Wirelessly-Powered Implantable Recording System
… The technology, such as current bias and weak inversion CMOS, presented in the design significantly reduce the power consumption into the microwatt level. The new design method produces an analog continuous wavelet function filter with high performance, low circuit complexity and low-power …
Page 1 of 2