Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 33 for “"alite"”.
-
Corrosion and passivation of steel in concrete
… for various ionic species. Samples of pure alite and tricalcium aluminate have been prepared and characterised with respect to morphology, free lime content and fineness. Kinetics of diffusion of chloride ions in hardened pastes of alite and alite blended with tricalcium aluminate have been …
-
Development of High Performing, Commercially Relevant Concretes with High Levels of Clinker Replacement by Manipulating Microstructure and Controlling Crystal Growth
… shown to be due to a combination of increased alite hydration and increased slag dissolution. Increased alite hydration was due to neither reduced dissolved Al concentration nor increased alite under-saturation, but related to increased ionic strength due to the presence of Na2SO4. Increased …
-
The use of a UK Alum Water Treatment Sludge as a Supplementary Cementitious Material – Characteristics, Hydration and Performance
… to an undersulfated cement which inhibits alite hydration. The poorly crystalline η-alumina is metastable, transforming to highly crystalline -alumina (alpha) at 1100oC, whereupon alite hydration is enhanced because undersulfation is avoided and the alumina provides nucleation sites, …
-
The Influence of Amorphous, Sub-Micrometer Silica Particles in Cement Pastes and Mortars with Very Low Water-to-Cement Ratios (Ultra-High Performance Concrete)
… a heterogeneous nucleation of C–S–H phases from alite hydration on silica surfaces (seeding effect). Herein, the influence of the reactivity of silica has been rarely considered. Furthermore, the incorporation of discrete, not agglomerated particles becomes increasingly important with respect to …
-
Oil-Based Mud Cuttings as Additional Raw Material in Clinker and Cement Production
… belite and a very low free lime content and no alite. Clinker prepared using 12% and 55% OBM cuttings had very similar microstructures, chemical composition and properties to clinker prepared from the limestone normally used in cement production. However, the addition of OBM cutting to the raw …
-
Effect of Cooling Rates on Mineralization in Portland Cement Clinker
… analyzed with an emphasis on silicate minerals, alite and belite. The fastest cooled sample was determined to be the best quality sample in terms of hydraulic reactivity. Alites and belites in this sample exhibited good crystal form. The belite minerals from this sample had higher levels of …
-
Βελτίωση εψησιμότητας μίγματος πρώτων υλών παραγωγής κλίνκερ
… Zn, Ni, Ba, Li), with a shift on the reaction of alite formation (the action is related to the increased solubility of elements Cr, Sr, B in belite phase) and with the effect of added elements on the combination reactions of the four major components. In the last case the differentiations are …
-
Axant™ Flex Cotton Response and Residual Weed Management Using HPPD Inhibiting Herbicides
… to evaluate weed control following isoxaflutole (Alite 27™) + pendimethalin applied preplant incorporated (PPI) or pendimethalin PPI followed by (fb) isoxaflutole preemergence (PRE) alone or combined with seven other cotton residual herbicides, and to determine if using isoxaflutole PPI would be a …
-
Low-cost, ubiquitous biomolecule as next generation, sustainable admixture to enhance the performance of ordinary portland cement-based concretes
… can strongly retard the hydration of cement and alite due to its ability to bind to various particles and chelate with calcium ions, causing less calcium hydroxide produced by the hydration. The strong interaction between the TA and hydration products leads to morphology change of the hydration …
-
Investigation on Wellbore Cement Integrity During Carbon Capture and Storage (CCS) and Underground Hydrogen Storage (UHS)
… mineral composition, and a complete depletion of alite, signaling extensive carbonation. CT scans highlighted a substantial reduction in pore size and sealed fractures due to calcite precipitation, dramatically affecting porosity and permeability, which decreased by 98% and 87%, respectively. …
-
Επίδραση των ιχνοστοιχείων των εναλλακτικών καυσίμων και πρώτων υλών στη δομή και τις ιδιότητες του κλίνκερ τσιμέντου Πόρτλαντ
… crystalline phases of clinkers. In the case of alite, the combined substitution of Al3+, Mg+2 and Fe3+ in its crystal lattice, causes a reduction in the unit cell volume. The laboratory cements prepared with the use of alternative fuels, showed very good strength and setting time. According to …
-
Θειικομπελιτικά και αλιτικά τσιμέντα χαμηλού ενεργειακού αποτυπώματος: σχηματισμός της φάσης του yeelimite
… yeelimite phase and the reduced levels of the alite phase, as a result of the low firing temperature (1280-1350 ℃), but also of the high chemical affinity of sulfur with limestone that leads to the creation of the CaSO4 phase, a product detected in the present tests (up to 9.4% wt.). In …
-
Gaining higher salt scaling resistance with slag concretes
… and ettringite in the system. Unreacted alite and belite in the system remain the major crystalline phases in the system. Stratlingite also forms in the systems particularly at higher cement contents (≥50%) as well as with increasing alumina content of the slag. The extent of the …
-
Relationship between Microstructure, Durability and Performance of CEM X Composite Cements
… accelerates slag and clinker hydration. Alite hydration is accelerated by the supplementary cementitious materials including slag and quartz. However, while belite hydration is retarded in the binary slag mix, this is not the case in limestone ternary blends. Calcium carbonate also reacts …
-
Příprava a stanovení vlastností různých polymorfů C3S
Diplomová práca sa zaoberá metodikou prípravy hlavného slinkového minerálu Alitu. Obsahom tejto práce je návrh a optimalizovanie metodiky prípravy čistých polymorfov Alitu, analyzovanie ich vlastností dostupnými analytickými metódami a pomocou XRD-analýzy vyhodnotenie zmeny v kryštalinite v procese …
-
Cement Heat of Hydration and Thermal Control
… period while reduces the magnitude of the alite main hydration peak due to the filler effect. Furthermore, increasing the w/c ratio from 0.5 to 0.6 and graphene content from 1 % to 10% (as a partial replacement of cement) increases the 7 day HOH of Portland cement by 50 J/g. Isothermal …
-
Syntéza a stanovení vlastností čistých fází portlandského slínku a jejich polymorfů
V cementářském průmyslu je kvantitativní difrakční analýza v současné době uskutečňována prostřednictvím Rietveldovy analýzy, která je schopna dekódovat různé difrakční linie na difrakčním záznamu za předpokladu, že je dobře znám strukturální model pro každou fázi slínku. Předmětem zkoumání této …
-
Effect of Alkalis and Sulfate on Portland Cement Systems
The effect of the sulfates and alkalis on the durability of Portland cement systems was investigated through a series of cube and prism mixes. Durability was assessed using expansion of mortar prisms and the compressive strength of mortar cubes. The study covered a large range of both alkali and …
Page 1 of 2