Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 3938 for “"amplifier"”.
-
Class F Power Amplifier and Doherty Power Amplifier Design
… this thesis is to design and fabricate a power amplifier suitable for entry in IMS 2023 High Efficiency Power Amplifier Student Design Competition. Power amplifier design requires multiple design tradeoffs, for example, efficiency and linearity are the two main conflicting design parameters that …
-
Low Noise Pre-amplifier/Amplifier Chain for High Capacitance Sensors
… essential for detector systems. A low noise pre-amplifier/amplifier readout circuitry has been designed and fabricated in 0.13um IBM CMOS8RF process technology. The pre-amplifier/ amplifier chain employs correlated double sampling at the input to suppress the kTC noise without any additional …
-
IMPATT diode amplifier.
… a 10 GHz silicon diode has been tested as an amplifier with power gains in excess of 20 db.
-
Electromechanical pulse amplifier
Not available
-
Class G amplifier
Thesis (M.S.)--Michigan State University. Department of Electrical and Computer Engineering, 2002
-
A dielectric amplifier
Thesis (M.S.)--Michigan State College of Agriculture and Applied Science. Dept. of Electrical Engineering, 1954
-
Chirped pulse raman amplifier
… CPA system. In this chirped pulse Raman amplifier sub-system, a 30 mJ portion of a chirped 800 nm fundamental pulse within the CPA system was split into two unequal portions, each of which impinged on a Raman-active barium nitrate, or Ba(NO3)2, crystal of length 5 cm. The weaker portion …
-
Integrated lock-in amplifier
The sensitivity of a lock-in amplifier makes it an exceptionally useful instrument for extracting signals from noise, even when the noise and signal frequencies are close together. Lock-in amplifiers are widely used in situations involving low signal-to-noise ratios. These situations frequently …
-
All-Digital Audio Amplifier
The approach presented in these pages processes the audio information digitally and generates a two-level pulse-width modulation (PWM) signal that is amplified by a switching power stage and finally low-pass filtered before it is sent to a speaker. The purpose of the digital signal processing (DSP) …
-
Methodology of amplifier design
Submission published under a 24 month embargo labeled 'U of I Access', the embargo will last until 2027-05-01
-
Feedback amplifier network analysis
Thesis (M.S.)--Michigan State College of Agriculture and Applied Science. Dept. of Electrical Engineering, 1954
-
Gallium arsenide MESFET operational amplifier to be used in composite operational amplifier design
A gallium arsenide (GaAs) MESFET operational amplifier for use in composite operational amplifier (CNOA) configurations is described. This device is guaranteed to be suitable for construction in CNOA models. The GaAs op amp design is a general-purpose dev
-
Gain of the magnetic amplifier.
In this thesis, the gain of the magnetic amplifier is derived theoretically as a function of different parameters of the circuit. An experimental circuit of a series-connected magnetic amplifier with a resistive load is set up to verify the theoretical results. Starting from Kirchoff's Voltage Law …
-
Switching power amplifier for TAR3
… construction, and testing of a switching power amplifier. The major emphasis of the research and development effort reported herein is to design and construct an efficient power amplifier for varying load conditions which provides 40 Watts of power, at 85% efficiency, and with no more than 10% …
Page 1 of 197