Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 399 for “"anemometry"”.
-
Heated anemometry and thermometry in water
The characteristics of several types of heated sensors used for measuring oceanic turbulence have been examined. The author measured the steady heat flux from glass coated ellipsoidal microbead thermistors, computed numerically the unsteady heat flux from an ideal constant temperature flat plate, …
-
Flow field measurements using hotwire anemometry
… data acquisition system utilizing hotwire anemometry has been designed, built and installed in the Naval Postgraduate School Low Speed Wind Tunnel Facility. All relevant wind tunnel data is obtained by the use of a computer guided Hewlett Packard data acquisition system and a …
-
Spectral anemometry with an electrogasdynamic probe.
This study involves the measurement of RMS velocities covering the frequency spectrum 25 to 20,000 hertz using an electro gas dynamic (EGD) probe. Previous work proved the feasibility of this investigation. The flow of air behind a circular cylinder was measured. The freestream velocity was 185 …
-
Acoustic anemometry on the surface of Mars
… Two promising technologies, optical and acoustic anemometry, could permit precise and high-frequency measurement of three-dimensional wind speeds on the Martian surface. Ultrasonic acoustic anemometry, which relies on time-of-flight measurements, was ultimately chosen for its lower processing …
-
Anemometry tools and procedures for greenhouse experiments
Greenhouses provide a useful environment for conducting plant studies, facilitating manipulation and measurement of many variables in the plant microclimate. Photosynthesis, transpiration, thigmomorphogenic responses, and particle transport all depend on the level of air speed at the …
-
MEMS ultrasonic sensors for anemometry applications on MARS
… ultrasonic transducer (CMUT) suited for Martian anemometry is presented in this thesis. The CMUT is a clamped membrane structure that vibrates on the application of an electric field, generating ultrasound. The Martian environment is 95 % carbon dioxide (CO2) with atmospheric pressures around ~ …
-
Split-film anemometry in a drag-reducing solution
… 0.15 < y/R < 0.3.</p> <p>Accurate hot-film anemometry measurements in fresh polymer solutions were found to be unfeasible because of rapid changes in heat transfer rate caused by minute polymer degradation.</p> <p>Measurements in a degraded polymer solution gave both raised and lowered axial …
-
A Study of Constant Voltage Anemometry Frequency Response
The development of the constant voltage anemometer (CVA) for the boundary layer data system (BLDS) has been motivated by a need for the explicit autonomous measurement of velocity fluctuations in the boundary layer. The frequency response of a sensor operated by CVA has been studied analytically …
-
HOT WIRE ANEMOMETRY IN COLD MACH 4 FLOW
… estimating turbulence intensity using hot-wire anemometry in cold, constant-Mach supersonic wind tunnels.
-
Turbulence measurements in polymer solutions using hot-film anemometry
"Hot-film anemometry was used to study the detailed structure of turbulence (intensities, energy spectra, and auto-correlations) in Newtonian solvents, non-drag reducing polymer solutions, and drag reducing polymer solutions. This was done in two smooth wall tubes with diameters of 1.0 inch and 2.0 …
-
Turbulence measurements with a nano-scale thermal anemometry probe
A nanoscale thermal anemometry probe (NSTAP) has been developed for high Reynolds number turbulence measurements. NSTAP has working principles similar to conventional hot-wire anemometry, at the same time having greatly improved spatial and temporal resolution. Fabrication of NSTAP has been …
-
Effect of an oil fog upon hot-wire anemometry response
Thesis (M.S.)--Michigan State University. Department of Mechanical Engineering, 1982
-
Constant Voltage Hot-Wire Anemometry for the Boundary Layer Data System
To continue the development of the Boundary Layer Data System (BLDS), a constant voltage hot-wire anemometer (CVA) is implemented into the BLDS for flight-testing. The hot-wire anemometer was chosen as an alternative to the traditional pressure probe because of the ability to measure both average …
-
Measurement of Vehicle Cooling Fan Air Flow using Laser Doppler Anemometry
… cooling fan used in a Volvo V40. Laser Doppler Anemometry, LDA is a non-intrusive optical technique used for velocity measurements of turbulent and laminar ows. The measurements were performed in the model scale wind tunnel at Volvo Cars. From the cylinder measurements, the performance of the …
-
Measurement of properties of gas-solid suspensions using phase-Doppler anemometry
… and horizontal diameters using Phase Doppler Anemometry which was a nonintrusive technique that measured the size and velocity of particles within the suspension flow. Phase Doppler Anemometry was used to determine flow properties that depended on the density of the particle phase and to …
Page 1 of 20