Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 27 for “"bias point"”.
-
Nonlinearities and all-optical switching in semiconductor laser amplifiers
… investigated, particularly at the transparency bias point, in the InGaAsP/InP and GaAs/AlGaAs material systems. An all-solid-state F-centre laser system has been developed. It consisted of a diode-pumped Nd:YLF laser mode-locked at 77 MHz repetition rate, producing pulse durations of 6-20 ps …
-
Analysis and design of CMOS voltage-folding circuits and their use in high speed ADCS
… folding stages connected to an output stage. The bias point (reference voltage at which input signal is to be folded) and differential input responses are determined analytically. Current source requirements are also determined to ensure that the transistors remain in saturation. Using the …
-
Modeling and simulation of self-heating effects in p-type MOS transistors
… but very modest for bulk ones. At a fixed bias point of VD = VG = -1.5 V, for instance, bulk devices presented a current variation of as much as -0.75%, whereas for FD-SOI devices it reached up to -8.82% for Tgate = 400 K. Hot spot acoustic (lattice) and optical phonon temperatures were …
-
Numerical Simulations of Device Scaling of a Pseudomorphic InP HEMT
… requirements in terms of the optimal low-noise bias point and the suppression of leakage currents.
-
GaN-based Tri-gate high electron mobility transistors
… the intrinsic device parameters on the applied bias point, highly-scaled GaN HEMTs are prone to experiencing deteriorated high frequency characteristics which severely limit the high power performance as well. Here, the relatively poor control of the gate electrode is known to be the underlying …
-
Noisy transistor models for microwave circuit CAD
… sets of S-parameter measurements at different bias conditions. The technique consists of two major steps; in the first step, part of the bias-independent extrinsic parameters is evaluated in preparation to the second step. In the second step, all other parameters should be extracted at the bias …
-
Gauge Factor of Graphene Piezoresistor for Surface Acoustic Wave Gyroscope Instrumentation
… to maximize the sensitivity obtained by a biasing technique. By applying an external bias, current induced by SAW in graphene resistors can be canceled and large sensitivity at this bias point can be obtained. To characterize the sensitivity of graphene electrodes, we vary the widths, …
-
Nanoscale RF CMOS transceiver design
… over the channel inversion level. The optimum bias point for noise matching is obtained close to moderate inversion (M.I.) and is shown to be shifted to inversion levels within the M.I. region, as channel length decreases.Small signal characterization and modeling of active devices is performed …
-
Meminductor- Physical Realization and Edge of Chaos Operation
… flux”. Memelements are capable of being biased at “locally active” steady states and may therefore generate persistent dynamical response to a constant excitation when passively coupled to an appropriate passive network. Reports on mathematical proof of the existence of such locally …
-
Multi-Port Receivers System Analysis and Modeling
… we not only provide a controlled continuous bias to the diodes, we also propose a novel algorithm that reduces the Error Vector Magnitude (EVM) by adaptively controlling the diode bias point. Another key feature of optimum diode bias control is the Local Oscillator (LO) power requirements …
-
Systematic Optimization Technique for MESFET Modeling
… sets of S-parameter measurements at different bias conditions. The technique consists of two major steps; in the first step, some of the bias-independent extrinsic parameters are estimated in preparation for the second step. In the second step, all other parameters should be extracted at the …
-
Avalanche ISFET Sensing Chip for DNA Sequencing
… The model identifies that there is an optimum bias point of A-ISFET to have maximum SNR sensitivity from the sensor. Every electronic device generates its own intrinsic noise, in addition to other induced noise from associated nearby components. We have identified different noise components of …
-
Modelamento e análise do efeito de coeficiente nulo de temperatura (ZTC) do Mosfet para aplicações análogicas de baixa sensibilidade têrmica
… Zero Temperature Coefficient (GZTC) bias points are modeled to support it. These are used as reference to deliver a set of equations that explains to analog designers how temperature will change transistor operation and hence the analog circuit behavior. The special bias conditions …
-
Circuit Quantum Electrodynamics with Flux Qubits
… of which is controlled via on-chip fast flux bias lines. Readout of the qubit’s quantum state is performed by homodyne detection of the resonator field at large driving power. We observe long coherence times at the optimal bias point of the flux qubits and present decoherence measurements …
-
Digitally Assisted Radio-Frequency Integrated Circuits
… method used a lookup table (LUT) of optimal bias points measured through extensive sweeps and linear interpolation to determine the optimal bias point of the chip between measured points. A Gilbert Cell was fabricated in 0.13 μm CMOS. Transistor gate bias voltages were swept with input power …
-
Improved Techniques for Nonlinear Electrothermal FET Modeling and Measurement Validation
… effects. Demonstration of a customized pulsed-bias, pulsed-RF S-parameter system constructed by the author using a traditional vector network analyzer is presented, along with the design of special bias tees to allow pulsing of the bias voltages. Pulsed IV and pulsed-bias S-parameter …
-
Enabling high baud rate terabit superchannels
… and phase modulation. However, MZMs are prone to bias drifts, requiring an effective DC bias control for stable operation. This work addresses the challenge of MZM bias drift by first characterizing the behavior of single and nested MZMs to understand their transfer functions. Based on the …
-
Modelling and Measurement of Reciprocal Quantum Logic Circuits
… for different test vectors. A methodology, bias point delta (BPD), for improving signal integrity of RQL circuits is also introduced. This methodology was applied to a 3,274 JJ design and the amount of coupled flux before and after routing improvements are compared. The work in this …
-
Performance Comparison of Harmonically Tuned Power Amplifiers at 28 GHz in SiGe BiCMOS
… the highest efficiency possible. The chosen bias point is VCE=2.3V and ICE~12mA. As the results, class-AB PA achieves the peak PAE of 44%, 15 dBm OP-1dB, >19 dBm Psat , and 10 dB Gp. Class-F PA achieves the peak PAE of 46%, 14.5 dBm OP-1dB, ~18 dBm Psat , and 10 dB Gp. Class-F-1 PA achieves …
-
Low Frequency Noise in CMOS transistors
… noise. This is done by increasing the bias current. For fixed defect density, increased bias current will ``saturate" the 1/f-noise fluctuation at some level resulting in an increase in SNR. Large current leads to large power dissipation, an undesirable side-effect of saturating the …
Page 1 of 2