Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 36 for “"compressor cascade"”.
-
Off-design loss measurements in a compressor cascade
… facility currently containing a modeled subsonic cascade of controlled diffusion (CD) stator blades. Acquisition, reduction and ancillary programs were written for a Hewlett-Packard 9000 Series 300 computer/HP3052 Data Acquisition System in HP BASIC 5.0/ The new software was demonstrated and …
-
Effects of Free Stream Turbulence on Compressor Cascade Performance
… of grid generated free-stream turbulence on compressor cascade performance was measured experimentally in the Virginia Tech blow-down wind tunnel. The parameter of key interest was the behavior of the measured total pressure loss coefficient with and without generated free-stream turbulence. …
-
Flowfield Downstream of a Compressor Cascade with Tip Leakage
An 8 blade, 7 passage linear compressor cascade with tip leakage was built. The flowfield downstream of the cascade was measured using four sensor hot-wire anemometers, from which the mean velocity field , the turbulence stress field and velocity spectra were obtained. Oil flow visualizations were …
-
Experimental investigation of reversed flow in a compressor cascade
… reversed flow performance characteristics in a compressor cascade was conducted. The purpose was to gain a fundamental understanding of reversed flow in a compressor blade cascade, and to determine the effects of stagger angle and angle of attack on the reversed flow behavior in the cascade. …
-
Experimental Investigation into the Effects of Riblets on Compressor Cascade Performance.
… riblets to the blades of a subsonic, linear compressor cascade were investigated at the Air Force Institute of Technology. Three blade configurations were tested, including a set of unmodified NACA 64- A905 series blades, a set with riblets applied to the suction surface, and a set with …
-
Tip Leakage Flow Downstream a Compressor Cascade with Moving End Wall
… This system forms part of a low-speed linear compressor cascade wind tunnel, where it is used to simulate the effects of the relative motion between the blade tips and casing upon the flow. Detailed 4-sensor hot wire measurements were made at various locations downstream the cascade. The …
-
Some Features of Tip Gap Flow Fields of a Linear Compressor Cascade
… turbulent tip gap flows in the linear cascade wind tunnel, for two different tip gap clearances (t/c=1.65% and 3.3%). The experiments focus on near-wall flow field measurements for the stationary wall and moving wall, and static pressure measurement on the low end-wall for the …
-
Investigation of a mach 1.4 compressor cascade with variable back pressure using flow visualization.
Flow through a transonic compressor cascade model was investigated at M = 1.4 using flow visualization and pressure measurements. Shock patterns for two different blade incidences were documented at increasing back pressures. Data were taken up to a maximum pressure ratio of 1.53 at estimated …
-
Investigation and Simulation of Ion Flow Control over a Flat Plate and Compressor Cascade
… ability to prevent separated flow in a low-speed compressor cascade. Flat plate tests were performed for two electrode configurations at free-stream velocity magnitudes of 2.5, 5, 7.5, and 10 m/s. Boundary layer velocity profile data was taken to measure the performance of the electrode pairs. Ion …
-
Measurements of the Tip-gap Turbulent Flow Structure in a Low-speed Compressor Cascade
… turbulent flow structure in a low-speed linear compressor cascade wind tunnel at Virginia Tech that includes a moving belt system to simulate the relative motion between the tip and the casing. The endwall pressure measurements and the surface oil flow visualizations were made on a stationary …
-
The Effects of Free Stream Turbulence on the Flow Field through a Compressor Cascade
The flow through a compressor cascade with tip leakage has been studied experimentally. The cascade of GE rotor B section blades had an inlet angle of 65.1º, a stagger angle of 56.9º, and a solidity of 1.08. The final turning angle of the cascade was 11.8º. This compressor configuration was …
-
Laser-Doppler velocimetry and viscous computation of the flow through a compressor cascade near stall
… were made in the flow field of a stalled cascade of controlled-diffusion stator blades. Tests were conducted at 10 degrees of incidence above the design inlet-flow angle in order to verify previous measurements. A unique method of data presentation was offered to characterize the unsteady …
-
Near-Stall Loss Measurements in a CD Compressor Cascade with Exploratory Leading Edge Flow Control
… in a subsonic wind tunnel containing a modeled cascade of controlled diffusion (CD) stator blades. Following reference measurements at high incidence one blade was modified (slotted at the leading edge) in an attempt to (passively) reduce the size of the leading edge separation bubble and …
-
Determining the effect of endwall boundary layer suction in a large scale subsonic compressor cascade
… in the Naval Postgraduate School's subsonic cascade wind tunnel. The aim was to improve flow two-dimensionality to enable flow separation of the installed controlled- diffusion blades at high incidence. The slots were located 17.25 inches upstream of the test section. Pressure and laser …
-
The Effect of Freestream Turbulence on Separation at Low Reynolds Numbers in a Compressor Cascade
… intensities on separation and performance in a compressor cascade at low Reynolds numbers. Tests were performed at 25° and 37.5° stagger angle, negative and positive angles of incidence up until the point of full stall, Reynolds numbers from 6 x 104 to 12.5 x 104, and turbulence intensities from …
-
The effect of solidity on the pre- and post-stall flow in a linear compressor cascade
… characteristics of a solid wall linear compressor cascade was conducted. The purpose of the experiments was to determine the effects of the blade row configuration parameters stagger and solidity on the pre-and post-stall behavior of the flow in the cascade. Tests were conducted at a …
-
The effect of boundary layer blowing in the corner region of a linear compressor cascade wind tunnel
… flow in the endwall corner region of a linear compressor cascade wind tunnel and the effect of boundary layer blowing in this region was conducted using blade surface pressure tap measurements and five - hole prism probe measurements taken downstream of the cascade. The results are presented as …
-
Reynolds-Averaged Navier-Stokes Computation of Tip Clearance Flow in a Compressor Cascade Using an Unstructured Grid
… to the tip clearance flow in a highly staggered cascade. Surface grids are first generated in the flow passage and blade tip by using several triangulation methods including Delaunay triangulation, advancing front method and advancing layer method. Then the whole computational domain including …
-
A surface flow visualization study of boundary layer behavior on the blades of a solid-wall compressor cascade at high angles of attack
… technique was applied to circular arc compressor blades in a solid wall, high aspect ratio cascade for the purpose of describing the transition from corner stall to full blade stall, and the blade surface flow under fully stalled conditions. Photos of the visualizations for three …
Page 1 of 2